<< Prev Question Next Question >>

Question 23/91

Refer to the exhibit.

Routers R1 and R2 reside in AS 65530, which is multihomed to the Internet. A network engineer expects devices in the AS to use R2 to access the Internet, but they are using R1 as the exit point from the AS. Which action corrects the problem?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (91q)
Question 1: Which two differences should be considered when deciding whe...
Question 2: While configuring Cisco NSF awareness, a network engineer en...
Question 3: Refer to the exhibit. (Exhibit) An administrator is troubles...
Question 4: An engineer is working to implement segment routing protocol...
Question 5: What is the difference between basic IS-IS and OSPF packet t...
Question 6: Refer to the exhibit. (Exhibit) Refer to the exhibit. Mid-si...
Question 7: Refer to the exhibit. (Exhibit) Router 1 is a core ABR in a ...
Question 8: Which feature provides service independence in service provi...
Question 9: Refer to the exhibit. (Exhibit)...
Question 10: Drag and drop the route-manipulation methods from the left o...
Question 11: Refer to the exhibit (Exhibit) Which router does R1 install ...
Question 12: Refer to the exhibit. (Exhibit) A network engineer configure...
Question 13: Which two BGP route reflector attributes should be implement...
Question 14: Refer to the exhibit. (Exhibit) Refer to the exhibit. An eng...
Question 15: Which two statements about route reflectors are true? (Choos...
Question 16: Which two statements about mapping multicast IP addresses to...
Question 17: Drag and drop the features about multicast from the left ont...
Question 18: After changing the IP address on an IOS XR router, an engine...
Question 19: Refer to the exhibit. (Exhibit) Routers R1, R2. R3, and R4 h...
Question 20: Refer to the exhibit. (Exhibit) Why is neighbor 10.1.5.5 stu...
Question 21: Refer to the exhibit. (Exhibit) Refer to the exhibit. A netw...
Question 22: Refer to the exhibit. (Exhibit) Which tree does multicast tr...
Question 23: Refer to the exhibit. (Exhibit) Routers R1 and R2 reside in ...
Question 24: Refer to the exhibit. (Exhibit) The green policy is designed...
Question 25: Refer to the exhibit. (Exhibit) Refer to the exhibit. R21 is...
Question 26: Level 3 switch SW1 is part of an EIGRP enabled network locat...
Question 27: Refer to the exhibit. (Exhibit) XR1 and XR2 are sending the ...
Question 28: Refer to the exhibit. (Exhibit) Refer to the exhibit. The in...
Question 29: Refer to the exhibit. (Exhibit) An administrator is troubles...
Question 30: After you change the IP address on an IOS XR router, you can...
Question 31: Refer to the exhibit. (Exhibit) Refer to the exhibit Reuters...
Question 32: What is the difference between a source tree and a shared tr...
Question 33: Refer to the exhibit. (Exhibit) R3 is: failing to accept mul...
Question 34: How does SRv6 function on the control plane?...
Question 35: Refer to the exhibit. (Exhibit) Refer to the exhibit. The Ci...
Question 36: Refer to me exhibit. (Exhibit) A network engineer sets up a ...
Question 37: Which IPv6 prefix format defines the destination of a dynami...
Question 38: A network engineer is troubleshooting OSPF multiare a. Which...
Question 39: Refer to the exhibit. (Exhibit) While configuring router 2 w...
Question 40: Drag and drop the attributes for the BGP route selection on ...
Question 41: Refer to the exhibit. (Exhibit) A network operator must inje...
Question 42: Refer to the exhibit. (Exhibit) An engineer applied the summ...
Question 43: Refer to the exhibit. (Exhibit) An MPLS core network has con...
Question 44: Refer to the exhibit. (Exhibit) A network engineer applied c...
Question 45: Refer to the exhibit. (Exhibit) Refer to the exhibit Network...
Question 46: Refer to the exhibit. (Exhibit) Refer to the exhibit. Multic...
Question 47: Drag and drop the features from the left into the order of o...
Question 48: The operator must leverage automated steering and coloring w...
Question 49: Refer to the exhibit. (Exhibit) Refer to the exhibit. Excess...
Question 50: Refer to the exhibit. (Exhibit) Refer to the exhibit Router ...
Question 51: Refer to the exhibit. (Exhibit) Refer to the exhibit. Which ...
Question 52: Refer to the exhibit. (Exhibit) Refer to the exhibit. Router...
Question 53: Refer to the exhibit. (Exhibit) An engineer has configured a...
Question 54: Refer to the exhibit. (Exhibit) Refer to the exhibit. A serv...
Question 55: Which technique should be permitted on ASA Firewall to allow...
Question 56: For which reason can two devices fail to establish an OSPF n...
Question 57: What is a requirement of PIM-SM?...
Question 58: Refer to the exhibit. (Exhibit) Refer to the exhibit. A netw...
Question 59: Which two conditions must be met before separate ISPs can pr...
Question 60: Refer to the exhibit. (Exhibit) Refer to the exhibit. This n...
Question 61: Refer to the exhibit. (Exhibit) Refer to the exhibit. Compan...
Question 62: Refer to the exhibit. (Exhibit) A network operator is gettin...
Question 63: Refer to the exhibit. (Exhibit) A network operators configur...
Question 64: Refer to the exhibit. (Exhibit) Refer to the exhibit. The se...
Question 65: Which lag command is used within route-map to redistribute r...
Question 66: Refer to the exhibit. (Exhibit) Refer to the exhibit. Router...
Question 67: Refer to the exhibit. (Exhibit) Refer to the exhibit. Custom...
Question 68: What is the role of segment routing mapping server?...
Question 69: Refer to the exhibit. (Exhibit) Refer to the exhibit. Users ...
Question 70: Which statement about enabling segment routing for IGPs is t...
Question 71: What Is a characteristic of a segment routing mapping server...
Question 72: Which keyword is used with the match route-type command to r...
Question 73: Which difference must an engineer consider when Implementing...
Question 74: After an engineer configures BGP in R1, it starts receiving ...
Question 75: Refer to the exhibit. (Exhibit) Traffic flow from router R1 ...
Question 76: What is the purpose of ACL type prefix set entries in RPL pr...
Question 77: Refer to the exhibit. (Exhibit) After troubleshooting BGP tr...
Question 78: Refer to the exhibit. (Exhibit) Refer to the exhibit. HostB ...
Question 79: Which cost is the default when redistributing routes from BG...
Question 80: A network operator working for a telecommunication company w...
Question 81: Refer to the exhibit. (Exhibit) How are packets directed thr...
Question 82: Refer to the exhibit. (Exhibit) Which statement about this c...
Question 83: Refer to the exhibit. (Exhibit) A network engineer has divid...
Question 84: Refer to the exhibit. (Exhibit) Routers within the cluster a...
Question 85: Refer to the exhibit. (Exhibit) Refer to the exhibit The bra...
Question 86: Refer to the exhibit. (Exhibit) An engineer has successfully...
Question 87: Refer to the exhibit. (Exhibit) Refer to the exhibit A netwo...
Question 88: Refer to the exhibit. (Exhibit) A network operator must stop...
Question 89: Refer to the exhibit. (Exhibit) P1 and PE3 Cisco IOS XR rout...
Question 90: Refer to the exhibit. (Exhibit) Refer to the exhibit. Users ...
Question 91: Compare different features between OSPFv2 and OSPFv3. Drag a...