<< Prev Question Next Question >>

Question 12/24

An engineer configured a Cisco AireOS controller with two TACACS+ servers. The engineer notices that when the primary TACACS+ server fails, the WLC starts using the secondary server as expected, but the WLC does not use the primary server again until the secondary server fails or the controller is rebooted. Which cause of this issue is true?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (24q)
Question 1: An engineer is implementing Cisco Identity-Based Networking ...
Question 2: Which QoS level is recommended for guest services?...
Question 3: Which feature on the Cisco Wireless LAN Controller must be p...
Question 4: What is the difference between PIM sparse mode and PIM dense...
Question 5: An engineer is following the proper upgrade path to upgrade ...
Question 6: Which devices can be tracked with the Cisco Context Aware Se...
Question 7: An engineer must track guest traffic flow using the WLAN inf...
Question 8: All APs are receiving multicast traffic, instead of only the...
Question 9: An engineer must implement rogue containment for an SSID. Wh...
Question 10: Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Serie...
Question 11: An engineer configures a Cisco Aironet 600 Series OfficeExte...
Question 12: An engineer configured a Cisco AireOS controller with two TA...
Question 13: What is an important consideration when implementing a dual ...
Question 14: An engineer must implement intrusion protection the WLAN. Th...
Question 15: Which three characteristics of a rogue AP pose a high securi...
Question 16: Refer to the exhibit. (Exhibit) A network administrator depl...
Question 17: An engineer is performing a Cisco Hyperlocation accuracy tes...
Question 18: Which three properties are used for client profiling of wire...
Question 19: When using a Cisco Catalyst 9800 Series Wireless Controller,...
Question 20: A new MSE with wIPS service has been installed and no alarm ...
Question 21: Which two statements about the requirements for a Cisco Hype...
Question 22: A Cisco WLC has been added to the network and Cisco ISE as a...
Question 23: Which two restrictions are in place with regards to configur...
Question 24: Which two protocols are used to communicate between the Cisc...