300-420 Exam Dumps | A customer's current Layer 2 infrastructure is running Spanning Tree 802.1d, and all configuration changes

Home
Cisco
Designing Cisco Enterprise Networks
Cisco.300-420.v2022-06-20.q115
Question 43

Valid 300-420 Dumps shared by EduDump.com for Helping Passing 300-420 Exam! EduDump.com now offer the newest 300-420 exam dumps, the EduDump.com 300-420 exam questions have been updated and answers have been corrected get the newest EduDump.com 300-420 dumps with Test Engine here:

Access 300-420 Dumps Premium Version
(457 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 43/115

A customer's current Layer 2 infrastructure is running Spanning Tree 802.1d, and all configuration changes are manually implemented on each switch. An architect must redesign the Layer 2 domain to achieve these goals:
* reduce the impact of topology changes
* reduce the time spent on network administration
* reduce manual configuration errors
Which two solutions should the architect include in the new design? (Choose two.)

A. Implement Rapid PVST+ instead of STP.

B. Implement MST instead of STP.

C. Use VTP to propagate VLAN information and to prune unused VLANs.

D. Configure broadcast and multicast storm control on all switches.

E. Configure dynamic trunking protocol to propagate VLAN information.

Correct Answer: C,D

Section: Advanced Enterprise Campus Networks

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (115q): Question 1: Which design consideration must be made when using IPv6 over...; Question 2: Which design consideration must be made when using IPv6 over...; Question 3: Which feature is required for graceful restart to recover fr...; Question 4: Which three feature sets are used in Stackwise technology? (...; Question 5: Instructions The main screen consists of two parts; the Main...; Question 6: Refer to the exhibit. The full EIGRP routing table is advert...; Question 7: Which two steps can be taken to improve convergence in an OS...; Question 8: Refer to the exhibit. An architect must design a solution to...; Question 9: Which method will filter routes between EIGRP neighbors with...; Question 10: (Exhibit) Refer to the exhibit. An architect reviews the low...; Question 11: A customer has several remote sites connected with their hea...; Question 12: A network administrator is troubleshooting a DMVPN setup bet...; Question 13: The customer solution requires QoS to support streaming mult...; Question 14: An architect is designing a multicast solution for a network...; Question 15: How is end-to-end microsegmentation enforced in a Cisco SD-A...; Question 16: A company with multiple service providers wants to speed up ...; Question 17: Which type of rendezvous point deployment is standards-based...; Question 18: An infrastructure team is concerned about the shared memory ...; Question 19: An engineer is designing an EIGRP network for a small branch...; Question 20: Refer to the exhibit. C0FD9 F48C9ACDC725EA850EC2476EE1E (Exh...; Question 21: A network solution is being designed for a company that conn...; Question 22: Refer to the exhibit. Customers report low video quality and...; Question 23: Which OSPF area blocks LSA Type 3, 4 and 5, but allows a def...; Question 24: Which design consideration should be observed when EIGRP is ...; Question 25: DRAG DROP Drag and drop the characteristics from the left on...; Question 26: (Exhibit) Refer to the exhibit. Customers report low video q...; Question 27: Drag and drop the elements from the left onto the functions ...; Question 28: Refer to the exhibit. An architect must design a solution to...; Question 29: Drag and drop the characteristics from the left onto the YAN...; Question 30: Which control-plane technology allows the same subnet to exi...; Question 31: Which two BGP features will result in successful route excha...; Question 32: Refer to the exhibit. (Exhibit) An engineer is designing a B...; Question 33: An engineer must design an addressing plan for a small busin...; Question 34: Refer to the exhibit. C0FD9F48 C9ACDC725EA850EC2476EE1E (Exh...; Question 35: (Exhibit) Refer to the exhibit. An architect is designing a ...; Question 36: Refer to the exhibit. (Exhibit) EIGRP has been configured on...; Question 37: An engineer must design a QoS solution for a customer that i...; Question 38: What is the function of the multicast Reverse Path Forwardin...; Question 39: (Exhibit) Refer to the exhibit. An engineer is designing a B...; Question 40: An engineer is working for a large cable TV provider that re...; Question 41: A company has the following network infrastructure. (Refer t...; Question 42: A company must automate a set of complex changes aligned wit...; Question 43: A customer's current Layer 2 infrastructure is running Spann...; Question 44: Drag and drop the descriptions from the left onto the Cisco ...; Question 45: (Exhibit) Refer to the exhibit. Area 10 is a regular OSPF ar...; Question 46: A company's security policy requires that all connections be...; Question 47: A network engineer is redesigning a company's QoS solution. ...; Question 48: Drag and drop the properties from the left onto the Cisco SD...; Question 49: When vEdge router redundancy is designed, which FHRP is supp...; Question 50: Instructions The main screen consists of two parts; the Main...; Question 51: Refer to the exhibit. The distribution switches serve as the...; Question 52: How are wireless endpoints registered in the HTDB in a Cisco...; Question 53: Which PIM mode uses a shared tree only?...; Question 54: Refer to the exhibit. An engineer must design an automatic f...; Question 55: A client is moving to Model-Driven Telemetry and requires pe...; Question 56: Drag and drop the descriptions from the left onto the corres...; Question 57: An engineer must design a VPN solution for a company that ha...; Question 58: Which authentication service is needed to configure 802.1x?...; Question 59: What are two valid scaling techniques when an EIGRP network ...; Question 60: Which two routing protocols allow for unequal cost load bala...; Question 61: Company A recently acquired another company. Users of the ne...; Question 62: Which two statements about VRRP object tracking are true? (C...; Question 63: Drag and drop the properties from the left onto the protocol...; Question 64: Refer to the exhibit. An engineer is designing an OSPF netwo...; Question 65: Which consideration must be taken into account when using th...; Question 66: How is internet access provided to a WAN edge router that is...; Question 67: What is the role of a control-plane node in a Cisco SD-Acces...; Question 68: An engineer is creating a design to enable IPv6 to run on an...; Question 69: Refer to the exhibit. Where must an architect plan for route...; Question 70: Which method does Cisco SD-WAN use to avoid fragmentation is...; Question 71: Drag and drop the descriptions from the left onto the Cisco ...; Question 72: Drag and drop the properties from the left onto the protocol...; Question 73: An engineer is designing a QoS policy that queues excess pac...; Question 74: An engineer is designing an enterprise campus network. The L...; Question 75: Drag and drop the properties from the left onto the protocol...; Question 76: Which design element should an engineer consider when multic...; Question 77: Which two BGP features will result in successful route excha...; Question 78: Refer to the exhibit. The full EIGRP routing table is advert...; Question 79: An architect must address sustained congestion on the access...; Question 80: Which design consideration must be made when using IPv6 over...; Question 81: Refer to the exhibit. (Exhibit) EIGRP has been configured on...; Question 82: An engineer must propose a QoS architecture model that allow...; Question 83: Refer to the exhibit. (Exhibit) Which solution decreases the...; Question 84: (Exhibit) Refer to the exhibit. Area 10 is a regular OSPF ar...; Question 85: Which two techniques improve the application experience in a...; Question 86: (Exhibit) Refer to the exhibit. An architect must design a s...; Question 87: When provisioning bandwidth for an IP telephony network, whi...; Question 88: Refer to the exhibit. (Exhibit) An architect must design an ...; Question 89: A customer's current Layer 2 infrastructure is running Spann...; Question 90: Drag and drop the characteristics from the left onto the con...; Question 91: (Exhibit) Refer to the exhibit. An architect must create a s...; Question 92: Which two BGP features will result in successful route excha...; Question 93: Which design consideration should be observed when EIGRP is ...; Question 94: Refer to the exhibit. (Exhibit) EIGRP has been configured on...; Question 95: Which design consideration must be made when dual WAN Edge r...; Question 96: An infrastructure team is concerned about the shared memory ...; Question 97: Which feature is required for graceful restart to recover fr...; Question 98: A network engineer must connect two sites across a public ne...; Question 99: An architect must develop a campus network solution that inc...; Question 100: Which design consideration must be made when dual WAN Edge r...; Question 101: An engineer is looking for a standards-driven YANG model to ...; Question 102: How do endpoints inside an SD-Access network reach resources...; Question 103: Drag and drop the characteristics from the left onto the YAN...; Question 104: A router running ISIS is showing high CPU and bandwidth util...; Question 105: Drag and drop the model driven telemetry characteristics fro...; Question 106: Refer to the exhibit. Area 10 is a regular OSPF area and net...; Question 107: (Exhibit) Refer to the exhibit. Customers report low video q...; Question 108: Which consideration must be made when designing a Cisco SD-A...; Question 109: Which two border nodes are available in the Cisco SD-Access ...; Question 110: An engineer must use YANG with an XML representation to conf...; Question 111: What is an advantage of designing an out-of-band network man...; Question 112: Which topology within a network underlay eliminates the need...; Question 113: An organization is designing a detailed QoS plan that limits...; Question 114: Which of the following features does GLBP provide, but not H...; Question 115: Drag and drop the components in a Cisco SD-Access architectu...

[×]

Download PDF File

Enter your email address to download Cisco.300-420.v2022-06-20.q115.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 43/115

LEAVE A REPLY

Download PDF File