<< Prev Question Next Question >>

Question 38/49

What is an advantage of using auto mode versus static mode of power allocation when an access point is connected o a PoE switch port?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (49q)
Question 1: An administrator must configure an ACL for traffic coming in...
Question 2: On which device Is a service FW address configured to Insert...
Question 3: Which component of the Cisco SD-WAN architecture oversees th...
Question 4: Which configuration step is taken on vManage after WAN Edge ...
Question 5: Drag and drop the route verification output from show omp tl...
Question 6: Which combination of platforms are managed by vManage?...
Question 7: Drag and drop the definitions from the left to the configura...
Question 8: An engineer wants to track tunnel characteristics within a S...
Question 9: Which plane assists in the automatic onboarding of the SD-WA...
Question 10: Drag and drop the functions from the left onto the correct t...
Question 11: Which two mechanisms are used to guarantee the integrity of ...
Question 12: Which two products are used to deploy Cisco WAN Edge Router ...
Question 13: Which policy configures an application-aware routing policy ...
Question 14: When a WAN Edge device joins the SD-WAN overlay, which Cisco...
Question 15: An administrator needs to configure SD-WAN to divert traffic...
Question 16: What is a benefit of the application aware firewall feature ...
Question 17: In the Cisco SD_WAN solution, vSmart controller is responsib...
Question 18: An engineer is configuring a WAN Edge router for DIA based o...
Question 19: When the VPN membership policy is being controlled at the vS...
Question 20: Which two algorithms authenticate a user when configuring SN...
Question 21: (Exhibit) Refer to the exhibit. The network administrator ha...
Question 22: A network administrator is configuring a centralized control...
Question 23: Company ABC has decided to deploy the controllers using the ...
Question 24: Drag and drop the vManage policy configuration procedures fr...
Question 25: Which device information is requited on PNP/ZTP to support t...
Question 26: An engineer is troubleshooting a vEdge router and identifies...
Question 27: When software is upgraded on a vManage NMS, which two image-...
Question 28: Refer to the exhibit. (Exhibit) An engineer is troubleshooti...
Question 29: Drag and drop the policies from the left onto the correct po...
Question 30: What is a description of vManage NMS?...
Question 31: At which layer does the application-aware firewall block app...
Question 32: An engineer wants to change the configuration of the certifi...
Question 33: Refer to the exhibit. (Exhibit) The control connection is fa...
Question 34: (Exhibit) Refer to the exhibit. An administrator is configur...
Question 35: A large retail organization decided to move some of the bran...
Question 36: An engineer is configuring a centralized policy to influence...
Question 37: For data plane resiliency, what does the Cisco SD-WAN softwa...
Question 38: What is an advantage of using auto mode versus static mode o...
Question 39: Where on vManage does an engineer find the details of contro...
Question 40: Which secure connection should be used to access the REST AP...
Question 41: Which value is verified in the certificates to confirm the i...
Question 42: A network administrator is creating an OMP feature template ...
Question 43: Which command verifies a policy that has been pushed to the ...
Question 44: Which configuration changes the packet loss priority from lo...
Question 45: Refer to the exhibit. (Exhibit) The tunnel interface configu...
Question 46: Refer to the exhibit. (Exhibit) Which QoS treatment results ...
Question 47: A network administrator is configuring an application-aware ...
Question 48: A bank is looking for improved customer experience for appli...
Question 49: (Exhibit) Refer to the exhibit, Which configuration routes S...