<< Prev Question Next Question >>

Question 38/107

A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping. How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (107q)
Question 1: Which description of Cisco Centralized Key Management is tru...
Question 2: A company has deployed a centralized wireless architecture i...
Question 3: You must upgrade a data- based wireless network to support V...
Question 4: Which option is the minimum RSSI signal for a data WLAN?...
Question 5: An engineer plugs in a Cisco Aironet 2700 Series Access Poin...
Question 6: Refer to the exhibit. Which type of cable connector is displ...
Question 7: What is the recommended minimum speed at the edge of the cel...
Question 8: You are designing a network deployment for a state college. ...
Question 9: A network engineer is retrofitting an existing building wire...
Question 10: You are designing a wireless network to support high user de...
Question 11: Which purpose of using Metageek Chanalyzer during site surve...
Question 12: A customer has deployed an N+N redundant wireless infrastruc...
Question 13: What is a common cause for signal attenuation?...
Question 14: An initial meeting has been scheduled for a proposed site su...
Question 15: When should a Layer I site survey be performed?...
Question 16: Which description of the ideal VoWLAN design is true?...
Question 17: The ClO of a company wants to start tracking inventory in th...
1 commentQuestion 18: A customer has determined that aesthetics is a primary conce...
Question 19: When implementing video teleconferencing over a wireless net...
Question 20: The wireless team must configure a new voice SSID for optimi...
Question 21: You are designing a wireless mesh network for an oil refiner...
Question 22: When planning to perform a customer WLAN site survey, which ...
Question 23: A wireless engineer is doing a pre-site survey. Which two at...
Question 24: An engineer is planning for a 24 Mbps data rate on the 5Ghz ...
Question 25: Which option will allow the maximum 2.4 GHz channel usage fo...
Question 26: What is the Cisco-recommended cell overlap percentage for a ...
Question 27: Cisco 7925G phones are experiencing intermittent connectivit...
Question 28: An engineer is deploying an outdoor Mesh network. Which four...
Question 29: You have a multinational customer that would like you to per...
Question 30: A customer has a business-critical voice network and wants t...
Question 31: After implementing mesh with an IP surveillance camera conne...
Question 32: While performing a Layer 1 passive wireless site survey of a...
Question 33: Which option is an enhancement of enabling WMM on an AP?...
Question 34: An engineer is conducting a location readiness test and want...
Question 35: While preparing to perform a wireless site survey on a site ...
Question 36: A customer requesting a site survey requires hidden APs, bas...
Question 37: IEEE 802.llk-2008 is an amendment to IEEE 80211- 2007 standa...
Question 38: A downstream packet that contains a DSCP value arrives at th...
Question 39: IEEE 802.11r-2008 or fast BSS transition (FT), also called "...
Question 40: An engineer is surveying a customer site for additional wire...
Question 41: An engineer is designing the physical infrastructure for an ...
Question 42: An engineer is determining powering requirements for a P2P w...
Question 43: During a post-deployment survey, the wireless engineer notic...
Question 44: Which three parameters are used by Cisco Prime Infrastructur...
Question 45: An engineer is performing a predictive wireless design for a...
Question 46: Clients are experiencing artifacts in multicast video even t...
Question 47: Which infrastructure issue needs to be verified and potentia...
Question 48: An engineer is concerned with the compliance guidelines for ...
Question 49: Which design limitation of dual-band WLAN must be considered...
Question 50: You must create a simple implementation of QoS on a WIAN. Th...
Question 51: You must optimize an IPv6 wireless design to ensure that RA ...
Question 52: An engineer is preparing for an indoor wireless LAN survey a...
Question 53: When reviewing a design for a voice over wireless deployment...
Question 54: An engineer is tuning RRM parameters to improve client conne...
Question 55: An engineer has been assigned the task of deciding the cell ...
Question 56: After the completion of a site survey with Ekahau Site Surve...
Question 57: An engineer is determining the signal levels for the wireles...
Question 58: When a post-installation audit is performed with an auditing...
Question 59: Which piece of information gathered during a WLAN site surve...
Question 60: As part of a wireless site survey in a hospital, an engineer...
Question 61: An 802.11n implementation is being discussed. Users are sati...
Question 62: What RF phenomenon results from a presence of metallic I-bea...
Question 63: A user is running a new video conferencing application on th...
Question 64: You are designing a wireless network to support voice and vi...
Question 65: Which two factors influence the density of APs in a data-onl...
Question 66: A customer has dual-band devices that they want to use 40 MH...
Question 67: You are using Ekahau Site Survey to plan a WLAN. Which image...
Question 68: You perform a Layer 1 survey by using Metageek Chanalyzer on...
Question 69: A cabling contractor is working at a customer facility. The ...
Question 70: What two factors could cause a post-deployment audit to show...
Question 71: An engineer is implementing Q0S for a new wireless voice net...
Question 72: During an installation of a wireless network in a country th...
Question 73: Which three components and tasks should be considered while ...
Question 74: What protocol can be enabled to listen in on IPv4 multicast ...
Question 75: An engineer is assigned to assist a customer by estimating t...
Question 76: An engineer is tasked with designing a WLAN. The customer is...
Question 77: Which two pieces of physical infrastructure information shou...
Question 78: An engineer is performing a predictive wireless design for a...
Question 79: Refer to the exhibit. An engineer has determined that Cisco ...
Question 80: A customer is preparing to deploy a wireless network in a st...
Question 81: Which three reasons describe the importance of assessing exi...
Question 82: When designing a WLAN, AP placement is important. Which opti...
Question 83: An engineer would like to calibrate the RF environment to im...
Question 84: An engineer is configuring a new VoWLAN and wants only IEEE ...
Question 85: Which three recommendations must be taken into consideration...
Question 86: Which three options are benefits of U-APSD? (Choose three.)...
Question 87: A network engineer wants the DSCP marking to align with the ...
Question 88: An engineer has performed a post-deployment site survey and ...
Question 89: Which two critical requirements must be addressed in the RF ...
Question 90: You must redesign an existing wireless network that spans mu...
Question 91: Which two options describe best practices that must be compl...
Question 92: An engineer is performing a predictive RF design of a typica...
Question 93: A network engineer is performing a site survey in preparatio...
Question 94: Which list of characteristics must all controllers in a mobi...
Question 95: An engineer must implement a cabling infrastructure that sup...
Question 96: You are designing a wireless network that contains many diff...
Question 97: An engineer is configuring an autonomous AP for RADIUS authe...
Question 98: When conducting a wireless survey at a customer facility, si...
Question 99: An engineer is preparing for an active site survey of a ware...
Question 100: Which two modifications to station behaviors were designed i...
Question 101: Which two types of information must be included in the insta...
Question 102: An engineer must perform a survey where the target client de...
Question 103: A hospital environment was designed to guarantee RF coverage...
Question 104: After installation of a new data-only wireless network, an e...
Question 105: A customer wants to implement a wireless network in a histor...
Question 106: A wireless engineer is calibrating a floor using Cisco Prime...
Question 107: A customer is deploying a mesh outdoor wireless network base...