<< Prev Question Next Question >>

Question 75/101

A customer is deploying a Greenfield 802.11ac network on a floor that will support approximately 300 wireless devices. Which setting needs to be changed on Prime Infrastructure Planning Tool in order to predict the amount of access points the customer needs to service the new floor?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (101q)
Question 1: When conducting a wireless survey at a customer facility, si...
Question 2: A wireless engineer is hired to design a network for six bui...
Question 3: A downstream packet that contains a DSCP value arrives at th...
Question 4: An engineer is configuring an autonomous AP for RADIUS authe...
Question 5: IEEE 802.11r-2008 or fast BSS transition (FT), also called "...
Question 6: You must create a simple implementation of QoS on a WIAN. Th...
Question 7: An engineer is performing a predictive wireless design for a...
Question 8: When designing a large, high-availability wireless network, ...
Question 9: A post-deployment active wireless site survey was just compl...
Question 10: You are designing a wireless mesh network for an oil refiner...
Question 11: Given an AP that can transmit at 100 mW and the client at 40...
Question 12: A customer is deploying a mesh outdoor wireless network base...
Question 13: An engineer is planning for a 24 Mbps data rate on the 5Ghz ...
Question 14: During an installation of a wireless network in a country th...
Question 15: A wireless phone user is having roaming difficulties and is ...
Question 16: An engineer would like to calibrate the RF environment to im...
Question 17: A network engineer is having wireless multicast fail when it...
Question 18: A customer has deployed an N+N redundant wireless infrastruc...
Question 19: A customer has determined that a cable run for a low-through...
Question 20: Which type of information should be included in an installat...
Question 21: Which two basic characteristics would be needed from antenna...
Question 22: A network engineer is preparing for an office site survey wi...
Question 23: If you are calibrating for 2.4 GHz and the site will not be ...
Question 24: An engineer is preparing for an active site survey of a hosp...
Question 25: An engineer is conducting a location readiness test and want...
Question 26: A network engineer wants the DSCP marking to align with the ...
Question 27: Which two steps are associated with the active portion of th...
Question 28: After the completion of a site survey with Ekahau Site Surve...
Question 29: An engineer is preparing for an outdoor wireless survey to m...
Question 30: An engineer installed a 3702 AP and is getting power from th...
Question 31: An engineer has performed a post-installation site survey us...
Question 32: Which two options describe best practices that must be compl...
Question 33: You are using Ekahau to plan a wireless network. Which unit ...
Question 34: A customer is preparing to deploy a wireless network in a st...
Question 35: Which description of the ideal VoWLAN design is true?...
Question 36: You are planning the coverage for wireless VoIP by using Eka...
Question 37: A wireless engineer is hired to troubleshoot wireless networ...
Question 38: You must upgrade a data- based wireless network to support V...
Question 39: Which two pieces of physical infrastructure information shou...
Question 40: After installation of a new data-only wireless network, an e...
Question 41: An engineer must perform a survey where the target client de...
Question 42: During a post-deployment survey, the wireless engineer notic...
Question 43: An engineer has performed a post-deployment site survey and ...
Question 44: An engineer is implementing Q0S for a new wireless voice net...
Question 45: Which three things do you need to consider prior to performi...
Question 46: An engineer is determining powering requirements for a P2P w...
Question 47: A customer recently placed 10 WLCs in a mobility group and n...
Question 48: Which infrastructure issue needs to be verified and potentia...
Question 49: You have a customer that is building a new campus of four 3-...
Question 50: What is the result if a client radio is incapable of support...
Question 51: Refer to the exhibit. (Exhibit) While testing the post-deplo...
Question 52: When designing and deploying an outdoor mesh network, what i...
Question 53: When implementing video teleconferencing over a wireless net...
Question 54: Which three statements describe WLAN RF interaction with env...
Question 55: A company has deployed a centralized wireless architecture i...
Question 56: A network engineer is designing a high-density wireless netw...
Question 57: An engineer must design a wireless voice network and is audi...
Question 58: Which two information points should a pre-site survey questi...
Question 59: You are designing a wireless network to support high user de...
Question 60: When reviewing a design for a voice over wireless deployment...
Question 61: Cisco 7925G phones are experiencing intermittent connectivit...
Question 62: After enabling global multicast, multicast traffic has been ...
Question 63: When should a Layer I site survey be performed?...
Question 64: Which purpose of using Metageek Chanalyzer during site surve...
Question 65: A wireless engineer is configuring VoWLAN on a WLC. Which co...
Question 66: The ClO of a company wants to start tracking inventory in th...
Question 67: Which list of characteristics must all controllers in a mobi...
Question 68: An engineer is assigned to provide wireless coverage in a pr...
Question 69: A network engineer is performing a site survey in preparatio...
Question 70: Which option is an advantage at using Cisco CleanAir technol...
Question 71: The ClO of a company wants to start tracking inventory in th...
Question 72: Which two best practices should be considered when a custome...
Question 73: Which three factors must you consider before you deploy APs ...
Question 74: An engineer receives a digital image scanned from the floor ...
Question 75: A customer is deploying a Greenfield 802.11ac network on a f...
Question 76: Refer to the exhibit. An engineer has determined that Cisco ...
Question 77: An engineer wants the controller to report when a client exc...
Question 78: What is the optimal distance between APs for location servic...
Question 79: An engineer is performing a predictive wireless design for a...
Question 80: An engineer is concerned with the compliance guidelines for ...
Question 81: What protocol can be enabled to listen in on IPv4 multicast ...
Question 82: A network installation on the site with ID 337055022 has bee...
Question 83: An engineer is designing the physical infrastructure for an ...
Question 84: An engineer is preparing for an active site survey of a ware...
Question 85: You must redesign an existing wireless network that spans mu...
Question 86: Which piece of information gathered during a WLAN site surve...
Question 87: An access point will be partially exposed to the outdoor env...
Question 88: An engineer is deploying centralized wireless solution with ...
Question 89: When designing a WLAN, AP placement is important. Which opti...
Question 90: Which three parameters are used by Cisco Prime Infrastructur...
Question 91: Which two factors influence the density of APs in a data-onl...
Question 92: What is a common cause for signal attenuation?...
Question 93: An engineer must implement a cabling infrastructure that sup...
Question 94: An engineer has added an access point to a deployment after ...
Question 95: An engineer is deploying outdoor Cisco Aironet 1500 Series A...
Question 96: You deploy a wireless network for a common area located outs...
Question 97: A cabling contractor is working at a customer facility. The ...
Question 98: A customer has determined that aesthetics is a primary conce...
Question 99: IEEE 802.llk-2008 is an amendment to IEEE 80211- 2007 standa...
Question 100: You are designing an outdoor mesh network to cover several s...
Question 101: A customer wants to upgrade their current wireless infrastru...