300-360 Exam Dumps | Which two basic characteristics would be needed from antennas used for survey and deployment in various

Home
Cisco
Designing Cisco Wireless Enterprise Networks
Cisco.300-360.v2018-06-25.q117
Question 90

Valid 300-360 Dumps shared by ExamDiscuss.com for Helping Passing 300-360 Exam! ExamDiscuss.com now offer the newest 300-360 exam dumps, the ExamDiscuss.com 300-360 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-360 dumps with Test Engine here:

Access 300-360 Dumps Premium Version
(180 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 90/117

Which two basic characteristics would be needed from antennas used for survey and deployment in various indoor situations? (Choose two.)

A. Highest gain

B. Aesthetically fitting

C. Largest beamwidth

D. Vertically polarized

E. Horizontally polarized

F. Least cost

Correct Answer: B,D

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (117q): Question 1: How would clients react to a controller configuration that u...; Question 2: What is the result if a client radio is incapable of support...; Question 3: Which item is more of an issue to outdoor wireless mesh depl...; Question 4: When designing and deploying an outdoor mesh network, what i...; Question 5: The customer had a 802.11b/g WLAN site survey and installati...; Question 6: In post-deployment testing you have identified an area where...; Question 7: Refer to the exhibit. After performing a Layer 1 survey usin...; Question 8: When using WCS 7.0 to calibrate a floor in a facility, which...; Question 9: Drag and Drop Questions Drag from the left devices that woul...; Question 10: What is the recommended method to protect a wireless outdoor...; Question 11: What are two reasons that it is always preferable to obtain ...; Question 12: You are working with a client that owns a six-story building...; Question 13: Refer to the exhibit. After performing a Layer 1 survey usin...; Question 14: Refer to the exhibit. The signal is being degraded to the po...; Question 15: Aside from software applications, which two tools will be im...; Question 16: What is the vertical height that a MAP should not exceed for...; Question 17: Refer to the exhibit. After performing a Layer 1 survey usin...; Question 18: In which two ways does the type of industry vertical change ...; Question 19: Drag and Drop Questions Drag from the left the Cisco recomme...; Question 20: Which infrastructure issue needs to be verified and potentia...; Question 21: Which two options indicate the RF channels regulated by 802....; Question 22: Which option describes the method of measuring the beamwidth...; Question 23: You have completed a site survey for a customer that refurbi...; Question 24: When performing a post-installation audit with a auditing to...; Question 25: You have completed a WLAN site survey for a customer. Which ...; Question 26: Which two factors influence the density of APs in a data-onl...; Question 27: Drag and Drop Questions Drag from the left the acceptable mi...; Question 28: Which two statements best describe the Fresnel zone related ...; Question 29: Drag and Drop Questions Drag from the left the preferred par...; Question 30: You have been asked to evaluate a deployed version 7.0 contr...; Question 31: Which two statements best describe the Fresnel zone related ...; Question 32: When surveying and deploying a mesh network, considerations ...; Question 33: How does WCS 7.0 calculate the map location of devices?...; Question 34: Which two options describes the vertical RF coverage pattern...; Question 35: Given an AP that can transmit at 100 mW and the client at 40...; Question 36: Given a new VoWLAN survey and deployment using 7921G phones,...; Question 37: Which option allows the maximum 2.4-GHz channel usage for a ...; Question 38: You have a customer that is renovating a historic building f...; Question 39: Which three components make up a Statement of Work? (Choose ...; Question 40: Which item is the most common limiting factor in an outdoor ...; Question 41: You have been contacted by a medium sized medical center to ...; Question 42: When using WCS 7.0 to calibrate a floor, is it more importan...; Question 43: A Cisco 1250 AP is deployed for a/b/g/n using version 7.0 so...; Question 44: Drag and Drop Questions Drag from the left the maximum power...; Question 45: Which three statements describe WLAN RF interaction with env...; Question 46: When discussing a WLAN site survey project with a customer, ...; Question 47: You have a customer that operates a large open pit coal mine...; Question 48: Refer to the exhibit. In testing the post-deployment WLAN ne...; Question 49: When performing a post-installation audit with an auditing t...; Question 50: What two factors could cause a post-deployment audit to show...; Question 51: Refer to the exhibit. After performing a Layer 1 survey usin...; Question 52: Which three types of WLAN data, location, and voice testing ...; Question 53: When designing for location services, how many APs should be...; Question 54: Which three basic pieces of information will you need to per...; Question 55: When performing a site survey, what is a typical usable rang...; Question 56: Which three are logistical issues that need to be taken into...; Question 57: You have a customer that is building a new campus of four 3-...; Question 58: Which two issues do access and backhaul radios experience in...; Question 59: Which two types of information should be included in the ins...; Question 60: Refer to the exhibit. What is the most likely cause of MAP1 ...; Question 61: Drag and Drop Questions Drag from the left the material type...; Question 62: If you are calibrating for 2.4 GHz and the site will not be ...; Question 63: After you have run the VoWLAN Voice Readiness Tool in WCS 7....; Question 64: You have a client that would like to upgrade their 2.4-GHz p...; Question 65: What are the most appropriate channels for an 802.11a/n VoWL...; Question 66: What will cause wireless voice devices to perform poorly?...; Question 67: Which antenna generally has the narrowest first Fresnel zone...; Question 68: What does a Cisco Unified Wireless IP Phone 7921G deployment...; Question 69: Drag and Drop Questions Drag from the left the relative AP d...; Question 70: When ordering the software licenses for a Cisco WLAN project...; Question 71: Which two issues can commonly create problems with positioni...; Question 72: The customer has an existing 802.11b/g network with Cisco 25...; Question 73: During the site survey kick-off meeting with your customer, ...; Question 74: Which two pieces of physical infrastructure information shou...; Question 75: Which two Cisco antennas provide better isolation from RF so...; Question 76: Refer to the exhibit. After performing a Layer 1 survey usin...; Question 77: Mesh APs are commonly mounted alongside a pole, meaning they...; Question 78: A design requires 100 access points with high channel bandwi...; Question 79: What is the basic difference in the manner in which a client...; Question 80: Which three things do you need to consider prior to performi...; Question 81: Which option will allow the maximum 2.4 GHz channel usage fo...; Question 82: Which statement best describes an outdoor RF point-to-point ...; Question 83: Which two of the following are considered best practices upo...; Question 84: What is the term for the space that exists above a drop ceil...; Question 85: When designing a WLAN, AP placement is important. How would ...; Question 86: What is the biggest challenge a customer faces when they are...; Question 87: Which value is NOT supported by Cisco Spectrum Expert, when ...; Question 88: You have been asked to evaluate a new version 7.0 controller...; Question 89: What is the optimal distance between APs for location servic...; Question 90: Which two basic characteristics would be needed from antenna...; Question 91: In performing a post-deployment audit, you are concerned by ...; Question 92: Which three items should the site survey documentation inclu...; Question 93: When does the curvature of the earth become a factor in an o...; Question 94: When planning to perform a customer WLAN site survey, which ...; Question 95: Refer to the exhibit. After performing a Layer 1 survey usin...; Question 96: Which piece of information gathered during a WLAN site surve...; Question 97: Which term defines the effects on RF known as free space pat...; Question 98: You have a multinational customer that would like you to per...; Question 99: Customer requirements and a WLAN site survey require a Cisco...; Question 100: When performing a post-installation audit using the Ekahau S...; Question 101: Refer to the exhibit. Which type of cable connector is displ...; Question 102: Which tool can best provide throughput verification?...; Question 103: An initial meeting has been scheduled for a proposed site su...; Question 104: Which three components and tasks should be considered while ...; Question 105: After the site installation is complete, you should verify t...; Question 106: How many access points will a Cisco 7600 Series Router with ...; Question 107: An outdoor mesh network is being designed with one RAP and t...; Question 108: You have been contacted by a medium-sized hospitality compan...; Question 109: You have completed a WLAN site survey for a customer. Which ...; Question 110: Which three types of infrastructure issues need to be verifi...; Question 111: Which type of information should be included in an installat...; Question 112: Which two basic factors have the most influence on the size ...; Question 113: For better compatibility with 802.11n clients, which 802.11a...; Question 114: Which three types of information should be included in the p...; Question 115: Drag and Drop Questions Drag from the left the minimum requi...; Question 116: A new client has contacted you to design a WLAN solution for...; Question 117: Which wireless tool would be most useful in planning a WLAN ...

[×]

Download PDF File

Enter your email address to download Cisco.300-360.v2018-06-25.q117.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 90/117

LEAVE A REPLY

Download PDF File