300-360 Exam Dumps | An engineer has performed a post-installation site survey using Ekahau Site Survey with a recommended

Home
Cisco
Designing Cisco Wireless Enterprise Networks
Cisco.300-360.v2018-04-02.q137
Question 39

Valid 300-360 Dumps shared by ExamDiscuss.com for Helping Passing 300-360 Exam! ExamDiscuss.com now offer the newest 300-360 exam dumps, the ExamDiscuss.com 300-360 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-360 dumps with Test Engine here:

Access 300-360 Dumps Premium Version
(180 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 39/137

An engineer has performed a post-installation site survey using Ekahau Site Survey with a recommended adapter.
Which two metrics can be different between the adapter used to survey and the client adapter? (Choose two.)

A. SNR

B. data rate

C. DFS

D. channel overlap

Correct Answer: A,B

Explanation/Reference:
Explanation:
You must take note on what adapter was used in a site survey. The adapter should have similar characteristics to the adapters on the devices that are actually to be used in the wireless network. You should always verify what type of client adapter was used throughout the survey. A client adapter with a better receiver sensitivity and stronger antenna does not provide accurate results to compare against clients that are actually used in production.

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (137q): Question 1: An engineer is assigned to replace an older data-grade auton...; Question 2: Which two steps are associated with the active portion of th...; Question 3: An engineer plugs in a Cisco Aironet 2700 Series Access Poin...; Question 4: A wireless engineer is configuring VoWLAN on a WLC. Which co...; Question 5: A customer has determined that aesthetics is a primary conce...; Question 6: Which three factors must you consider before you deploy APs ...; Question 7: During a post-deployment survey, the wireless engineer notic...; Question 8: What protocol can be enabled to listen in on IPv4 multicast ...; Question 9: A customer has deployed an N+N redundant wireless infrastruc...; Question 10: Which three recommendations must be taken into consideration...; Question 11: A wireless engineer is hired to design a network for six bui...; Question 12: Which two best practices should be considered when a custome...; Question 13: An engineer is installing a wireless network in an industria...; Question 14: A wireless engineer is hired to troubleshoot wireless networ...; Question 15: The AP has been configured property for a VoWLAN survey The ...; Question 16: An engineer is tuning RRM parameters to improve client conne...; Question 17: Which purpose of using Metageek Chanalyzer during site surve...; Question 18: You must upgrade a data- based wireless network to support V...; Question 19: A downstream packet that contains a DSCP value arrives at th...; Question 20: A network engineer is performing a site survey in preparatio...; Question 21: Refer to the exhibit. An engineer has determined that Cisco ...; Question 22: A customer is having issues streaming video over wireless in...; Question 23: An engineer wants the controller to report when a client exc...; Question 24: You must redesign an existing wireless network that spans mu...; Question 25: An engineer is deploying centralized wireless solution with ...; Question 26: A customer is deploying a Greenfield 802.11ac network on a f...; Question 27: Which two options describe best practices that must be compl...; Question 28: An engineer is deploying outdoor Cisco Aironet 1500 Series A...; Question 29: Which option will allow the maximum 2.4 GHz channel usage fo...; Question 30: An engineer is performing a predictive wireless design for a...; Question 31: After implementing mesh with an IP surveillance camera conne...; Question 32: Which three parameters are used by Cisco Prime Infrastructur...; Question 33: You are designing a wireless mesh network for an oil refiner...; Question 34: Which two types of information must be included in the insta...; Question 35: A customer has dual-band devices that they want to use 40 MH...; Question 36: What is the recommended minimum speed at the edge of the cel...; Question 37: A wireless phone user is having roaming difficulties and is ...; Question 38: A customer reports that wireless clients are not able to rec...; Question 39: An engineer has performed a post-installation site survey us...; Question 40: An engineer has performed a post-deployment site survey and ...; Question 41: Cisco 7925G phones are experiencing intermittent connectivit...; Question 42: Refer to the exhibit. Which type of cable connector is displ...; Question 43: Which description of the ideal VoWLAN design is true?...; Question 44: What is the result if a client radio is incapable of support...; Question 45: When designing and deploying an outdoor mesh network, what i...; Question 46: Which two pieces of physical infrastructure information shou...; Question 47: An engineer is configuring an autonomous AP for RADIUS authe...; Question 48: As part of a wireless site survey in a hospital, an engineer...; Question 49: An engineer must design a wireless voice network and is audi...; Question 50: A customer is preparing to deploy a wireless network in a st...; Question 51: An engineer is implementing Q0S for a new wireless voice net...; Question 52: A customer is deploying a mesh outdoor wireless network base...; Question 53: DRAG DROP Drag and drop the IPv6 feature on the left to the ...; Question 54: When designing a large, high-availability wireless network, ...; Question 55: A customer has a business-critical voice network and wants t...; Question 56: An engineer has been assigned the task of deciding the cell ...; Question 57: An engineer is performing a predictive wireless design for a...; Question 58: An engineer is preparing for an outdoor wireless survey to m...; Question 59: Which two information points should a pre-site survey questi...; Question 60: You are planning the coverage for wireless VoIP by using Eka...; Question 61: When calculating bandwidth usage for an application, what tw...; Question 62: Which piece of information gathered during a WLAN site surve...; Question 63: Given an AP that can transmit at 100 mW and the client at 40...; Question 64: A company has deployed a centralized wireless architecture i...; Question 65: The ClO of a company wants to start tracking inventory in th...; Question 66: A post-deployment active wireless site survey was just compl...; Question 67: If you are calibrating for 2.4 GHz and the site will not be ...; Question 68: You are designing an outdoor mesh network to cover several s...; Question 69: When designing a WLAN, AP placement is important. Which opti...; Question 70: An access point will be partially exposed to the outdoor env...; Question 71: Which three options are benefits of U-APSD? (Choose three.)...; Question 72: Clients are experiencing artifacts in multicast video even t...; Question 73: After the completion of a site survey with Ekahau Site Surve...; Question 74: When reviewing a design for a voice over wireless deployment...; Question 75: You have a customer that is building a new campus of four 3-...; Question 76: A Cisco 7925 phone at a client's location is not registering...; Question 77: While performing a Layer 1 passive wireless site survey of a...; Question 78: A customer has restricted the AP and antenna combinations fo...; Question 79: A network engineer is configuring QoS with a DSCP value of 4...; Question 80: A customer wants to implement a wireless network in a histor...; Question 81: An engineer has added an access point to a deployment after ...; Question 82: Refer to the exhibit. (Exhibit) While testing the post-deplo...; Question 83: A network engineer is having wireless multicast fail when it...; Question 84: An engineer is configuring a new VoWLAN and wants only IEEE ...; Question 85: An engineer would like to calibrate the RF environment to im...; Question 86: Which option is an advantage at using Cisco CleanAir technol...; Question 87: Which infrastructure issue needs to be verified and potentia...; Question 88: You have a multinational customer that would like you to per...; Question 89: An engineer is preparing for an active site survey of a hosp...; Question 90: An engineer is assigned to assist a customer by estimating t...; Question 91: An engineer is preparing for an active site survey of a ware...; Question 92: Which two factors influence the density of APs in a data-onl...; Question 93: An engineer is concerned with the compliance guidelines for ...; Question 94: A corporation has a Cisco Unified Wireless Network that has ...; Question 95: When should a Layer I site survey be performed?...; Question 96: After enabling global multicast, multicast traffic has been ...; Question 97: An engineer receives a digital image scanned from the floor ...; Question 98: An engineer installed a 3702 AP and is getting power from th...; Question 99: Which type of information should be included in an installat...; Question 100: When implementing video teleconferencing over a wireless net...; Question 101: An engineer is assigned to provide wireless coverage in a pr...; Question 102: An 802.11n implementation is being discussed. Users are sati...; Question 103: Which three components and tasks should be considered while ...; Question 104: An engineer is preparing for an indoor wireless LAN survey a...; Question 105: An engineer is planning for a 24 Mbps data rate for a new in...; Question 106: An engineer is performing a predictive wireless design for a...; Question 107: You deploy a wireless network for a common area located outs...; Question 108: An engineer is determining powering requirements for a P2P w...; Question 109: An engineer must perform a survey where the target client de...; Question 110: IEEE 802.11r-2008 or fast BSS transition (FT), also called "...; Question 111: A network engineer wants the DSCP marking to align with the ...; Question 112: Which list of characteristics must all controllers in a mobi...; Question 113: A customer wants to upgrade their current wireless infrastru...; Question 114: A hospital environment was designed to guarantee RF coverage...; Question 115: Which two basic characteristics would be needed from antenna...; Question 116: IEEE 802.llk-2008 is an amendment to IEEE 80211- 2007 standa...; Question 117: Which two critical requirements must be addressed in the RF ...; Question 118: What is a common cause for signal attenuation?...; Question 119: What two factors could cause a post-deployment audit to show...; 1 commentQuestion 120: During an installation of a wireless network in a country th...; Question 121: A customer has determined that a cable run for a low-through...; Question 122: An engineer must design wireless coverage in thick-walled st...; Question 123: Which three things do you need to consider prior to performi...; Question 124: A cabling contractor is working at a customer facility. The ...; Question 125: You are designing a wireless network to support high user de...; Question 126: An engineer is conducting a location readiness test and want...; Question 127: When conducting a wireless survey at a customer facility, si...; Question 128: A network engineer is preparing for an office site survey wi...; Question 129: An engineer is determining the signal levels for the wireles...; Question 130: When planning to perform a customer WLAN site survey, which ...; Question 131: You must create a simple implementation of QoS on a WIAN. Th...; Question 132: An engineer is deploying an outdoor Mesh network. Which four...; Question 133: What is the optimal distance between APs for location servic...; Question 134: After installation of a new data-only wireless network, an e...; Question 135: What are two advantages of conducting an active survey versu...; Question 136: A customer recently placed 10 WLCs in a mobility group and n...; Question 137: Which three statements describe WLAN RF interaction with env...

[×]

Download PDF File

Enter your email address to download Cisco.300-360.v2018-04-02.q137.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 39/137

LEAVE A REPLY

Download PDF File