<< Prev Question Next Question >>

Question 63/68

Cisco 802.1X phasing enables flexible deployments through the use of open, low-impact, and closed modes. What is a unique characteristic of the most secure mode?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (68q)
Question 1: A network administrator needs to implement a service that en...
Question 2: Which command enables static PAT for TCP port 25?...
Question 3: In a split ACS deployment with primary and secondary servers...
Question 4: From which location can you run reports on endpoint profilin...
Question 5: What is the first step that occurs when provisioning a wired...
Question 6: Which three algorithms should be avoided due to security con...
Question 7: The NAC Agent uses which port and protocol to send discovery...
Question 8: Which statement about IOS accounting is true?...
Question 9: Changes were made to the ISE server while troubleshooting, a...
Question 10: What is the purpose of the Cisco ISE Guest Service Sponsor P...
Question 11: Which two authentication stores are supported to design a wi...
Question 12: Which two switchport commands enable MAB and allow non-802.1...
Question 13: Which statement about Cisco Management Frame Protection is t...
Question 14: Which three components comprise the Cisco ISE profiler? (Cho...
Question 15: Wireless client supplicants attempting to authenticate to a ...
Question 16: Which administrative role has permission to assign Security ...
Question 17: Which two conditions are valid when configuring ISE for post...
Question 18: A network administrator must enable which protocol extension...
Question 19: Which command can check a AAA server authentication for serv...
Question 20: An administrator can leverage which attribute to assign priv...
Question 21: Which term describes a software application that seeks conne...
Question 22: In AAA, what function does authentication perform?...
Question 23: In a multi-node ISE deployment, backups are not working on t...
Question 24: LAB: What are the initial steps must you perform to add the ...
Question 25: Cisco ISE distributed deployments support which three featur...
Question 26: Which two statements about Cisco NAC Agents that are install...
Question 27: Which two EAP types require server side certificates? (Choos...
Question 28: When MAB is configured, how often are ports reauthenticated ...
Question 29: Which command configures console port authorization under li...
Question 30: What is a feature of Cisco WLC and IPS synchronization?...
Question 31: Which command in the My Devices Portal can restore a previou...
Question 32: Which three features should be enabled as best practices for...
Question 33: In a basic ACS deployment consisting of two servers, for whi...
Question 34: Which command is useful when troubleshooting AAA Authenticat...
Question 35: What is a required step when you deploy dynamic VLAN and ACL...
Question 36: Which statement about system time and NTP server configurati...
Question 37: Which two statements about administrative access to the Cisc...
Question 38: How frequently does the Profiled Endpoints dashlet refresh d...
Question 39: When RADIUS NAC and AAA Override are enabled for WLC on a Ci...
Question 40: Which two services are included in the Cisco ISE posture ser...
Question 41: In the command 'aaa authentication default group tacacs loca...
Question 42: What are two client-side requirements of the NAC Agent and N...
Question 43: Which two statements about administrative access to the ACS ...
Question 44: Which set of commands allows IPX inbound on all interfaces?...
Question 45: Which three statements about the Cisco ISE profiler are true...
Question 46: An organization has recently deployed ISE with the latest mo...
Question 47: Which three personas can a Cisco ISE assume in a deployment?...
Question 48: Refer to the exhibit. Which three statements about the given...
Question 49: What is the effect of the ip http secure-server command on a...
Question 50: Which three statements about the Cisco wireless IPS solution...
Question 51: What are the initial steps to configure an ACS as a TACACS s...
Question 52: What is a requirement for posture administration services in...
Question 53: What steps must you perform to deploy a CA-signed identify c...
Question 54: Which identity store option allows you to modify the directo...
Question 55: Where is client traffic decrypted in a controller-based wire...
Question 56: In the command 'aaa authentication default group tacacs loca...
Question 57: Which two components are required to connect to a WLAN netwo...
Question 58: When RADIUS NAC and AAA Override are enabled for a WLC on a ...
Question 59: What is another term for 802.11i wireless network security?...
Question 60: Refer to the exhibit. If the given configuration is applied ...
Question 61: Which effect does the ip http secure-server command have on ...
Question 62: Which setting provides the best security for a WLAN and auth...
Question 63: Cisco 802.1X phasing enables flexible deployments through th...
Question 64: What implementation must be added to the WLC to enable 802.1...
Question 65: Which model does Cisco support in a RADIUS change of authori...
Question 66: In the command 'aaa authentication default group tacacs loca...
Question 67: Which two attributes must match between two Cisco ASA device...
Question 68: In an 802.1X authorization process, a network access device ...