Valid 300-165 Dumps shared by ExamDiscuss.com for Helping Passing 300-165 Exam! ExamDiscuss.com now offer the newest 300-165 exam dumps, the ExamDiscuss.com 300-165 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-165 dumps with Test Engine here:
Access 300-165 Dumps Premium Version
(326 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 36/168
Switch(config)# login block-for 60 attempts 10 within 180
Switch(config)# login quiet-mode access-class acl
Refer to the exhibit. Which statement is true about the impact to login requests on a Cisco NX-OS switch that uses this configuration?
Switch(config)# login quiet-mode access-class acl
Refer to the exhibit. Which statement is true about the impact to login requests on a Cisco NX-OS switch that uses this configuration?
Correct Answer: C
Explanation/Reference:
Explanation:
The "login quiet-mode access-class acl "command can help authorized users to log into device in case of system login block-for function. Then users from the acl localization can log into the cisco device even when others cannot.
Explanation:
The "login quiet-mode access-class acl "command can help authorized users to log into device in case of system login block-for function. Then users from the acl localization can log into the cisco device even when others cannot.
- Question List (168q)
- Question 1: Refer to the exhibit. Which IP address does N9K-1 use to rep...
- Question 2: You have two roles that are associated to the same user. Whi...
- Question 3: You have a Cisco MDS 9000 Series Switch that uses port chann...
- Question 4: Which technology is required in the underlay to facilitate r...
- Question 5: Which statement about implementation of Cisco TrustSec on Ci...
- Question 6: (Exhibit) Refer to the exhibit. Which type of domain does th...
- Question 7: (Exhibit) Refer to the exhibit. What does the diameter comma...
- Question 8: Which of the following Cisco Nexus features is best managed ...
- Question 9: Which two advantages does FabricPath have over Spanning Tree...
- Question 10: Which statement accurately describes MP-BGP EVPN?...
- Question 11: You have a Cisco Nexus 5000 Series switch. Port security is ...
- Question 12: (Exhibit) Refer to the exhibit. Which statement about the co...
- Question 13: Which statement about the Layer 3 card on the Cisco Nexus 55...
- Question 14: Which two issues explain why a packet is not being routed as...
- Question 15: When configuring OSPF, which two network types will avoid th...
- Question 16: Refer to the exhibit. Which result of implementing the confi...
- Question 17: By default it will take 10 seconds for authentication to fai...
- Question 18: Which features must be enabled to implement manual MACsec?...
- Question 19: Which statement regarding the implementation of Fibre Channe...
- Question 20: What is the default Fibre Channel interface type for an FCIP...
- Question 21: What can be identified by running the show install all impac...
- Question 22: Which statement about scalability in Cisco OTV is true?...
- Question 23: Which topology is not supported when using vPC?...
- Question 24: (Exhibit) Refer to the exhibit. Which result of implementing...
- Question 25: Which statement about implementing fabric binding is true?...
- Question 26: Which command sequence correctly enables Adapter FEX on Nexu...
- Question 27: Which feature must be enabled for Cisco TrustSec FC Link Enc...
- Question 28: Which two events automatically generate Cisco NX-OS checkpoi...
- Question 29: Which statement about enhanced zoning on Cisco Multilayer Di...
- Question 30: Refer to the exhibit. Which corrective action is taken to re...
- Question 31: Which action limits the maximum number of routes that are al...
- Question 32: (Exhibit) Refer to the exhibit. Which option is the result o...
- Question 33: What mode is required on a Cisco Nexus 7000 32-port 10-GB mo...
- Question 34: Which two actions are required when configuring LISP virtual...
- Question 35: Refer to the exhibit. (Exhibit) Which command configures a s...
- Question 36: Switch(config)# login block-for 60 attempts 10 within 180 Sw...
- Question 37: Which statement about Cisco FabricPath is true?...
- Question 38: Refer to the exhibit. What is the effect of the bind interfa...
- Question 39: Which three items must be configured in the port profile cli...
- Question 40: Refer to the exhibit. The ISSU fails. Which option do you ch...
- Question 41: Which statement about vPC loop avoidance is true?...
- Question 42: Which two statements about SAN zoning on Cisco Nexus switche...
- Question 43: Refer to the exhibit. This multilayer Cisco Nexus switch had...
- Question 44: Which option must be configured when you implement a vPC?...
- Question 45: Which issue does DCB address?
- Question 46: Refer to the exhibit. What is the maximum IPv6 unicast route...
- Question 47: Which three parameters can be set when configuring a Cisco M...
- Question 48: Which statement about the configuration of a VXLAN is true?...
- Question 49: Instructions * This task does not require device configurati...
- Question 50: Which three selections represent implementations of Cisco VN...
- Question 51: In a Cisco Catalyst 6500 Series Switch with redundant superv...
- Question 52: Which statement describes what happens if a new EPLD version...
- Question 53: Which two items are required components of VN-Link in softwa...
- Question 54: (Exhibit) Refer to the exhibit. You have a suboptimal outbou...
- Question 55: Which two items are features that are available in VN-Link i...
- Question 56: Which technology facilitates a nondisruptive upgrade on a Ci...
- Question 57: Which statement about RBAC user roles on a Cisco Nexus switc...
- Question 58: Which FCoE component is responsible for the encapsulation an...
- Question 59: How is a dynamic vNIC allocated?...
- Question 60: What is the Overlay Transport Virtualization site VLAN used ...
- Question 61: The Connectivity Management Processor monitors the active su...
- Question 62: Assuming hello PDU authentication has been disabled, which c...
- Question 63: You plan to implement the OSPF protocol whithin the data cen...
- Question 64: Which GLBL load-balancing method ensures that a client is al...
- Question 65: Which two statements about Cisco Nexus 7000 line cards are t...
- Question 66: Which command is used to associate EID-to-RLOC for a LISP si...
- Question 67: In policy-based routing, which action is taken for packets t...
- Question 68: Which three options are CallHome predefined destination prof...
- Question 69: (Exhibit) Refer to the exhibit. You are implementing a rollb...
- Question 70: Which two RFCs are supported by Cisco NX-OS devices for OSPF...
- Question 71: Which policy-map action performs congestion avoidance?...
- Question 72: Which Cisco Nexus feature is best managed with DCNM-SAN?...
- Question 73: When configuring HSPR on IPv6-enabled interfaces, which two ...
- Question 74: When a local RBAC user account has the same name as a remote...
- Question 75: Refer to the exhibit. (Exhibit) You configure two switches n...
- Question 76: Which parameter is configurable when setting up logging on t...
- Question 77: (Exhibit) Refer to the exhibit. Which two descriptions of th...
- Question 78: What must be enabled on the interface of a multicast-enabled...
- Question 79: During the design of a new Cisco Data Center Network, a cust...
- Question 80: Refer to the exhibit. Which fabric-provided MAC address does...
- Question 81: Scenario The following four questions concern the Nexus 7010...
- Question 82: What is the result when the configured RTT of an FCIP link i...
- Question 83: You plan to configure authentication for OSPF. In which conf...
- Question 84: What is an Overlay Transport Virtualization extended VLAN?...
- Question 85: Which example creates an Embedded Event Manager policy allow...
- Question 86: Which command allows a Cisco Nexus 7000 Series Switch to rec...
- Question 87: (Exhibit) Customer has configured fabricpath allocate-delay ...
- Question 88: Refer to the exhibit. How does Switch 1 route traffic to the...
- Question 89: Which security feature is only supported on the Cisco Nexus ...
- Question 90: Which statement about the MPLS feature set is true?...
- Question 91: Which statement about FabricPath and private VLANs is true?...
- Question 92: You have a Cisco FabricPath network. You must extend the net...
- Question 93: Which two statements about VRRP are true? (Choose two.)...
- Question 94: Which statement explains why a Cisco UCS 6200 Fabric Interco...
- Question 95: You are configuring QoS on a Cisco Nexus 5000 Series switch....
- Question 96: On a Cisco Nexus 7000 Series router, witch statement about H...
- Question 97: You have a Fibre Channel switch with one of its ports connec...
- Question 98: If vPC peer keepalives are used between vPC peers, which VRF...
- Question 99: Which command lists all the available file systems on a Cisc...
- Question 100: You must configure Microsoft Network Load Balancing in unica...
- Question 101: Instructions * This task does not require device configurati...
- Question 102: (Exhibit) Refer to the exhibit. Which field identifies the E...
- Question 103: (Exhibit) FabricPath switch- id is 25 and load-balance is co...
- Question 104: Refer to the exhibit. Which two outcomes occur when the stat...
- Question 105: Which function does the graceful restart feature allow a Cis...
- Question 106: You have two Fibre Channel switches that are connected via E...
- Question 107: Which standard has Cisco used to implement VM-FEX?...
- Question 108: Which two statements about SAN zoning on Cisco Nexus switche...
- Question 109: Which protocol is responsible for the discovery of FCoE capa...
- Question 110: Which statement about a configuration that uses OSPFv3 multi...
- Question 111: SW3#rollback running-config checkpoint user-checkpoint-1 ato...
- Question 112: Which command enables NPIV on Cisco Nexus 5000 Series Switch...
- Question 113: Which three VDC resources can be constrained with a resource...
- Question 114: Within the vPC configuration of the 7K's, the command peer-s...
- Question 115: (Exhibit) Refer to the exhibit. You have a Cisco Nexus 7010 ...
- Question 116: What is the grace period in a graceful restart situation?...
- Question 117: Which feature must be configured before you can implement a ...
- Question 118: On a Cisco Catalyst 6500 Series Supervisor Engine 720, an ag...
- Question 119: When configuring PIM on a Cisco Nexus 7000 Series switch, wh...
- Question 120: switch# configure terminal switch (config) # interface ether...
- Question 121: (Exhibit) Refer to the exhibit. Which command should you run...
- Question 122: (Exhibit) Refer to the exhibit. Which corrective action is t...
- Question 123: Which two statements are true when implementing fabric bindi...
- Question 124: Which three types of interfaces are required when implementi...
- Question 125: You are configuring OTV between two data centers. On which i...
- Question 126: Which command activates the port security database for VSAN ...
- Question 127: Which two file systems can hold a Cisco Catalyst 6500 IOS im...
- Question 128: Which implicit rules are applied to all IPv6 ACLs?...
- Question 129: Which option is a restriction of the unified ports on the Ci...
- Question 130: Refer to the exhibit. (Exhibit) You must ensure that the vPC...
- Question 131: (Exhibit) Refer to the exhibit. Which option is the result o...
- Question 132: (Exhibit) Refer to the exhibit. What is the result of the co...
- Question 133: Refer to the exhibit. (Exhibit) What is the result when you ...
- Question 134: When creating a VDC on a Cisco Nexus 7000 switch, which comm...
- Question 135: Your customer wants to use distinct security policies for di...
- Question 136: What is the purpose of the resequence command for ACLs?...
- Question 137: You plant to configure a SAN zone set. Which two facts shoul...
- Question 138: Which two actions are required before FIPS is configured in ...
- Question 139: Refer to the exhibit. (Exhibit) You must configure zones on ...
- Question 140: (Exhibit) Refer to the exhibit. Which statement regarding th...
- Question 141: Refer to the exhibit. Which result of the configuration snip...
- Question 142: After enabling strong, reversible 128-bit Advanced Encryptio...
- Question 143: Refer to the exhibit. (Exhibit) Which statement about the Ne...
- Question 144: Refer to the exhibit. Which three statements about the Cisco...
- Question 145: Which two security features are only supported on the Cisco ...
- Question 146: What are two requirements for configuring SAN device aliases...
- Question 147: When implementing Cisco Adapter FEX, which setting on the vi...
- Question 148: Which statement about electronic programmable logic device i...
- Question 149: Which statement about core-edge SAN topology is true?...
- Question 150: Which two reasons explain why a server on VLAN 10 is unable ...
- Question 151: Which feature enables NIV?
- Question 152: Which feature does a vFC interface support?...
- Question 153: Refer to the exhibit. Which result of implementing the confi...
- Question 154: Which two protocols can be used to back up the configuration...
- Question 155: How does addition of bandwidth between spine and leaf switch...
- Question 156: Which technology relies on STP as a failsafe mechanism?...
- Question 157: Refer to the exhibit. An engineer is implementing a new netw...
- Question 158: You are implementing a Cisco FabricPath network. Which state...
- Question 159: Scenario The following four questions concern the Nexus 7010...
- Question 160: (Exhibit) Refer to the exhibit. The configuration belongs to...
- Question 161: ipv6 access-list MY_ACL permit tcp 2001:cc1e:aaaa::/64 2001:...
- Question 162: Which statement about RADIUS configuration distribution usin...
- Question 163: Which command should you use to apply a custom CoPP policy?...
- Question 164: What are two prerequisites to running the Smart Call Home fe...
- Question 165: Instructions * This task does not require device configurati...
- Question 166: Which command ensures that a learned MAC address is stored w...
- Question 167: When you configure LISP, which two components must be config...
- Question 168: Which GLBP load-balancing algorithm ensures that a client is...
