<< Prev Question Next Question >>

Question 53/156

Instructions
* This task does not require device configuration.
* Click Cisco Nexus 5548 to gain console access. No console or enable passwords are required.
* To access the multiple-choice questions, click the numbered boxes on the left of the top panel.
* There are four multiple-choice questions with this task.
Scenario
Customer is deploying Cisco Nexus 5548 switch with FCoE in their new data center, as shown in the topology diagram. Click Nexus5548 icon to run show commands and answer the questions.


What is the status of FC interface associated with ethernet 1/5 indicate?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (156q)
Question 1: Which statement explains why a Cisco UCS 6200 Fabric Interco...
Question 2: Which four options are capabilities of the Cisco Nexus 5000 ...
Question 3: Which two statements about implementing Cisco NPV and NPIV o...
Question 4: A Cisco Catalyst 6500 Series Switch suffers a supervisor fai...
Question 5: Which two actions are required before FIPS is configured in ...
Question 6: (Exhibit) FabricPath switch- id is 25 and load-balance is co...
Question 7: Which standard has Cisco used to implement VM-FEX?...
Question 8: What must be enabled on the interface of a multicast-enabled...
Question 9: You have two Cisco Nexus 7700 Series switches named SwitchA ...
Question 10: (Exhibit) Refer to the exhibit. Which action do you take to ...
Question 11: Which protocol is the foundation for unified fabric as imple...
Question 12: (Exhibit) What is effect of the command "fabric path load-ba...
Question 13: You have a Cisco FabricPath network. You must extend the net...
Question 14: Which protocol is responsible for the discovery of FCoE capa...
Question 15: Which two elements must be configured correctly for Cisco Tr...
Question 16: Refer to the exhibit. What is the maximum IPv6 unicast route...
Question 17: Which feature allows routing protocols to remain in the data...
Question 18: Which statement describes what happens if a new EPLD version...
Question 19: Which statement about scalability in Cisco OTV is true?...
Question 20: How does addition of bandwidth between spine and leaf switch...
Question 21: Which situation must you consider when you add a remote RADI...
Question 22: Which LISP component provides connectivity between LISP and ...
Question 23: Which command should you run to limit IS-IS LSP flooding on ...
Question 24: Which command allows a Cisco Nexus 7000 Series Switch to rec...
Question 25: You enable the HSRP feature on a Cisco Nexus 7000 Series swi...
Question 26: What are two prerequisites to running the Smart Call Home fe...
Question 27: Which Cisco NX-OS feature allows transparent Layer 2 extensi...
Question 28: Which three options are capabilities of the Cisco Nexus 7000...
Question 29: Which action limits the maximum number of routes that are al...
Question 30: Which two Nexus family linecards allow the configuration of ...
Question 31: Which option accurately describes an EPLD upgrade on supervi...
Question 32: Which two functions are enabled when you set up vPC+ at the ...
Question 33: N7k(config)# logging logfile LOGFILES Refer to the exhibit. ...
Question 34: What configuration is required when implementing FCoE?...
Question 35: In Cisco Nexus 7000 Series Switches, which three statements ...
Question 36: Instructions * This task does not require device configurati...
Question 37: In OTV, how are the VLANs split when a site has two edge dev...
Question 38: Which two advantages does FabricPath have over Spanning Tree...
Question 39: Refer to the exhibit. Which result of the configuration snip...
Question 40: Instructions * This task does not require device configurati...
Question 41: You have a switch that is operating in NPV mode. The interfa...
Question 42: When configuring HSPR on IPv6-enabled interfaces, which two ...
Question 43: What is the default Fibre Channel interface type for an FCIP...
Question 44: Fibre Channel IDs are dynamically assigned to which objects?...
Question 45: (Exhibit) Refer to the exhibit. Which two statements about t...
Question 46: Which three options are CallHome predefined destination prof...
Question 47: Which interface is used for vPC peer keepalives on both 7000...
Question 48: Which two statements are true when implementing fabric bindi...
Question 49: Which statement about Cisco FabricPath is true?...
Question 50: Which SCSI terminology is used to describe source and destin...
Question 51: Which three options are capabilities of the Cisco Nexus 7000...
Question 52: Which three parameters can be set when configuring a Cisco M...
Question 53: Instructions * This task does not require device configurati...
Question 54: What is the result when the configured RTT of an FCIP link i...
Question 55: Which statement about the MPLS feature set is true?...
Question 56: SW3#rollback running-config checkpoint user-checkpoint-1 ato...
Question 57: Which two file systems can hold a Cisco Catalyst 6500 IOS im...
Question 58: Which feature does the spanning-tree port type network comma...
Question 59: Which task must be done before a zone set takes effect?...
Question 60: You have a Cisco FabricPath network. You must implement vPC+...
Question 61: After enabling strong, reversible 128-bit Advanced Encryptio...
Question 62: Refer to the exhibit. Which corrective action is taken to re...
Question 63: Within the vPC configuration of the 7K's, the command peer-s...
Question 64: Refer to the exhibit. Which two outcomes occur when the stat...
Question 65: Which topology is not supported when using vPC?...
Question 66: Which command specifies a load-balancing method based on the...
Question 67: Which command lists all the available file systems on a Cisc...
Question 68: Which two benefits are realized when deploying Cisco Catalys...
Question 69: Which information does the show fcns database command displa...
Question 70: Which option must be enabled to implement manual MACsec?...
Question 71: (Exhibit) Refer to the exhibit. Which command should you run...
Question 72: Which feature must be enabled for Cisco TrustSec FC Link Enc...
Question 73: You plant to configure a SAN zone set. Which two facts shoul...
Question 74: During the design of a new Cisco Data Center Network, a cust...
Question 75: switch (config)# spanning-tree port type edge bpdufilter def...
Question 76: Which configuration is specific to Cisco TelePresence System...
Question 77: In a Cisco Catalyst 6500 Series Switch with redundant superv...
Question 78: (Exhibit) Refer to the exhibit. What does the diameter comma...
Question 79: Which option accurately describes the implementation of Fibr...
Question 80: Which statement about the configuration of a VXLAN is true?...
Question 81: Which two items are services that are provided by Cisco Fabr...
Question 82: (Exhibit) Refer to the exhibit. Which corrective action is t...
Question 83: When configuring PIM to support an OTV implementation, which...
Question 84: What is the purpose of the resequence command for ACLs?...
Question 85: Which parameter is configurable when setting up logging on t...
Question 86: Which command should you use to apply a custom CoPP policy?...
Question 87: Which three options of encryption are supported in PIM hello...
Question 88: Which function does the graceful restart feature allow a Cis...
Question 89: You are configuring QoS on a Cisco Nexus 5000 Series switch....
Question 90: Which statement about the implementation of Cisco TrustSec o...
Question 91: Which two protocols can be used to back up the configuration...
Question 92: Refer to the exhibit. (Exhibit) Which statement about the re...
Question 93: Assuming hello PDU authentication has been disabled, which c...
Question 94: Switch(config)# login block-for 60 attempts 10 within 180 Sw...
Question 95: Without having access to Fabric Path show commands, how can ...
Question 96: Which option shows how to configure an ERSPAN Type III sourc...
Question 97: Which two RFCs are supported by Cisco NX-OS devices for OSPF...
Question 98: Which statement about RADIUS configuration distribution usin...
Question 99: N7k# show ip lisp locator-table DataCenter Information appli...
Question 100: You have two Fibre Channel switches that are connected via E...
Question 101: When a local RBAC user account has the same name as a remote...
Question 102: Refer to the exhibit. Which three statements about the Cisco...
Question 103: Which three attributes encompass a local user account on a C...
Question 104: When implementing Cisco Adapter FEX, which setting on the vi...
Question 105: You have a Cisco Nexus 5000 Series switch. Port security is ...
Question 106: Which statement about FabricPath and private VLANs is true?...
Question 107: Which four statements about reserved VLANs in Cisco NX-OS ar...
Question 108: Which statement about implementation of Cisco TrustSec on Ci...
Question 109: Which statement about the Layer 3 card on the Cisco Nexus 55...
Question 110: Which two PIM modes on a Cisco Nexus 7000 Series switch requ...
Question 111: By default it will take 10 seconds for authentication to fai...
Question 112: Refer to the exhibit. (Exhibit) Which statement about the Ne...
Question 113: Which command ensures that a learned MAC address is stored w...
Question 114: Which two options accurately describe the implementation of ...
Question 115: Which features must be enabled to implement manual MACsec?...
Question 116: When creating a VDC on a Cisco Nexus 7000 switch, which comm...
Question 117: Which statement about core-edge SAN topology is true?...
Question 118: Which command activates the port security database for VSAN ...
Question 119: Using the default VDC high-availability options in the Cisco...
Question 120: Which two options are limitations of NetFlow Version 5? (Cho...
Question 121: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...
Question 122: You are configuring OTV between two data centers. On which i...
Question 123: On a Cisco Catalyst 6500 Series Supervisor Engine 720, an ag...
Question 124: Which option is a restriction of the unified ports on the Ci...
Question 125: When configuring OSPF, which two network types will avoid th...
Question 126: Which example creates an Embedded Event Manager policy allow...
Question 127: (Exhibit) Refer to the exhibit. You have a suboptimal outbou...
Question 128: (Exhibit) Refer to the exhibit. What is the result of the co...
Question 129: Refer to the exhibit. Which two commands are missing from th...
Question 130: What are two ways to configure the switch ID for Cisco Fabri...
Question 131: Which two issues explain why a packet is not being routed as...
Question 132: Your customer wants to use distinct security policies for di...
Question 133: You have a Cisco MDS 9000 Series Switch that uses port chann...
Question 134: You have two roles that are associated to the same user. Whi...
Question 135: Which security feature is only supported on the Cisco Nexus ...
Question 136: In a Cisco Catalyst 6500 VSS 1440 domain on a Catalyst 6509 ...
Question 137: If vPC peer keepalives are used between vPC peers, which VRF...
Question 138: (Exhibit) Customer has configured fabricpath allocate-delay ...
Question 139: (Exhibit) On a Cisco Nexus7000 switches what is true regardi...
Question 140: Which command is used to associate EID-to-RLOC for a LISP si...
Question 141: You have a Cisco Nexus 7700 Series switch on which the grace...
Question 142: Which two statements are true when performing a SPAN capture...
Question 143: Refer to the exhibit. (Exhibit) You must configure zones on ...
Question 144: Nexus_7k (config)# feature port-security Nexus_7k (config-if...
Question 145: Which two security features are only supported on the Cisco ...
Question 146: Which technology relies on STP as a failsafe mechanism?...
Question 147: What are two requirements for configuring SAN device aliases...
Question 148: Instructions * This task does not require device configurati...
Question 149: You have a vPC configuration with two functional peers and t...
Question 150: Which two statements about Cisco Nexus 7000 line cards are t...
Question 151: Which two events automatically generate Cisco NX-OS checkpoi...
Question 152: If you are using NAT in your data center, which load balanci...
Question 153: Within the vPC configuration of the 7K's the command peer-ga...
Question 154: Refer to the exhibit. This multilayer Cisco Nexus switch had...
Question 155: N7k-1# show running-config fabricpath ... fabricpath switch-...
Question 156: You configure STP on a switch that is attached to a Cisco Fa...