300-165 Exam Dumps | What configuration is required when implementing FCoE?

Home
Cisco
Implementing Cisco Data Center Infrastructure
Cisco.300-165.v2018-08-15.q144
Question 90

Valid 300-165 Dumps shared by ExamDiscuss.com for Helping Passing 300-165 Exam! ExamDiscuss.com now offer the newest 300-165 exam dumps, the ExamDiscuss.com 300-165 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 300-165 dumps with Test Engine here:

Access 300-165 Dumps Premium Version
(326 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 90/144

What configuration is required when implementing FCoE?

A. disable LAN traffic on the interface

B. configure PortFast on the access port

C. permit all VLANs on the interface

D. permit all VSANs on the interface

Correct Answer: A

Explanation/Reference:
Explanation:
DCBX allows the switch to send a LAN Logical Link Status (LLS) message to a directly-connected CNA.
Enter the shutdown lan command to send an LLS-Down message to the CNA. This command causes all VLANs on the interface that are not enabled for FCoE to be brought down. If a VLAN on the interface is enabled for FCoE, it continues to carry SAN traffic without any interruption.
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/fcoe/ b_Cisco_Nexus_5000_Series_NX-OS_Fibre_Channel_over_Ethernet_Configuration_Guide_/ Cisco_Nexus_5000_Series_NX- OS_Fibre_Channel_over_Ethernet_Configuration_Guide__chapter3.html

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (144q): Question 1: Refer to the exhibit. Which three statements about the Cisco...; Question 2: Instructions * This task does not require device configurati...; Question 3: What must be enabled on the interface of a multicast-enabled...; Question 4: Which statement about RBAC user roles on a Cisco Nexus switc...; Question 5: DRAG DROP Drag the description on the left to the most appro...; Question 6: Which command allows a Cisco Nexus 7000 Series Switch to rec...; Question 7: Which two statements about SAN zoning on Cisco Nexus switche...; Question 8: (Exhibit) What is effect of the command "fabric path load-ba...; Question 9: DRAG DROP Drag the security description on the left to the a...; Question 10: N7k# show ip lisp locator-table DataCenter Information appli...; Question 11: Which statement about scalability in Cisco OTV is true?...; Question 12: DRAG DROP Drag the network characteristics on the left to th...; Question 13: (Exhibit) FabricPath switch- id is 25 and load-balance is co...; Question 14: Which two items are services that are provided by Cisco Fabr...; Question 15: Which Cisco Nexus feature is best managed with DCNM-SAN?...; Question 16: When configuring PIM to support an OTV implementation, which...; Question 17: The Connectivity Management Processor monitors the active su...; Question 18: switch (config)# spanning-tree port type edge bpdufilter def...; Question 19: Which statement about the implementation of Cisco TrustSec o...; Question 20: What mode is required on a Cisco Nexus 7000 32-port 10-GB mo...; Question 21: You have a Cisco Nexus 7700 Series switch on which the grace...; Question 22: Instructions * This task does not require device configurati...; Question 23: Which statement is true if password-strength checking is ena...; Question 24: What is the grace period in a graceful restart situation?...; Question 25: Which three options are capabilities of the Cisco Nexus 7000...; Question 26: You are configuring QoS on a Cisco Nexus 5000 Series switch....; Question 27: Which two functions are enabled when you set up vPC+ at the ...; Question 28: You have two Fibre Channel switches that are connected via E...; Question 29: If you are using NAT in your data center, which load balanci...; Question 30: N7k(config)# logging logfile LOGFILES Refer to the exhibit. ...; Question 31: You are configuring OTV between two data centers. On which i...; Question 32: Which feature allows routing protocols to remain in the data...; Question 33: Which two elements must be configured correctly for Cisco Tr...; Question 34: Which statement about core-edge SAN topology is true?...; Question 35: Which LISP component provides connectivity between LISP and ...; Question 36: Assuming hello PDU authentication has been disabled, which c...; Question 37: Which command ensures that a learned MAC address is stored w...; Question 38: When a local RBAC user account has the same name as a remote...; Question 39: Which command is used to associate EID-to-RLOC for a LISP si...; Question 40: Which command specifies a load-balancing method based on the...; Question 41: Which two statements about SAN zoning on Cisco Nexus switche...; Question 42: Nexus_7k (config)# feature port-security Nexus_7k (config-if...; Question 43: When configuring OSPF, which two network types will avoid th...; Question 44: Refer to the exhibit. This multilayer Cisco Nexus switch had...; Question 45: Which command should you run to limit IS-IS LSP flooding on ...; Question 46: Which four statements about reserved VLANs in Cisco NX-OS ar...; Question 47: Which configuration is specific to Cisco TelePresence System...; Question 48: Instructions * This task does not require device configurati...; Question 49: Which statement about implementation of Cisco TrustSec on Ci...; Question 50: You have a vPC configuration with two functional peers and t...; Question 51: Which information does the show fcns database command displa...; Question 52: Which two statements about implementing Cisco NPV and NPIV o...; Question 53: Which two types of traffic are carried over a vPC peer link ...; Question 54: (Exhibit) Refer to the exhibit. What does the diameter comma...; Question 55: Which option is a restriction of the unified ports on the Ci...; Question 56: You configure STP on a switch that is attached to a Cisco Fa...; Question 57: (Exhibit) Refer to the exhibit. Which option is the result o...; Question 58: Which protocol is responsible for the discovery of FCoE capa...; Question 59: Which task must be done before a zone set takes effect?...; Question 60: Which action limits the maximum number of routes that are al...; Question 61: Which option shows how to configure an ERSPAN Type III sourc...; Question 62: Which standard has Cisco used to implement VM-FEX?...; Question 63: Which statement about RADIUS configuration distribution usin...; Question 64: Which two options are limitations of NetFlow Version 5? (Cho...; Question 65: DRAG DROP Drag and drop the types of PTP clocks on the left ...; Question 66: N7K-1(config)# feature vpc N7K-1(config)# vpc domain 113 N7K...; Question 67: When implementing Cisco Adapter FEX, which setting on the vi...; Question 68: Which two advantages does FabricPath have over Spanning Tree...; Question 69: Which three parameters can be set when configuring a Cisco M...; Question 70: (Exhibit) Refer to the exhibit. Which two statements about t...; Question 71: You have two roles that are associated to the same user. Whi...; Question 72: Which interface is used for vPC peer keepalives on both 7000...; Question 73: You have a switch that is operating in NPV mode. The interfa...; Question 74: Which of the following Cisco Nexus features is best managed ...; Question 75: Which command should you use to apply a custom CoPP policy?...; Question 76: Which statement explains why a Cisco UCS 6200 Fabric Interco...; Question 77: Which two RFCs are supported by Cisco NX-OS devices for OSPF...; Question 78: DRAG DROP Drag and drop the LISP devices from the left onto ...; Question 79: In OTV, how are the VLANs split when a site has two edge dev...; Question 80: (Exhibit) On a Cisco Nexus7000 switches what is true regardi...; Question 81: After enabling strong, reversible 128-bit Advanced Encryptio...; Question 82: You have a Cisco MDS 9000 Series Switch that uses port chann...; Question 83: (Exhibit) Customer has configured fabricpath allocate-delay ...; Question 84: Which command activates the port security database for VSAN ...; Question 85: Which technology relies on STP as a failsafe mechanism?...; Question 86: What are two ways to configure the switch ID for Cisco Fabri...; Question 87: How does addition of bandwidth between spine and leaf switch...; 1 commentQuestion 88: N7k-1# show running-config fabricpath ... fabricpath switch-...; Question 89: Fibre Channel IDs are dynamically assigned to which objects?...; Question 90: What configuration is required when implementing FCoE?...; Question 91: Which feature must be enabled for Cisco TrustSec FC Link Enc...; Question 92: Which option accurately describes an EPLD upgrade on supervi...; Question 93: (Exhibit) Refer to the exhibit. You have a suboptimal outbou...; Question 94: Within the vPC configuration of the 7K's the command peer-ga...; Question 95: Which statement about Cisco FabricPath is true?...; Question 96: Instructions * This task does not require device configurati...; Question 97: Which two statements about Cisco Nexus 7000 line cards are t...; Question 98: Which three options are CallHome predefined destination prof...; Question 99: What are two prerequisites to running the Smart Call Home fe...; Question 100: In Cisco Nexus 7000 Series Switches, which three statements ...; Question 101: Which parameter is configurable when setting up logging on t...; Question 102: Which two statements are true when performing a SPAN capture...; Question 103: Which three options are capabilities of the Cisco Nexus 7000...; 1 commentQuestion 104: switch(config)# snmp-server user all enforcePriv Refer to th...; Question 105: Which statement describes what happens if a new EPLD version...; Question 106: When creating a VDC on a Cisco Nexus 7000 switch, which comm...; Question 107: Which statement about the MPLS feature set is true?...; Question 108: Which three options of encryption are supported in PIM hello...; Question 109: Refer to the exhibit. Which corrective action is taken to re...; Question 110: You have two Cisco Nexus 7700 Series switches named SwitchA ...; Question 111: You have a Cisco FabricPath network. You must implement vPC+...; 1 commentQuestion 112: Without having access to Fabric Path show commands, how can ...; Question 113: (Exhibit) Refer to the exhibit. Which action do you take to ...; Question 114: Which two events automatically generate Cisco NX-OX checkpoi...; Question 115: Which two Nexus family linecards allow the configuration of ...; Question 116: Which topology is not supported when using vPC?...; Question 117: Which Cisco NX-OS feature allows transparent Layer 2 extensi...; Question 118: Which three attributes encompass a local user account on a C...; Question 119: Which statement about the Layer 3 card on the Cisco Nexus 55...; Question 120: Which implicit rules are applied to all IPv6 ACLs?...; Question 121: What are two requirements for configuring SAN device aliases...; Question 122: Which situation must you consider when you add a remote RADI...; Question 123: Which two security features are only supported on the Cisco ...; Question 124: What is the purpose of the resequence command for ACLs?...; Question 125: DRAG DROP VSANs and SAN Zoning have similar security goals, ...; Question 126: Which security feature is only supported on the Cisco Nexus ...; Question 127: What is the default Fibre Channel interface type for an FCIP...; Question 128: You have a Cisco FabricPath network. You must extend the net...; Question 129: SW3#rollback running-config checkpoint user-checkpoint-1 ato...; Question 130: Switch(config)# login block-for 60 attempts 10 within 180 Sw...; Question 131: mac access-list mac-01 permit 11c0.0000.0000 0000.ffff.ffff ...; Question 132: Which two statements are true when implementing fabric bindi...; Question 133: When configuring HSPR on IPv6-enabled interfaces, which two ...; Question 134: DRAG DROP Drag and drop the types of spanning tree ports fro...; Question 135: What is the result when the configured RTT of an FCIP link i...; Question 136: By default it will take 10 seconds for authentication to fai...; Question 137: Refer to the exhibit. What is the maximum IPv6 unicast route...; Question 138: DRAG DROP Drag the description on the left to the most appro...; Question 139: Which GLBP load-balancing algorithm ensures that a client is...; Question 140: Which features must be enabled to implement manual MACsec?...; Question 141: (Exhibit) Refer to the exhibit. Which corrective action is t...; Question 142: Which function does the graceful restart feature allow a Cis...; Question 143: Which SCSI terminology is used to describe source and destin...; Question 144: Which four options are capabilities of the Cisco Nexus 5000 ...

[×]

Download PDF File

Enter your email address to download Cisco.300-165.v2018-08-15.q144.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 90/144

LEAVE A REPLY

Download PDF File