300-115 Exam Dumps | Which command creates a login authentication method named "login" that will primarily use RADIUS and

Home
Cisco
Implementing Cisco IP Switched Networks
Cisco.300-115.v2019-09-20.q120
Question 59

Valid 300-115 Dumps shared by EduDump.com for Helping Passing 300-115 Exam! EduDump.com now offer the newest 300-115 exam dumps, the EduDump.com 300-115 exam questions have been updated and answers have been corrected get the newest EduDump.com 300-115 dumps with Test Engine here:

Access 300-115 Dumps Premium Version
(162 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 59/120

Which command creates a login authentication method named "login" that will primarily use RADIUS and fail over to the local user database?

A. (config)# aaa authentication login login radius local

B. (config)# aaa authentication login default radius local

C. (config)# aaa authentication login default local radius

D. (config)# aaa authentication login radius local

Correct Answer: A

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (120q): Question 1: An engineer is configuring EtherChannel between two switches...; Question 2: In which EtherChannel mode does a port receive and respond t...; Question 3: Refer to the exhibit. Switch 15 is configured as the root sw...; Question 4: points of management for redundancy and improved support you...; Question 5: Which two features can you configure on an access port? (Cho...; Question 6: Which command correctly configures standby tracking for grou...; Question 7: Which statement is true when UDLD is configured on a link an...; Question 8: Refer to the exhibit. (Exhibit) Which two statements about t...; Question 9: After configuring new data VLANs 1020 through 1030 on the VT...; Question 10: You have been asked to install and configure a new switch in...; Question 11: Which database is used to determine the validity of an ARP p...; Question 12: Under which two conditions does Cisco StackWise Virtual tran...; Question 13: Which command enables root guard on a Cisco switch at locati...; Question 14: Refer to the exhibit. (Exhibit) An engineer has run the show...; Question 15: Refer to the exhibit. (Exhibit) BPDUGuard is enabled on both...; Question 16: Your customer has asked you to come in and verify the operat...; Question 17: Which two statements about Stack Wise are true? (Choose two)...; Question 18: Which command do you enter to troubleshoot a misconfigured E...; Question 19: Refer to the exhibit. (Exhibit) Which effect of this configu...; Question 20: Which statement about restrictions for multichassis LACP is ...; Question 21: You administer a network that uses two routers, R1 and R2, c...; Question 22: Under which two conditin does Cisco StackWise Virtual transm...; Question 23: After the recent upgrade of the switching infrastructure, th...; Question 24: When port security is configured on a switch, which violatio...; Question 25: What is the benefit of UDLD?; Question 26: Refer to the Exhibit: (Exhibit) Which two statements correct...; Question 27: Which two statements about SPAN source and destination ports...; Question 28: Which command configures an HSRP group to become a slave of ...; Question 29: Which two combinations of Ether Channel modes support the fo...; Question 30: Which security violation mode drops packets with unknown sou...; Question 31: Pilot testing of the new switching infrastructure finds that...; Question 32: Which two statements about GLBP are true? (Choose two.)...; Question 33: Which option lists the modes that are available for configur...; Question 34: Which two TLVs are included in Cisco Discovery Protocol adve...; Question 35: Refer to the exhibit. (Exhibit) A single server in Company A...; Question 36: After reviewing UDLD status on switch ports an engineer noti...; Question 37: Which two statements about STP path cost are true? (Choose t...; Question 38: Refer to the exhibit. (Exhibit) Which two statements about t...; Question 39: A network engineer must set the load balance method on an ex...; Question 40: Which of the following HSRP router states does an active rou...; Question 41: An enterprise network has port security sticky enabled on al...; Question 42: Which protocol will enable a group of routers to form a sing...; Question 43: The network monitoring application alerts a network engineer...; Question 44: Drag and drop the correct statements about HSRP from the lef...; Question 45: Refer to the exhibit. (Exhibit) Which two statement can be d...; 1 commentQuestion 46: (Exhibit) Refer to the exhibit. Which description of the eff...; Question 47: When a private VLAN is configured, which mode must be config...; Question 48: Refer to the exhibit. What is the result of setting GLBP wei...; Question 49: What are three possible router states of HSRP routers on a L...; Question 50: Which two statements about errdisable recovery are true? (Ch...; Question 51: Which feature do you implement so that a physical port enter...; Question 52: Which will identify the master switch in stack wise?...; Question 53: Which command maximizes system resources for ACL s'?...; Question 54: For security reasons, the IT manager has prohibited users fr...; Question 55: You have been tasked with configuring multilayer SwitchC, wh...; Question 56: A workstation technician moves a PC from one office desk to ...; Question 57: Refer to the exhibit. (Exhibit) The network switches for two...; 1 commentQuestion 58: Which statement about HSRP, GLBP, and VRRP is true?...; Question 59: Which command creates a login authentication method named "l...; 1 commentQuestion 60: Which two statements about LLDP are true? (Choose two.)...; Question 61: Which form of centralized device authentication allows each ...; Question 62: Which two statements about configuring VLANs on switches in ...; Question 63: Which command overrides the default priority of frames on an...; Question 64: If a switch stack is configured to use SDM templates, where ...; Question 65: Which statement about the default behavior of a Cisco switch...; Question 66: Which two statements about RADIUS are true? (Choose two)...; Question 67: Your manager asked you to make every port on your switch byp...; Question 68: After an EtherChannel is configured between two Cisco switch...; Question 69: While doing network discovery using Cisco Discovery Protocol...; Question 70: Which two commands display trunking information on one or mo...; Question 71: Which two statements about VRRP advertisements are true? (Ch...; Question 72: Which statement about VSPAN is true?...; Question 73: What effect does the mac address-table aging-time 180 comman...; Question 74: Which two statements are result of using the command spannin...; Question 75: An access switch at a remote location is connected to the sp...; Question 76: Which two statements about CDP are true? (Choose two.)...; Question 77: Which two restrictions of the port security feature are true...; Question 78: Which VTP mode is needed to configure an extended VLAN, when...; Question 79: Which AAA authorization type applies security policies on a ...; Question 80: The network manager has requested that several new VLANs (VL...; Question 81: Which option is a benefit of using VSS?...; Question 82: Which three functions does Dynamic ARP Inspection perform wi...; Question 83: Refer to the exhibit. (Exhibit) Which two statements about t...; Question 84: Which three statements are correct with regard to the IEEE 8...; Question 85: Which two statements about manually-configured LACP EtherCha...; Question 86: Which command configures VLAN 99 as an untagged VLAN on a tr...; Question 87: You have been asked to install and configure a new switch in...; Question 88: Which command maximizes system resources for ACLs?...; Question 89: Behavior of an access port when a tagged packet is received ...; Question 90: Which command configures an interface to accept LLDP packets...; Question 91: A network engineer configured a fault-tolerance link on Giga...; Question 92: Given the configuration on a switch interface, what happens ...; Question 93: Drag and drop the characteristic from the left to the matchi...; Question 94: For which reason would you configure RSPAN instead of SPAN o...; Question 95: Which two commands display the VLANs that are present in the...; Question 96: switch#show standby Virtual IP address is X.X.X.X Hello time...; Question 97: Which two statements about VTP are true? (Choose two.)...; Question 98: Which command enables you to determine whether any interface...; Question 99: What is the default amount by which the hot standby priority...; Question 100: (Exhibit) Refer to the exhibit. Which statement about the in...; Question 101: Which configuration do you apply to an interface so that a h...; Question 102: Which command displays the current SDM template?...; Question 103: In which two ways can a port respond to a port-security viol...; Question 104: Which option describes a limitation of LLDP?...; Question 105: How does SPAN interact with STP?...; Question 106: Which two differences between RADIUS and TACACS+ are true? (...; Question 107: If StormControl is enabled on a port and the traffic reaches...; Question 108: Which two commands display trunking information on one or mo...; Question 109: When you design a switched network using VTPv2, how many VLA...; Question 110: Refer to the exhibit. (Exhibit) How can the traffic that is ...; Question 111: A network engineer configures port security and 802.1x on th...; Question 112: What happens on a Cisco switch that runs Cisco IOS when an R...; Question 113: Which Cisco technology provides network redundancy by combin...; Question 114: What happens if you apply this command "vlan dot1q tag nativ...; Question 115: Which three characteristics of AAA with RADIUS are true? (Ch...; Question 116: Which benefit of StackWise is true?...; Question 117: A server with a statically assigned IP address is attached t...; Question 118: Which command do you enter to enable Dynamic ARP Inspection ...; Question 119: Which two statements apply to topology-based switching?...; Question 120: Which command enables PortFast and disables port channel on ...

[×]

Download PDF File

Enter your email address to download Cisco.300-115.v2019-09-20.q120.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 59/120

LEAVE A REPLY

Download PDF File