300-115 Exam Dumps | Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and

Home
Cisco
Implementing Cisco IP Switched Networks
Cisco.300-115.v2018-03-04.q139
Question 4

Valid 300-115 Dumps shared by EduDump.com for Helping Passing 300-115 Exam! EduDump.com now offer the newest 300-115 exam dumps, the EduDump.com 300-115 exam questions have been updated and answers have been corrected get the newest EduDump.com 300-115 dumps with Test Engine here:

Access 300-115 Dumps Premium Version
(162 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 4/139

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.
DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105

DSW2 - primary device for VLAN 103 and VLAN 104

A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its

status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.
Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.

All interfaces are active. DSW2 has not become the active device for the VLAN 103 HSRP group. As related to the VLAN 103 HSRP group, what can be done to make the group function properly?

A. On DSW1, disable preempt.

B. On DSW1, decrease the priority value to a value less than 190 and greater than 150.

C. On DSW2, increase the priority value to a value greater 200 and less than 250.

D. On DSW2, increase the decrement value in the track command to a value greater than 10 and less than 50.

Correct Answer: C

Explanation/Reference:
Explanation:
From the output shown below of the HSRP status of DSW2, we see that the active router has a priority of
200, while the local priority is 190. We need to increase the priority of DSW2 to greater than 200, but it should be less than 250 so that if the gig 1/0/1 interface goes down, DSW1 will become active. DSW2 is configured to decrement the priority by 50 if this interface goes down, so the correct answer is to increase the priority to more than 200, but less than 250.

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (139q): Question 1: Which two protocols can be automatically negotiated between ...; Question 2: In which portion of the frame is the 802.1q header found?...; Question 3: Which command globally enables AAA on a device?...; Question 4: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 5: When two MST instances (MST 1 and MST 2) are created on a sw...; Question 6: A manager tells the network engineer to permit only certain ...; Question 7: After the implementation of several different types of switc...; Question 8: A DHCP configured router is connected directly to a switch t...; Question 9: Which statement about restrictions for multichassis LACP is ...; Question 10: What is the maximum number of VLANs that can be assigned to ...; Question 11: After configuring new data VLANs 1020 through 1030 on the VT...; Question 12: You have been asked to install and configure a new switch in...; Question 13: Refer to the exhibit. (Exhibit) f1/0 and f1/1 have the same ...; Question 14: Which feature must be enabled to eliminate the broadcasting ...; Question 15: Which statement describes what happens if all VSL connection...; Question 16: Refer to the exhibit. (Exhibit) A network engineer wants to ...; Question 17: What is required for a LAN switch to support 802.1q Q-in-Q e...; Question 18: Which feature describes MAC addresses that are dynamically l...; Question 19: Refer to the exhibit. (Exhibit) Which option describes the r...; Question 20: Which authentication service is needed to configure 802.1x?...; Question 21: What is the maximum number of switches that can be stacked u...; Question 22: Refer to the exhibit. (Exhibit) A network engineer investiga...; Question 23: What is the default value for the errdisable recovery interv...; Question 24: After UDLD is implemented, a Network Administrator noticed t...; Question 25: What effect does the mac address-table aging-time 180 comman...; Question 26: When IP Source Guard with source IP filtering is enabled on ...; Question 27: A network engineer configured an Ethernet switch using these...; Question 28: Which portion of AAA looks at what a user has access to?...; Question 29: A network engineer configures port security and 802.1x on th...; Question 30: Scenario: You work for SWITCH.com. They have just added a ne...; Question 31: A Cisco Catalyst switch that is prone to reboots continues t...; Question 32: When you configure a private VLAN, which type of port must y...; Question 33: Which gateway role is responsible for answering ARP requests...; Question 34: Which VTP mode is needed to configure an extended VLAN, when...; Question 35: An EtherChannel bundle has been established between a Cisco ...; Question 36: Refer to the exhibit. (Exhibit) What is the result of the co...; Question 37: The network manager has requested that several new VLANs (VL...; Question 38: Which command configures an HSRP group to become a slave of ...; Question 39: A server with a statically assigned IP address is attached t...; Question 40: Which feature is automatically enabled when a voice VLAN is ...; Question 41: Refer to the exhibit. (Exhibit) Switch A, B, and C are trunk...; Question 42: After reviewing UDLD status on switch ports, an engineer not...; Question 43: Which statement describes what happens when a switch enters ...; Question 44: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 45: Refer to the exhibit. (Exhibit) Why would the switch be cons...; Question 46: Refer to the exhibit. (Exhibit) Which login credentials are ...; Question 47: For security reasons, the IT manager has prohibited users fr...; Question 48: After an EtherChannel is configured between two Cisco switch...; Question 49: Refer to the exhibit. (Exhibit) The network switches for two...; Question 50: Refer to the exhibit. (Exhibit) How many bytes are added to ...; Question 51: A network engineer wants to ensure Layer 2 isolation of cust...; Question 52: A network engineer configured a fault-tolerance link on Giga...; Question 53: For client server failover purposes, the application server ...; Question 54: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 55: Refer to the exhibit. (Exhibit) How can the traffic that is ...; Question 56: Which statement about the UDLD protocol is true?...; Question 57: Which option is a possible cause for an errdisabled interfac...; Question 58: What is the default interval at which Cisco devices send Cis...; Question 59: A network is running VTPv2. After verifying all VTP settings...; Question 60: Which command is needed to enable DHCP snooping if a switchp...; Question 61: Which private VLAN access port belongs to the primary VLAN a...; Question 62: Refer to the exhibit. (Exhibit) Switch A, B, and C are trunk...; Question 63: Refer to the exhibit. (Exhibit) When a network administrator...; Question 64: Which option lists the information that is contained in a Ci...; Question 65: Which statement about using native VLANs to carry untagged f...; Question 66: Which AAA Authorization type includes PPP, SLIP, and ARAP co...; Question 67: A network engineer is setting up a new switched network. The...; Question 68: What is the size of the VLAN field inside an 802.1q frame?...; Question 69: A network engineer must adjust the STP interface attributes ...; Question 70: What happens on a Cisco switch that runs Cisco IOS when an R...; Question 71: Which type of information does the DHCP snooping binding dat...; Question 72: A network engineer changed the port speed and duplex setting...; Question 73: Refer to the exhibit. (Exhibit) Users of PC-1 experience slo...; Question 74: The command storm-control broadcast level 75 65 is configure...; Question 75: Which statement describes what happens when a port configure...; Question 76: While troubleshooting a network outage, a network engineer d...; Question 77: On which interface can port security be configured?...; Question 78: Which configuration command ties the router hot standby prio...; Question 79: Refer to the exhibit. (Exhibit) All ports are members of VLA...; Question 80: DHCP snooping and IP Source Guard have been configured on a ...; Question 81: A network engineer wants to add a new switch to an existing ...; Question 82: Which command would a network engineer apply to error-disabl...; Question 83: Which statement about the use of SDM templates in a Cisco sw...; Question 84: Refer to the exhibit. (Exhibit) Which statement about switch...; Question 85: What is the default amount by which the hot standby priority...; Question 86: Which statement about the use of PAgP link aggregation on a ...; Question 87: A network engineer tries to configure storm control on an Et...; Question 88: You have been asked to install and configure a new switch in...; Question 89: After the recent upgrade of the switching infrastructure, th...; Question 90: Your customer has asked you to come in and verify the operat...; Question 91: An administrator recently configured all ports for rapid tra...; Question 92: Refer to the exhibit. (Exhibit) Which EtherChannel negotiati...; Question 93: Which command does a network engineer use to verify the span...; Question 94: Which VLAN range is eligible to be pruned when a network eng...; Question 95: Which switch feature prevents traffic on a LAN from being ov...; Question 96: Your customer has asked you to come in and verify the operat...; Question 97: What is the maximum number of 10 Gigabit Ethernet connection...; Question 98: A network engineer deployed a switch that operates the LAN b...; Question 99: After port security is deployed throughout an enterprise cam...; Question 100: Interface FastEthernet0/1 is configured as a trunk interface...; Question 101: When you configure private VLANs on a switch, which port typ...; Question 102: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 103: Which technique automatically limits VLAN traffic to only th...; Question 104: A switch is added into the production network to increase po...; Question 105: SWITCH.com is an IT company that has an existing enterprise ...; Question 106: A network engineer is trying to deploy a PC on a network. Th...; Question 107: Which SDM template is the most appropriate for a Layer 2 swi...; Question 108: What is the default HSRP priority?...; Question 109: Which command creates a login authentication method named "l...; Question 110: What is the maximum number of virtual MAC addresses that GLB...; Question 111: Which First Hop Redundancy Protocol is an IEEE Standard?...; Question 112: Which statement about using EtherChannel on Cisco IOS switch...; Question 113: Which technique allows specific VLANs to be strictly permitt...; Question 114: Which action allows a network engineer to limit a default VL...; Question 115: SIMULATION SWITCH.com is an IT company that has an existing ...; Question 116: An access switch has been configured with an EtherChannel po...; Question 117: A network engineer notices inconsistent Cisco Discovery Prot...; Question 118: Which option lists the modes that are available for configur...; Question 119: Which statement about LLDP-MED is true?...; Question 120: A network engineer has just deployed a non-Cisco device in t...; Question 121: Which statement about Cisco Discovery Protocol configuration...; Question 122: Which statement about Cisco devices learning about each othe...; Question 123: Which SDM template disables routing and supports the maximum...; Question 124: Refer to the exhibit. (Exhibit) The users in an engineering ...; Question 125: After implementing VTP, the extended VLANs are not being pro...; Question 126: If a network engineer applies the command mac-address-table ...; Question 127: What does the command vlan dot1q tag native accomplish when ...; Question 128: Which private VLAN can have only one VLAN and be a secondary...; Question 129: Which command correctly configures standby tracking for grou...; Question 130: Refer to the exhibit. (Exhibit) A multilayer switch has been...; Question 131: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 132: A new network that consists of several switches has been con...; Question 133: When you design a switched network using VTPv2, how many VLA...; Question 134: A network engineer must set the load balance method on an ex...; Question 135: Several new switches have been added to the existing network...; Question 136: What is the function of NSF?; Question 137: Your customer has asked you to come in and verify the operat...; Question 138: Ferris Plastics, Inc. is a medium sized company, with an ent...; Question 139: In a Cisco switch, what is the default period of time after ...

[×]

Download PDF File

Enter your email address to download Cisco.300-115.v2018-03-04.q139.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 4/139

LEAVE A REPLY

Download PDF File