200-310 Exam Dumps | What will extend a trust boundary (there is switch interface configuration with separate voice VLAN and

Valid 200-310 Dumps shared by ExamDiscuss.com for Helping Passing 200-310 Exam! ExamDiscuss.com now offer the newest 200-310 exam dumps, the ExamDiscuss.com 200-310 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-310 dumps with Test Engine here:

Access 200-310 Dumps Premium Version
(392 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 171/192

What will extend a trust boundary (there is switch interface configuration with separate voice VLAN and data VLAN configured where the phone is connected to, also small diagram showing endpoint (host), IP Phone, Access Switch, Distribution Switch, Core Switch and Data Centre Aggregation switch)?

A. Distribution Switch

B. IP Phone

C. Access Switch

D. Core Switch

E. Multiple layers PC

Question List (192q): Question 1: Which tool captures network traffic, decodes the protocols i...; Question 2: In which phase of cisco design life cycle the validation of ...; Question 3: High availability is required for a critical remote office o...; Question 4: Refer to the exhibit. (Exhibit) A design engineer has four a...; Question 5: What IPv4 addressing technique is used for proper address pl...; Question 6: Which route source has a lower administrative cost than BGP?...; Question 7: What IP address is used for broadcast for 120.20.78.8/30?...; Question 8: Which statement correctly describes queuing in environments ...; Question 9: Which two features are benefits of a modular network design"...; Question 10: Which three Cisco technologies can you use to detect and mit...; Question 11: Which option is an advantage of a Layer 3 access model over ...; Question 12: Which option is an example of physical device virtualization...; Question 13: which options characterizes normal traffic flow and performa...; Question 14: A startup company wants to deploy the Cisco IP Telephony sol...; Question 15: An engineer is designing a solution for a client that has a ...; Question 16: In an enterprise Layer 2 switched network, which protocol mu...; Question 17: Which WAN technology is a cost-effective method to deliver 1...; Question 18: Which Cisco tool provides network accounting, monitoring, an...; Question 19: Which feature must be configured on a switch port that conne...; Question 20: Which two are types of network virtualization? (Choose two.)...; Question 21: A corporation has asked for a new design of a branch office ...; Question 22: Which type of area should you use in an enterprise OSPF depl...; Question 23: Which Layer in the Cisco Enterprise Archetecture model is hi...; Question 24: A network engineer must collect application-level informatio...; Question 25: An engineer wants to ensure that the Spanning Tree topology ...; Question 26: Which statement about VSS is true?...; Question 27: Refer to the exhibit. (Exhibit) Where should routes in the r...; Question 28: Which command is correct for creating a virtual interface on...; Question 29: An organization is deciding what routing protocol to use thr...; Question 30: What phase of Cisco's PPDIOO is the final test of the approp...; Question 31: Which technology combines two Nexus switches to form a singl...; Question 32: An engineer must design a new data center network and must r...; Question 33: Which is part of the Prepare phase of PPDIOO?...; Question 34: Drag and drop the network virtualization features from the l...; Question 35: What two components are used when creating an endpoint's mod...; Question 36: Which technology does an engineer use to classify applicatio...; Question 37: A network engineer must collect application-level informatio...; Question 38: Which Cisco Wireless LAN Controller interface is used for ou...; Question 39: Traditionally, the DMZ exist between which two locations? (C...; Question 40: A network engineer is tasked with summarizing the routes to ...; Question 41: Which network layer is the best fit for security features su...; Question 42: Drag the spanning-tree protocol on the left to the recommend...; Question 43: Which two methods can Cisco routers and switches use to shar...; Question 44: Which design enables easy and flexible scaling in the Cisco ...; Question 45: Which two design criteria require VLANs in a proposed soluti...; Question 46: What is the technology that allows you to combine more than ...; Question 47: Which two techniques can you use to reduce the size of a net...; Question 48: Which first-hop redundancy protocol dynamically distributes ...; Question 49: Which two statements are true regarding a hierarchical netwo...; Question 50: Which network element must be summarized in a multiarea OSPF...; Question 51: What are two industry drivers that promote network virtualiz...; Question 52: Which two types of files are the most common used in APIs fo...; Question 53: Refer to the exhibit. (Exhibit) A standard Layer 2 campus ne...; Question 54: Which two options are features offered by NetFlow? (Choose t...; Question 55: Which technology allow multiple instances of a routing table...; Question 56: A customer is deploying a centralized communications infrast...; Question 57: What three design best practices are key functions of the di...; Question 58: Which two Cisco data center devices can participate in Cisco...; Question 59: In which two modes can you deploy Cisco IPS appliances? (Cho...; Question 60: For a VLAN that requires 60 hosts, which subnet is the most ...; Question 61: For which type of topology are modern fast-converging routin...; Question 62: Which statement is true about using a DNS server to discover...; Question 63: You want to gather as much detail as possible during a netwo...; Question 64: What two addresses are defined under RFC 1918? (Choose two.)...; Question 65: Which three series of Cisco wireless controllers support wir...; Question 66: Which two characteristics are advantages of the top-down app...; Question 67: What design requirement is necessary for campus network acce...; Question 68: Which three options are examples of network logical virtuali...; Question 69: Which IP address can be routed to cross the public Internet?...; Question 70: An organization must decide which routing protocol to use th...; Question 71: Refer to the exhibit. (Exhibit) Which functionality must be ...; Question 72: In an EAP-enabled WLAN, which component sends the EAP identi...; Question 73: Which layer of the OSI model when included in the access lay...; Question 74: An organization needs to implement isolated logical structur...; Question 75: Refer to the exhibit . (Exhibit) This customer network desig...; Question 76: An engineer is designing a disaster recovery solution to avo...; Question 77: According to fundamental design principles, which location i...; Question 78: Which interior routing protocol has the most preferable admi...; Question 79: Cisco Unified Wireless networks support two campus design mo...; Question 80: Why would an engineer implement variable-length subnet masks...; Question 81: Which three functions of a wireless LAN controller in an ent...; Question 82: Drag the characteristic on the left to the correct campus de...; Question 83: A large company requests a hierarchical design model. What t...; Question 84: When considering the three VoIP design models - single site,...; Question 85: In which operation mode does the AP act as a dedicated senso...; Question 86: A routing protocol neighbor relationship has been establishe...; Question 87: Which feature is improved by utilizing network modularity wh...; Question 88: A network engineer has been asked to follow a top down desig...; Question 89: You design a network with the following network addresses: 1...; Question 90: An engineer must build an enterprise network that can operat...; Question 91: Refer to the exhibit. (Exhibit) A standard, Layer 2 campus n...; Question 92: The network infrastructure of a building is being expanded, ...; Question 93: A remote worker for a sales company must submit daily update...; Question 94: Which option is a benefit of Cisco Discovery Protocol?...; Question 95: What are two important aspects to consider when looking at b...; Question 96: What is the key limitation of using Internet circuits as a b...; Question 97: Which option is used by OSPF to reduce the flooding domain o...; Question 98: Which routing protocol provides the fastest convergence and ...; Question 99: Which two design decisions can improve network resiliency? (...; Question 100: A network engineer is tasked to upgrade and expand a large e...; Question 101: What information should be utilized to identify network appl...; Question 102: Based on best practices which QoS profile should be configur...; Question 103: What are two advantages of a modular design (Choose two)?...; Question 104: You are deploying IP Telephony over a WAN. What will be the ...; Question 105: While analyzing the network addressing scheme for an organiz...; Question 106: Which two considerations are important when designing an IP ...; Question 107: Traditionally, the DMZ exists between which two locations? (...; Question 108: Cisco Identity-Based Networking Services relies heavily on t...; Question 109: Consider the reservation of IP Addressing what mask you will...; Question 110: A network architect working for a larger financial instituti...; Question 111: What is the maximum RIPv2 hop count for a reachable route?...; Question 112: Which two states are RSTP port states? (Choose two.)...; Question 113: Drag the descriptions on the left to the matching design cat...; Question 114: Which two activities are included in the Plan phase of the C...; Question 115: Which option is an advantage of the bottom-up design model?...; Question 116: Cisco FabricPath brings the benefits of routing protocols to...; Question 117: What are two advantages of employing scalability when design...; Question 118: While designing a campus access layer, a network engineer is...; Question 119: Refer to the exhibit. (Exhibit) Which three OSPF routers are...; Question 120: Which two Cisco products can be used in a data center to sup...; Question 121: An engineer wants to transport Layer 2 packets over an MPLS-...; Question 122: Drag the technology on the left to the matching routing prot...; Question 123: A data center is being deployed, and one design requirement ...; Question 124: What three primary sources of information are needed to perf...; Question 125: Which advantage to using route summarization is true?...; Question 126: An engineer is designing a new modular network topoiogy. Wha...; Question 127: Which one of the following represent correct IPv6 Global Uni...; Question 128: In Cisco ACI, which option is the unified point of automatio...; Question 129: Refer to the exhibit. (Exhibit) Assuming that a network will...; Question 130: What are two benefits of the bottom-up design approach? (Cho...; Question 131: What are two benefits of a structured IPv4 addressing scheme...; Question 132: In which phase of PPDIOO are the network requirements identi...; Question 133: Which one of the following is "synchronous link" design?...; Question 134: Which statement describes an advantage of the Layer 2 access...; Question 135: Which two methods are used to reduce the mesh links required...; Question 136: Which tow network services should you host on the DMZ ? (Cho...; Question 137: Which two options best describe the top-down design approach...; Question 138: A network engineer requires that an OSPF ASBR must only floo...; Question 139: A network engineer must connect two sites. Each site has a d...; Question 140: What phase of Cisco's PPDIOO includes the identification and...; Question 141: Which Cisco device management feature is most suited to mete...; Question 142: Which option is a benefit of Cisco Discovery Protocol?...; Question 143: Which subnet mask should you use on point-to-point links to ...; Question 144: An engineer wants to find all of the objects of a certain ty...; Question 145: Which feature do you use to identify which network nodes exc...; Question 146: What should be considered when scaling EIGRP (Choose three)?...; Question 147: A spanning tree topology can be simplified by deploying what...; Question 148: Which option is a benefit of the modular approach to network...; Question 149: Multicast has been enabled and configured in the Enterprise,...; Question 150: A design engineer must send management information messages ...; Question 151: OSPF will be used as the IGP within a campus network. Which ...; Question 152: which QoS level should VOIPset be configured on WLC ?...; Question 153: Which protocol is used for voice bearer traffic?...; Question 154: Which protocol is used to reserve bandwidth for the transpor...; Question 155: Refer to the exhibit. (Exhibit) An engineer is upgrading a c...; Question 156: Which application provides AAA service for cisco devices?...; Question 157: Which design is the recommended geometric design for routed ...; Question 158: Which issue is a possible result of using the bottom-up appr...; Question 159: Refer to the exhibit. (Exhibit) Which action can be taken in...; Question 160: A network engineer must connect two sites. Each site has a d...; Question 161: Refer to the exhibit. (Exhibit) The red lines refer to STP b...; Question 162: Which statement describes the recommended deployment of DNS ...; Question 163: A company is implementing an Identity Management solution wi...; Question 164: Which two network services should you host on the DMZ? (Choo...; Question 165: What occurs to traffic when a Cisco APIC is removed from the...; Question 166: Which VPN tunneling technology supports IP multicast?...; Question 167: Which two protocols are classful routing protocols? (Choose ...; Question 168: Which statement about using VSS on a pair of switches is tru...; Question 169: (Exhibit) Refer to the exhibit. Which two functions are appr...; Question 170: Two companies that want to connect with multiple providers v...; Question 171: What will extend a trust boundary (there is switch interface...; Question 172: Which technology can help prevent attacks from the Internet ...; Question 173: What tool would you use to capture, segregate and analyse IP...; Question 174: Which two mechanisms are used by distance vector protocols t...; Question 175: Drag the STP toolkit term on the left to the definition on t...; Question 176: Which statement about modular network design is true?...; Question 177: Which two benefits are realized by establishing virtualizati...; Question 178: What is a benefit of IPv6 over IPv4 addresses?...; Question 179: A network design engineer is seeking a dynamic routing proto...; Question 180: What network technology consolidates network and storage tra...; Question 181: How does the use of multiple areas in a link state routing p...; Question 182: Your company uses OSPF for internal routing. The company wil...; Question 183: A network engineer has finished designing and implementing a...; Question 184: Which option can hinder efficient IP address allocation?...; Question 185: What are two components of the Build phase in the Cisco Desi...; Question 186: An organization needs a WAN Transport technology that meets ...; Question 187: A remote user for a company must periodically connect to the...; Question 188: A network engineer requires that an OSPF ASBR must only floo...; Question 189: Which Cisco tool can prevent attacks from malware, viruses, ...; Question 190: What is a benefit of deploying Cisco IPS devices in inline m...; Question 191: The spanning tree topology can be simplified by deploying wh...; Question 192: Refer to the exhibit. (Exhibit) In this suboptimal design of...

Question 171/192

LEAVE A REPLY

Download PDF File