200-310 Exam Dumps | What is the acceptable amount of one-way network delay for voice and video applications?

Home
Cisco
Designing for Cisco Internetwork Solutions
Cisco.200-310.v2019-11-25.q100
Question 72

Valid 200-310 Dumps shared by ExamDiscuss.com for Helping Passing 200-310 Exam! ExamDiscuss.com now offer the newest 200-310 exam dumps, the ExamDiscuss.com 200-310 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-310 dumps with Test Engine here:

Access 200-310 Dumps Premium Version
(392 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 72/100

What is the acceptable amount of one-way network delay for voice and video applications?

A. 300 bytes

B. 1 sec

C. 150 ms

D. 500 ms

Correct Answer: C

Explanation
Delay Components in VoIP Networks
The ITU's G.I 14 recommendation specifics that the one-way delay between endpoints should not exceed 150 ms to be acceptable, commercial voice quality. In private networks, somewhat longer delays might be acceptable for economic reasons. The ITU G.114 recommendation specifics that 151-ms to 400-ms one-way delay might be acceptable provided that organizations are aware that the transmission time will affect the quality of user applications. One-way delays of above 400 ms are unacceptable for general network planning purposes.

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (100q): Question 1: Which statement describes the methodology that supports the ...; Question 2: Which interior routing protocol has the most preferable admi...; Question 3: What two design best practices are key functions of the dist...; Question 4: GRE has been used to establish a routing-protocol neighbor r...; Question 5: Which option is an example of a fixed two-level hierarchical...; Question 6: Which is part of the Prepare phase of PPDIOO?...; Question 7: According to fundamental design principles, which location i...; Question 8: Refer to the exhibit. (Exhibit) Which component do you use t...; Question 9: Which IP address can be routed to cross the public Internet?...; Question 10: Which two connector actions are important when designing the...; Question 11: What IPv4 addressing technique is used for proper address pl...; Question 12: An engineer wants to transport Layer 2 packets over an MPLS-...; Question 13: An enterprise campus module is typically made up of four sub...; Question 14: What is a benefit of IPv6 over IPv4 addresses?...; Question 15: What are two components of the Build phase in the Cisco Desi...; Question 16: What tool would you use to decode protocols?...; Question 17: Which design is the recommended geometric design for routed ...; Question 18: Refer to the exhibit. (Exhibit) Assuming that a network will...; Question 19: Which tow network services should you host on the DMZ ? (Cho...; Question 20: A network engineer needs to create a controller-based, high-...; Question 21: Which two characteristics are advantages of the top-down app...; Question 22: An organization needs a WAN Transport technology that meets ...; Question 23: Which feature is improved by utilizing network modularity wh...; Question 24: Which option is a benefit of Cisco Discovery Protocol?...; Question 25: When there is a need for immunity to EMI for connecting loca...; Question 26: Traditionally, the DMZ exist between which two locations? (C...; Question 27: You want to gather as much detail as possible during a netwo...; Question 28: A spanning tree topology can be simplified by deploying what...; Question 29: Which protocol is used to reserve bandwidth for the transpor...; Question 30: A network engineer has finished designing and implementing a...; Question 31: From which DNS record can a Cisco wireless AP, running Cisco...; Question 32: A remote user for a company must periodically connect to the...; Question 33: Which Cisco device management feature is most suited to mete...; Question 34: Which two benefits are realized by establishing virtualizati...; Question 35: Drag the characteristic on the left to the correct campus de...; Question 36: A network engineer is tasked to upgrade and expand a large e...; Question 37: In Cisco ACI, which option is the unified point of automatio...; Question 38: Between what two modules DMZ should be located? (Choose two)...; Question 39: Company ABC has intermittent problems registering site IP ph...; Question 40: What are two benefits of the bottom-up design approach? (Cho...; Question 41: While preparing an overview of Internet facing DMZ for a cus...; Question 42: What statement about EVN is true?...; Question 43: Which network virtualization technique can you implement wit...; Question 44: Which statement about modular network design is true?...; Question 45: Which two network services should you host on the DMZ? (Choo...; Question 46: Which two options should be considered when designing an OSP...; Question 47: Which IPv6 feature enables routing to distribute connection ...; Question 48: What information should be utilized to identify network appl...; Question 49: In which two modes can you deploy Cisco IPS appliances? (Cho...; Question 50: While designing a campus access layer, a network engineer is...; Question 51: Drag and drop the phases of the lifecycle of a standard netw...; Question 52: How many switches can be combined into a single network elem...; Question 53: Refer to the exhibit . (Exhibit) This customer network desig...; Question 54: Which two routing protocols converge most quickly? (Choose t...; Question 55: Refer to the exhibit. (Exhibit) Which action can be taken in...; Question 56: Refer to the exhibit. (Exhibit) A design engineer has four a...; Question 57: An engineer must design a new data center network and must r...; Question 58: Directory services and electronic messaging are performed at...; Question 59: When designing changes to an existing network which tow opti...; Question 60: What are two benefits of a structured IPv4 addressing scheme...; Question 61: When designing changes to an existing network, which two opt...; Question 62: A network engineer requires that an OSPF ASBR must only floo...; Question 63: Which two of these are scalability benefits of designing a n...; Question 64: Which feature enables the VRRP-enabled router to regain the ...; Question 65: Which key feature does a modular design approach provide?...; Question 66: A network engineer must connect two sites. Each site has a d...; Question 67: Which three Cisco technologies can you use to detect and mit...; Question 68: Which network size can provide six /25 subnets while wasting...; Question 69: A network design engineer is seeking a dynamic routing proto...; Question 70: Drag the technology on the left to the matching routing prot...; Question 71: Which two techniques can you use to reduce the size of a net...; Question 72: What is the acceptable amount of one-way network delay for v...; Question 73: Which statement about using VSS on a pair of switches is tru...; Question 74: Which two processes are included in the Build phase of the C...; Question 75: When integrating services with Cisco ACI Service Graphs, whi...; Question 76: An engineer is designing an OSPF infrastructure for an organ...; Question 77: Which two types of files are the most common used in APIs fo...; Question 78: Which two major campus design models does the cisco unified ...; Question 79: Which statement is true concerning the data center distribut...; Question 80: Traditionally, the DMZ exists between which two locations? (...; Question 81: What is the primary consideration when choosing a routed net...; Question 82: A company is implementing an Identity Management solution wi...; Question 83: Which technology combines two Nexus switches to form a singl...; Question 84: Which statement about VSS is true?...; Question 85: Refer to the exhibit. (Exhibit) A standard Layer 2 campus ne...; Question 86: Which HSRP parameters must match, to ensure proper functiona...; Question 87: Which two options should be used to achieve fast convergence...; Question 88: Which two features are benefits of a modular network design"...; Question 89: Which technology can help prevent attacks from the Internet ...; Question 90: An engineer is designing a solution for a client that has a ...; Question 91: Which option best describes the high-level design document?...; Question 92: Which address is the broadcast address of subnet 120.20.78.8...; Question 93: Which option is an advantage of the bottom-up design model?...; Question 94: An engineer wants to ensure that the Spanning Tree topology ...; Question 95: Drag the term on the left to the matching deployment scenari...; Question 96: Which two statements about designing the Data Center Access ...; Question 97: Which one of the following represent correct IPv6 Global Uni...; Question 98: Which option is an example of physical device virtualization...; Question 99: Which Cisco security mechanism has the attributes listed bel...; Question 100: While designing the LAN core to distribution infrastructure ...

[×]

Download PDF File

Enter your email address to download Cisco.200-310.v2019-11-25.q100.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 72/100

LEAVE A REPLY

Download PDF File