Valid 200-301 Dumps shared by ExamDiscuss.com for Helping Passing 200-301 Exam! ExamDiscuss.com now offer the newest 200-301 exam dumps, the ExamDiscuss.com 200-301 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-301 dumps with Test Engine here:

Access 200-301 Dumps Premium Version
(1237 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 60/68

A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (68q)
Question 1: What is a DHCP client?
Question 2: Drag and drop the descriptions of AAA services from the left...
Question 3: Refer to the exhibit. (Exhibit) Router R1 is running three d...
Question 4: Which QoS queuing method discards or marks packets that exce...
Question 5: Which protocol requires authentication to transfer a backup ...
Question 6: Refer to the exhibit. (Exhibit) What commands are needed to ...
Question 7: An administrator must use the password complexity not manufa...
Question 8: What is a zero-day exploit?
Question 9: Refer to the exhibit. (Exhibit) R5 is the current DR on the ...
Question 10: Refer to the exhibit. (Exhibit) Which change to the configur...
Question 11: Which protocol prompts the Wireless LAN Controller to genera...
Question 12: An engineer must configure a WLAN using the strongest encryp...
Question 13: An engineer is configuring SSH version 2 exclusively on the ...
Question 14: Refer to the exhibit. (Exhibit) Router R1 resides in OSPF Ar...
Question 15: An office has 8 floors with approximately 30-40 users per fl...
Question 16: Drag the descriptions of device management from the left ont...
Question 17: An engineer is tasked to configure a switch with port securi...
Question 18: Which QoS queuing method discards or marks packets that exce...
Question 19: What is the function of "off-the-shell" switches in a contro...
Question 20: An engineer requires a switch interface to actively attempt ...
Question 21: Configure IPv4 and IPv6 connectivity between two routers. Fo...
Question 22: An engineer configured an OSPF neighbor as a designated rout...
Question 23: Refer to the exhibit. (Exhibit) What are the two steps an en...
Question 24: Refer to the exhibit. (Exhibit) How does router R1 handle tr...
Question 25: Drag and drop the descriptions from the left onto the config...
Question 26: Refer to the exhibit. (Exhibit) IP connectivity between the ...
Question 27: Refer to the exhibit. (Exhibit) An engineer has started to c...
Question 28: R1 as an NTP server must have: * NTP authentication enabled ...
Question 29: A port security violation has occurred on a switch port due ...
Question 30: Refer to the exhibit. (Exhibit) If R1 receives a packet dest...
Question 31: A network engineer is configuring a switch so that it is rem...
Question 32: Connectivity between three routers has been established, and...
Question 33: Refer to the exhibit. (Exhibit) An engineer is bringing up a...
Question 34: Refer to the exhibit. (Exhibit) Packets received by the rout...
Question 35: Which port type supports the spanning-tree portfast command ...
Question 36: Refer to the exhibit. (Exhibit) If OSPF Is running on this n...
Question 37: What is a function of Cisco Advanced Malware Protection for ...
Question 38: Which networking function occurs on the data plane?...
Question 39: Which WPA3 enhancement protects against hackers viewing traf...
Question 40: Refer to the exhibit. (Exhibit) Load-balanced traffic is com...
Question 41: Refer to the exhibit. (Exhibit) Which action is expected fro...
Question 42: Refer to the exhibit. (Exhibit) The New York router is confi...
Question 43: R1 has learned route 10.10.10.0/24 via numerous routing prot...
Question 44: Refer to Exhibit. (Exhibit) Which configuration must be appl...
Question 45: Which type of traffic Is sent with pure iPsec?...
Question 46: Refer to the exhibit. (Exhibit) A company is configuring a f...
Question 47: Drag and drop the QoS terms from the left onto the descripti...
Question 48: Refer to the exhibit. (Exhibit) Refer to the exhibit. Each r...
Question 49: Refer to the exhibit. (Exhibit) IP connectivity and OSPF are...
Question 50: Refer to the exhibit. (Exhibit) When PC-A sends traffic to P...
Question 51: Which two events occur automatically when a device Is added ...
Question 52: Refer to the exhibit. (Exhibit) An administrator is tasked w...
Question 53: What is a requirement when configuring or removing LAG on a ...
Question 54: Refer to the exhibit. (Exhibit) An engineer built a new L2 L...
Question 55: Drag and drop the IPv6 address details from the left onto th...
Question 56: An engineer is configuring data and voice services to pass t...
Question 57: Refer to the exhibit. (Exhibit) Refer to the exhibit Routers...
Question 58: A network engineer must create a diagram of a multivendor ne...
Question 59: Refer to the exhibit. (Exhibit) How does the router manage t...
Question 60: A user configured OSPF in a single area between two routers ...
Question 61: Refer to the exhibit. (Exhibit) Between which zones do wirel...
Question 62: In which two ways does a password manager reduce the chance ...
Question 63: Which function does the range of private IPv4 addresses perf...
Question 64: Drag and drop the facts about wireless architectures from th...
Question 65: All physical cabling between the two switches is installed. ...
Question 66: Which interface mode must be configured to connect the light...
Question 67: What are two benefits of FHRPs? (Choose two.)...
Question 68: Refer to the exhibit. (Exhibit) What does router R1 use as i...