Valid 200-301 Dumps shared by ExamDiscuss.com for Helping Passing 200-301 Exam! ExamDiscuss.com now offer the newest 200-301 exam dumps, the ExamDiscuss.com 200-301 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-301 dumps with Test Engine here:

Access 200-301 Dumps Premium Version
(1237 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 65/124

While examining excessive traffic on the network, it is noted that all incoming packets on an interface appear to be allowed even though an IPv4 ACL is applied to the interface.
Which two misconfigurations cause this behavior? (Choose two)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (124q)
Question 1: Which two must be met before SSH can operate normally on a C...
Question 2: What does an SDN controller use as a communication protocol ...
Question 3: What is the default behavior of a Layer 2 switch when a fram...
Question 4: Which two command sequences must you configure on switch to ...
Question 5: Which technology must be implemented to configure network de...
Question 6: Refer to the exhibit. (Exhibit) An engineer must configure G...
Question 7: In which situation is private IPv4 addressing appropriate fo...
Question 8: What event has occurred if a router sends a notice level mes...
Question 9: What are two roles of the Dynamic Host Configuration Protoco...
Question 10: Using direct sequence spread spectrum, which three 2.4-GHz c...
Question 11: What are two descriptions of three-tier network topologies? ...
Question 12: A corporate office uses four floors in a building * Floor 1 ...
Question 13: Refer to Exhibit. (Exhibit) The loopback1 interface of the A...
Question 14: Refer to the exhibit. (Exhibit) A network administrator has ...
Question 15: Which protocol does an IPv4 host use to obtain a dynamically...
Question 16: What software defined architecture plane assists network dev...
Question 17: Drag and drop the application protocols from the left onto t...
Question 18: An engineer must configure the IPv6 address 2001:0db8:0000:0...
Question 19: Which design element is a best practice when deploying an 80...
Question 20: Which technology is used to improve web traffic performance ...
Question 21: Which implementation provides the strongest encryption combi...
Question 22: Which two WAN architecture options help a business scalabili...
Question 23: A network administrator needs to aggregate 4 ports into a si...
Question 24: A wireless administrator has configured a WLAN; however, the...
Question 25: Which two actions are performed by the Weighted Random Early...
Question 26: A network engineer must back up 20 network router configurat...
Question 27: Refer to the exhibit. An engineer must add a subnet for a ne...
Question 28: Which network plane is centralized and manages routing decis...
Question 29: Which IPv6 address type provides communication between subne...
Question 30: Refer to the exhibit. (Exhibit) which path is used by the ro...
Question 31: What protocol allows an engineer to back up 20 network route...
Question 32: Which command must be entered to configure a DHCP relay?...
Question 33: Refer to the exhibit. (Exhibit) Which switch becomes the roo...
1 commentQuestion 34: Which device controls the forwarding of authentication reque...
Question 35: Which 802.11 frame type is association response?...
Question 36: Which resource is able to be shared among virtual machines d...
Question 37: Which two minimum parameters must be configured on an active...
Question 38: Which 802.11 frame type is indicated by a probe response aft...
Question 39: What is a network appliance that checks the state of a packe...
Question 40: Refer to the exhibit. (Exhibit) What two conclusions should ...
Question 41: What is the primary effect of the spanning-tree portfast com...
Question 42: Which condition must be met before an NMS handles an SNMP tr...
Question 43: An engineer is configuring NAT to translate the source subne...
Question 44: Refer to the exhibit. (Exhibit) Which route type does the ro...
Question 45: Refer to the exhibit. (Exhibit) Which command configures a f...
Question 46: Which command prevents passwords from being stored in the co...
Question 47: Several new coverage cells are required to improve the Wi-Fi...
Question 48: How does a Cisco Unified Wireless network respond to Wi-Fi c...
Question 49: What is recommended for the wireless infrastructure design o...
1 commentQuestion 50: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 51: Refer to the exhibit. (Exhibit) Which outcome is expected wh...
Question 52: Drag the descriptions of device management from the left ont...
Question 53: Refer to the exhibit. (Exhibit) An engineer is required to v...
Question 54: What is the maximum bandwidth of a T1 point-to-point connect...
Question 55: An engineering team asks an implementer to configure syslog ...
Question 56: What are two differences between optical-fiber cabling and c...
Question 57: Where does the configuration reside when a helper address Is...
Question 58: What is the primary different between AAA authentication and...
Question 59: Refer to the exhibit. (Exhibit) An engineer configured NAT t...
Question 60: Refer to the exhibit. (Exhibit) What action establishes the ...
Question 61: What does a router do when configured with the default DNS l...
Question 62: What is the primary purpose of a First Hop Redundancy Protoc...
Question 63: Refer to the exhibit. (Exhibit) A router reserved these five...
Question 64: What is a function of Wireless LAN Controller?...
Question 65: While examining excessive traffic on the network, it is note...
Question 66: Router A learns the same route from two different neighbors,...
Question 67: A network engineer must create a diagram of a multivendor ne...
Question 68: What is an appropriate use for private IPv4 addressing?...
Question 69: A Cisco IP phone receive untagged data traffic from an attac...
Question 70: A device detects two stations transmitting frames at the sam...
Question 71: Which security program element involves installing badge rea...
Question 72: A network engineer must configure the router R1 GigabitEther...
Question 73: Refer to the exhibit. (Exhibit) The nip server 192.168.0.3 c...
Question 74: What is a difference between RADIUS and TACACS+?...
Question 75: Which function does the range of private IPv4 addresses perf...
Question 76: What is a characteristic of private IPv4 addressing?...
Question 77: Refer to the Exhibit. (Exhibit) After the switch configurati...
Question 78: What makes Cisco DNA Center different from traditional netwo...
Question 79: Which goal is achieved by the implementation of private IPv4...
Question 80: Refer to the exhibit. (Exhibit) Which command must be execut...
Question 81: Which command automatically generates an IPv6 address from a...
Question 82: Refer to the exhibit. (Exhibit) If configuring a static defa...
Question 83: Which type of wireless encryption is used for WPA2 in presha...
Question 84: When deploying syslog, which severity level logs information...
Question 85: Refer to the exhibit. (Exhibit) PC1 is trying to ping PC3 fo...
Question 86: Refer to the exhibit. (Exhibit) Which type of route does R1 ...
Question 87: What does a switch use to build its MAC address table?...
Question 88: Which technology can prevent client devices from arbitrarily...
Question 89: Refer to the exhibit. (Exhibit) A network administrator must...
Question 90: How will Link Aggregation be Implemented on a Cisco Wireless...
Question 91: Drag and drop the SNMP manager and agent identifier commands...
Question 92: Which type of information resides on a DHCP server?...
Question 93: Which protocol does an access point use to draw power from a...
Question 94: Drag and drop the characteristics of network architectures f...
Question 95: Which action must be taken to assign a global unicast IPv6 a...
Question 96: When configuring a WLAN with WPA2 PSK in the Cisco Wireless ...
Question 97: Which type of security program is violated when a group of e...
Question 98: What criteria is used first during the root port selection p...
Question 99: Drag the descriptions of IP protocol transmissions from the ...
Question 100: Which technology is appropriate for communication between an...
Question 101: What is a DNS lookup operation?...
Question 102: What are two recommendations for protecting network ports fr...
Question 103: When implementing a router as a DHCP server, which two featu...
Question 104: Refer to the exhibit. (Exhibit) The New York router is confi...
Question 105: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 106: Refer to the exhibit. (Exhibit) Drag and drop the networking...
Question 107: What are two southbound APIs? (Choose two )...
Question 108: Which networking function occurs on the data plane?...
Question 109: A network administrator must enable DHCP services between tw...
Question 110: Drag and drop the Cisco Wireless LAN Controller security set...
Question 111: Drag and drop the descriptions of file-transfer protocols fr...
Question 112: Refer to the exhibit. (Exhibit) If OSPF is running on this n...
Question 113: Which attribute does a router use to select the best path wh...
Question 114: What is the benefit of using FHRP?...
Question 115: Refer to the exhibit. (Exhibit) What is the effect of this c...
Question 116: Why does a switch flood a frame to all ports?...
Question 117: What are two reasons that cause late collisions to increment...
Question 118: Refer to the exhibit. (Exhibit) Which switch in this configu...
Question 119: Which API is used in controller-based architectures to inter...
Question 120: Which WLC port connects to a switch to pass normal access-po...
Question 121: Refer to the exhibit. (Exhibit) A network engineer must bloc...
Question 122: What is a DHCP client?
Question 123: A packet is destined for 10.10.1.22. Which static route does...
Question 124: When DHCP is configured on a router, which command must be e...