<< Prev Question Next Question >>

Question 12/125

A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (125q)
Question 1: How do AAA operations compare regarding user identification,...
Question 2: What is a difference between RADIUS and TACACS+?...
Question 3: An engineer must establish a trunk link between two switches...
Question 4: Which type of attack can be mitigated by dynamic ARP inspect...
Question 5: Refer to the exhibit. (Exhibit) Only four switches are parti...
Question 6: An engineer observes high usage on the 2.4GHz channels and l...
Question 7: If a notice-level messaging is sent to a syslog server, whic...
Question 8: Which configuration is needed to generate an RSA key for SSH...
Question 9: What are two benefits of network automation? (Choose two)...
Question 10: Drag and drop to the characteristics of networking from the ...
Question 11: Refer to the exhibit. (Exhibit) An administrator is tasked w...
Question 12: A user configured OSPF in a single area between two routers ...
Question 13: A frame that enters a switch fails the Frame Check Sequence....
Question 14: Refer to the exhibit. (Exhibit) Which route type is configur...
Question 15: Which global command encrypt all passwords in the running co...
Question 16: Which statement identifies the functionality of virtual mach...
Question 17: Which two WAN architecture options help a business improve s...
Question 18: In which two ways does a password manager reduce the chance ...
Question 19: Which 802.11 frame type is indicated by a probe response aft...
Question 20: A network administrator needs to aggregate 4 ports into a si...
Question 21: What occurs when overlapping Wi-Fi channels are implemented?...
Question 22: Which command prevents passwords from being stored in the co...
Question 23: What is an advantage of Cisco DNA Center versus traditional ...
Question 24: Which switch technology establishes a network connection imm...
Question 25: What is the maximum bandwidth of a T1 point-to-point connect...
Question 26: When implementing a router as a DHCP server, which two featu...
Question 27: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 28: Refer to the exhibit. (Exhibit) If the network environment i...
Question 29: What is the primary different between AAA authentication and...
Question 30: What are two roles of Domain Name Services (DNS)? (Choose Tw...
Question 31: Which command is used to specify the delay time in seconds f...
Question 32: What protocol allows an engineer to back up 20 network route...
Question 33: Which protocol does an access point use to draw power from a...
Question 34: Refer to the Exhibit. (Exhibit) After the switch configurati...
Question 35: Which configuration ensures that the switch is always the ro...
Question 36: What criteria is used first during me root port selection pr...
Question 37: Which two encoding methods are supported by REST APIs? (Choo...
Question 38: Refer to Exhibit. (Exhibit) Which configuration must be appl...
Question 39: What are two fundamentals of virtualization? (choose two)...
Question 40: Which device performs stateful inspection of traffic?...
Question 41: An engineer configured an OSPF neighbor as a designated rout...
Question 42: Refer to the exhibit. (Exhibit) An administrator must config...
Question 43: An administrator must secure the WLC from receiving spoofed ...
Question 44: Refer to the exhibit. (Exhibit) Which prefix does Router 1 u...
Question 45: Drag and drop the Cisco Wireless LAN Controller security set...
Question 46: A network engineer is configuring an OSPFv2 neighbor adjacen...
Question 47: Which command enables a router to become a DHCP client?...
Question 48: What are two differences between optical-fiber cabling and c...
Question 49: What does an SDN controller use as a communication protocol ...
Question 50: What is the purpose of traffic shaping?...
Question 51: When the active router in an HSRP group fails, what router a...
Question 52: How does the dynamically-learned MAC address feature functio...
Question 53: A corporate office uses four floors in a building * Floor 1 ...
Question 54: What is the difference regarding reliability and communicati...
Question 55: What are two reasons that cause late collisions to increment...
Question 56: Which 802.11 frame type is association response?...
Question 57: When a WPA2-PSK WLAN is configured in the wireless LAN Contr...
Question 58: Refer to the exhibit. (Exhibit) Drag and drop the networking...
Question 59: Drag and drop the 802.11 wireless standards from the left on...
Question 60: Which network plane is centralized and manages routing decis...
Question 61: Refer to exhibit. (Exhibit) Which statement explains the con...
Question 62: Which command automatically generates an IPv6 address from a...
Question 63: Drag and drop the SNMP components from the left onto the des...
Question 64: Drag and drop the DHCP snooping terms from the left onto the...
Question 65: A device detects two stations transmitting frames at the sam...
Question 66: Which function does the range of private IPv4 addresses perf...
Question 67: What is a network appliance that checks the state of a packe...
Question 68: Which CRUD operation modifies an existing table or view?...
Question 69: Which attribute does a router use to select the best path wh...
Question 70: A manager asks a network engineer to advise which cloud serv...
Question 71: Which statement correctly compares traditional networks and ...
Question 72: Which two minimum parameters must be configured on an active...
Question 73: Which type of wireless encryption is used for WPA2 in presha...
Question 74: Drag the descriptions of device management from the left ont...
Question 75: Router R1 must send all traffic without a matching routing-t...
Question 76: When a site-to-site VPN is used, which protocol is responsib...
Question 77: Refer to the exhibit. (Exhibit) Router R1 Fa0/0 cannot ping ...
Question 78: What are two descriptions of three-tier network topologies? ...
Question 79: Where does a switch maintain DHCP snooping information?...
Question 80: What is a characteristic of private IPv4 addressing?...
Question 81: Refer to the exhibit. An engineer must add a subnet for a ne...
Question 82: Which mode must be used to configure EtherChannel between tw...
Question 83: What is the effect when loopback interfaces and the configur...
Question 84: Which networking function occurs on the data plane?...
Question 85: Two switches are connected and using Cisco Dynamic Trunking ...
Question 86: Drag and drop the IPv4 network subnets from the left onto th...
Question 87: Which protocol prompts the Wireless LAN Controller to genera...
Question 88: How does CAPWAP communicate between an access point in local...
Question 89: Which mode allows access points to be managed by Cisco Wirel...
Question 90: What causes a port to be placed in the err-disabled state?...
Question 91: Refer to the exhibit. (Exhibit) Which route does R1 select f...
Question 92: in Which way does a spine and-leaf architecture allow for sc...
Question 93: Refer to the exhibit. (Exhibit) If configuring a static defa...
Question 94: Which resource is able to be shared among virtual machines d...
Question 95: Refer to the exhibit. (Exhibit) An administrator configures ...
Question 96: An office has 8 floors with approximately 30-40 users per fl...
Question 97: Which IPv6 address type provides communication between subne...
Question 98: A network engineer must back up 20 network router configurat...
Question 99: What is a DNS lookup operation?...
Question 100: Refer to the exhibit. (Exhibit) An engineer is bringing up a...
Question 101: What are two functions of an SDN controller? (Choose two)...
Question 102: Drag and drop the network protocols from the left onto the c...
Question 103: When configuring IPv6 on an interface, which two IPv6 multic...
Question 104: Which CRUD operation corresponds to the HTTP GET method?...
Question 105: Which IPv6 address type provides communication between subne...
Question 106: What are two recommendations for protecting network ports fr...
Question 107: Which QoS Profile is selected in the GUI when configuring a ...
Question 108: Which action is taken by a switch port enabled for PoE power...
Question 109: Refer to the exhibit. (Exhibit) The entire contents of the M...
Question 110: When configuring a WLAN with WPA2 PSK in the Cisco Wireless ...
Question 111: Refer to the exhibit. (Exhibit) A network administrator has ...
Question 112: Refer to Exhibit. (Exhibit) Which action do the switches tak...
Question 113: Which command must be entered when a device is configured as...
Question 114: When DHCP is configured on a router, which command must be e...
Question 115: What are two improvements provided by automation for network...
Question 116: Where does the configuration reside when a helper address Is...
Question 117: Drag and drop the attack-mitigation techniques from the left...
Question 118: Refer to the exhibit. (Exhibit) Which type of route does R1 ...
Question 119: What are two roles of the Dynamic Host Configuration Protoco...
Question 120: which type of IPv6 address is publicly routable in the same ...
Question 121: Refer to the exhibit. (Exhibit) Which two commands were used...
Question 122: What is a practice that protects a network from VLAN hopping...
Question 123: Which output displays a JSON data representation? (Exhibit)...
Question 124: By default, how Does EIGRP determine the metric of a route f...
Question 125: Drag and drop the TCP/IP protocols from the left onto the tr...