<< Prev Question Next Question >>

Question 74/123

A network administrator enabled port security on a switch interface connected to a printer. What is the next configuration action in order to allow the port to learn the MAC address of the printer and insert it into the table automatically?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (123q)
1 commentQuestion 1: What is a recommended approach to avoid co-channel congestio...
Question 2: Which command on a port enters the forwarding state immediat...
Question 3: When a site-to-site VPN is used, which protocol is responsib...
Question 4: Which statement identifies the functionality of virtual mach...
Question 5: Which design element is a best practice when deploying an 80...
Question 6: An engineer must configure the IPv6 address 2001:0db8:0000:0...
Question 7: What benefit does controller-based networking provide versus...
Question 8: Which configuration management mechanism uses TCP port 22 by...
Question 9: Which type of address is the public IP address of a NAT devi...
Question 10: By default, how Does EIGRP determine the metric of a route f...
Question 11: Refer to the exhibit. (Exhibit) Shortly after SiteA was conn...
Question 12: An engineer requires a scratch interface to actively attempt...
Question 13: Where does the configuration reside when a helper address Is...
Question 14: Refer to Exhibit. (Exhibit) An engineer is configuring the N...
Question 15: Refer to the exhibit. (Exhibit) A router reserved these five...
Question 16: Refer to the exhibit. (Exhibit) An engineer booted a new swi...
Question 17: What is a DHCP client?
Question 18: What is the primary effect of the spanning-tree portfast com...
Question 19: Refer to the exhibit. (Exhibit) If the network environment i...
Question 20: Which result occurs when PortFast is enabled on an interface...
Question 21: What is a function of a remote access VPN?...
Question 22: Which command prevents passwords from being stored in the co...
Question 23: Refer to the exhibit. (Exhibit) The network administrator wa...
Question 24: Drag the descriptions of device management from the left ont...
Question 25: Refer to the exhibit. (Exhibit) Which outcome is expected wh...
Question 26: What is a difference between RADIUS and TACACS+?...
Question 27: Which two must be met before SSH can operate normally on a C...
Question 28: When implementing a router as a DHCP server, which two featu...
Question 29: Drag and drop the threat-mitigation techniques from the left...
Question 30: Which technology allows for multiple operating systems to be...
Question 31: Drag drop the descriptions from the left onto the correct co...
Question 32: Router R1 must send all traffic without a matching routing-t...
Question 33: An organization secures its network with multi-factor authen...
Question 34: Refer to the exhibit. After the configuration is applied, th...
Question 35: What is a benefit of VRRP?
Question 36: Drag and drop the descriptions of file-transfer protocols fr...
Question 37: What is a network appliance that checks the state of a packe...
Question 38: An administrator must secure the WLC from receiving spoofed ...
Question 39: If a notice-level messaging is sent to a syslog server, whic...
Question 40: Drag and drop to the characteristics of networking from the ...
Question 41: Two switches are connected and using Cisco Dynamic Trunking ...
Question 42: Which protocol prompts the Wireless LAN Controller to genera...
Question 43: Drag and drop the Cisco Wireless LAN Controller security set...
Question 44: What is a characteristic of private IPv4 addressing?...
Question 45: What is a role of access points in an enterprise network?...
Question 46: Drag and drop the WLAN components from the left onto the cor...
Question 47: Refer to the exhibit. (Exhibit) Which two commands were used...
Question 48: What are two fundamentals of virtualization? (choose two)...
Question 49: Refer to the exhibit. (Exhibit) A network engineer must bloc...
Question 50: How do TCP and UDP differ in the way they guarantee packet d...
Question 51: What are two differences between optical-fiber cabling and c...
Question 52: Refer to the exhibit. (Exhibit) The default-information orig...
Question 53: Which 802.11 frame type is association response?...
Question 54: Which two WAN architecture options help a business scalabili...
Question 55: Which WAN topology provides a combination of simplicity qual...
Question 56: An engineer observes high usage on the 2.4GHz channels and l...
Question 57: Which CRUD operation corresponds to the HTTP GET method?...
Question 58: A network administrator needs to aggregate 4 ports into a si...
Question 59: An engineer must configure a/30 subnet between two routers. ...
Question 60: Refer to the exhibit. (Exhibit) An engineer configured NAT t...
Question 61: A frame that enters a switch fails the Frame Check Sequence....
Question 62: Which protocol does an IPv4 host use to obtain a dynamically...
Question 63: A corporate office uses four floors in a building * Floor 1 ...
Question 64: Refer to the exhibit. (Exhibit) To which device does Router1...
Question 65: In which situation is private IPv4 addressing appropriate fo...
Question 66: What are two roles of the Dynamic Host Configuration Protoco...
Question 67: Which two actions are performed by the Weighted Random Early...
Question 68: What is the primary different between AAA authentication and...
Question 69: What is a practice that protects a network from VLAN hopping...
Question 70: Which IPv6 address block sends packets to a group address ra...
Question 71: which IPv6 address block forwards packets to a multicast add...
Question 72: Refer to the exhibit. An engineer must add a subnet for a ne...
Question 73: Which unified access point mode continues to serve wireless ...
Question 74: A network administrator enabled port security on a switch in...
Question 75: Refer to the exhibit. (Exhibit) A network engineer must conf...
Question 76: Refer to the exhibit. (Exhibit) An administrator must config...
Question 77: When configuring IPv6 on an interface, which two IPv6 multic...
Question 78: Refer to Exhibit. (Exhibit) Which configuration must be appl...
Question 79: Which technology must be implemented to configure network de...
Question 80: How do AAA operations compare regarding user identification,...
Question 81: Refer to the exhibit. (Exhibit) Router R1 Fa0/0 cannot ping ...
Question 82: What are two reasons that cause late collisions to increment...
Question 83: Refer to the exhibit. (Exhibit) What is the effect of this c...
Question 84: Router A learns the same route from two different neighbors,...
Question 85: Refer to the exhibit. (Exhibit) What is the effect of this c...
Question 86: Refer to the exhibit. (Exhibit) A network administrator assu...
Question 87: Refer to the exhibit. (Exhibit) If OSPF Is running on this n...
Question 88: Refer to the exhibit. (Exhibit) If configuring a static defa...
Question 89: The service password-encryption command is entered on a rout...
Question 90: When using Rapid PVST+, which command guarantees the switch ...
Question 91: Refer to the exhibit. (Exhibit) What is the result if Gig1/1...
Question 92: Refer to the exhibit. (Exhibit) Which route type does the ro...
Question 93: Which type of security program is violated when a group of e...
Question 94: What facilitates a Telnet connection between devices by ente...
Question 95: Refer to the exhibit. (Exhibit) Which switch becomes the roo...
Question 96: Which API is used in controller-based architectures to inter...
Question 97: What is the effect when loopback interfaces and the configur...
Question 98: An email user has been lured into clicking a link in an emai...
Question 99: Refer to the exhibit. (Exhibit) An engineer is required to v...
Question 100: Which MAC address is recognized as a VRRP virtual address?...
Question 101: Refer to the exhibit. (Exhibit) Which route does R1 select f...
Question 102: How does HSRP provide first hop redundancy?...
Question 103: How do servers connect to the network in a virtual environme...
Question 104: Refer to the exhibit. (Exhibit) An administrator must turn o...
Question 105: Which statement correctly compares traditional networks and ...
Question 106: What is a DHCP client?
Question 107: Which device performs stateful inspection of traffic?...
Question 108: What is a function of Wireless LAN Controller?...
Question 109: Which two actions influence the EIGRP route selection proces...
Question 110: Refer to the exhibit. (Exhibit) Which type of configuration ...
Question 111: Which resource is able to be shared among virtual machines d...
Question 112: What uses HTTP messages to transfer data to applications res...
Question 113: what occurs to frames during the process of frame flooding?...
Question 114: An engineer is configuring NAT to translate the source subne...
Question 115: A network engineer must back up 20 network router configurat...
Question 116: in Which way does a spine and-leaf architecture allow for sc...
Question 117: Drag the IPv6 DNS record types from the left onto the descri...
Question 118: A wireless administrator has configured a WLAN; however, the...
Question 119: What are two reasons for an engineer to configure a floating...
Question 120: Which type of attack can be mitigated by dynamic ARP inspect...
Question 121: In which two ways does a password manager reduce the chance ...
Question 122: Which network allows devices to communicate without the need...
Question 123: What are two functions of a Layer 2 switch? (Choose two)...