<< Prev Question Next Question >>

Question 58/89

Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (89q)
Question 1: Refer to the exhibit. (Exhibit) Which command provides this ...
Question 2: Drag and drop the WLAN components from the left onto the cor...
Question 3: Router R1 must send all traffic without a matching routing-t...
Question 4: When using Rapid PVST+, which command guarantees the switch ...
Question 5: Drag and drop the threat-mitigation techniques from the left...
Question 6: Refer to the exhibit. (Exhibit) To which device does Router1...
1 commentQuestion 7: A corporate office uses four floors in a building * Floor 1 ...
Question 8: Which command must be entered when a device is configured as...
1 commentQuestion 9: An office has 8 floors with approximately 30-40 users per fl...
Question 10: Refer to the exhibit. (Exhibit) What is the effect of this c...
1 commentQuestion 11: Refer to the exhibit. (Exhibit) Based on the LACP neighbor s...
Question 12: What protocol allows an engineer to back up 20 network route...
Question 13: How does the dynamically-learned MAC address feature functio...
Question 14: Drag and drop the IPv4 network subnets from the left onto th...
Question 15: Which two outcomes are predictable behaviors for HSRP? (Choo...
Question 16: Refer to the exhibit. (Exhibit) If OSPF Is running on this n...
Question 17: What is the primary different between AAA authentication and...
Question 18: Which API is used in controller-based architectures to inter...
Question 19: Which two minimum parameters must be configured on an active...
Question 20: A device detects two stations transmitting frames at the sam...
Question 21: How does CAPWAP communicate between an access point in local...
Question 22: Which attribute does a router use to select the best path wh...
Question 23: Which design element is a best practice when deploying an 80...
Question 24: (Exhibit) Refer to the exhibit. After the configuration is a...
Question 25: A port security violation has occurred on a switch port due ...
Question 26: Which statement identifies the functionality of virtual mach...
Question 27: What criteria is used first during me root port selection pr...
Question 28: A network engineer must back up 20 network router configurat...
Question 29: What are two roles of Domain Name Services (DNS)? (Choose Tw...
Question 30: Which CRUD operation modifies an existing table or view?...
Question 31: Which mode allows access points to be managed by Cisco Wirel...
Question 32: Refer to the exhibit. (Exhibit) An administrator configures ...
Question 33: Which IPv6 address block sends packets to a group address ra...
Question 34: Drag and drop the attack-mitigation techniques from the left...
Question 35: Which WPA3 enhancement protects against hackers viewing traf...
Question 36: When configuring IPv6 on an interface, which two IPv6 multic...
Question 37: How do TCP and UDP differ in the way they guarantee packet d...
Question 38: Refer to the exhibit. (Exhibit) What does router R1 use as i...
Question 39: (Exhibit) Refer to the exhibit. How does router R1 handle tr...
Question 40: Refer to the Exhibit. (Exhibit) After the switch configurati...
Question 41: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 42: Which configuration is needed to generate an RSA key for SSH...
Question 43: What are two descriptions of three-tier network topologies? ...
Question 44: What are two characteristics of a controller-based network? ...
Question 45: What is the primary effect of the spanning-tree portfast com...
Question 46: Refer to Exhibit. (Exhibit) The loopback1 interface of the A...
Question 47: Drag the descriptions of IP protocol transmissions from the ...
Question 48: which purpose does a northbound API serve in a controller-ba...
Question 49: Refer to the exhibit. (Exhibit) Which configuration on RTR-1...
Question 50: What are two differences between optical-fiber cabling and c...
Question 51: What is a DHCP client?
Question 52: Refer to the exhibit. (Exhibit) Which prefix does Router 1 u...
Question 53: The service password-encryption command is entered on a rout...
Question 54: What are two reasons that cause late collisions to increment...
Question 55: Refer to the exhibit. (Exhibit) An engineer configured NAT t...
Question 56: When OSPF learns multiple paths to a network, how does it se...
Question 57: What are two benefits of controller-based networking compare...
Question 58: Which action must be taken to assign a global unicast IPv6 a...
Question 59: What facilitates a Telnet connection between devices by ente...
Question 60: Drag the descriptions of device management from the left ont...
Question 61: When configuring a WLAN with WPA2 PSK in the Cisco Wireless ...
Question 62: What software defined architecture plane assists network dev...
Question 63: Refer to the exhibit. (Exhibit) Which type of configuration ...
Question 64: Which two capacities of Cisco DNA Center make it more extens...
Question 65: What is the primary function of a Layer 3 device?...
Question 66: which type of IPv6 address is publicly routable in the same ...
Question 67: Drag and drop the AAA functions from the left onto the corre...
Question 68: in Which way does a spine and-leaf architecture allow for sc...
Question 69: Which network allows devices to communicate without the need...
Question 70: Which action is taken by a switch port enabled for PoE power...
Question 71: Which type of attack can be mitigated by dynamic ARP inspect...
Question 72: Refer to the exhibit. (Exhibit) An administrator is tasked w...
Question 73: Refer to the exhibit. (Exhibit) A network administrator must...
Question 74: An engineer needs to configure LLDP to send the port descrip...
Question 75: Which IPv6 address type provides communication between subne...
Question 76: An engineer must establish a trunk link between two switches...
Question 77: While examining excessive traffic on the network, it is note...
Question 78: Which two actions are performed by the Weighted Random Early...
Question 79: An email user has been lured into clicking a link in an emai...
Question 80: Which two tasks must be performed to configure NTP to a trus...
Question 81: Refer to the exhibit. (Exhibit) The New York router is confi...
Question 82: Refer to the exhibit. (Exhibit) Which two commands were used...
Question 83: Drag and drop the SNMP components from the left onto the des...
Question 84: What are two reasons for an engineer to configure a floating...
Question 85: What is a difference between local AP mode and FiexConnet AP...
Question 86: Refer to Exhibit. (Exhibit) An engineer is configuring the N...
Question 87: A network administrator enabled port security on a switch in...
Question 88: Refer to the exhibit. (Exhibit) After the election process w...
Question 89: When the active router in an HSRP group fails, what router a...