<< Prev Question Next Question >>

Question 30/75

A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (75q)
1 commentQuestion 1: Drag and drop the network protocols from the left onto the c...
Question 2: Refer to the exhibit. (Exhibit) If the network environment i...
Question 3: A user configured OSPF and advertised the Gigabit Ethernet i...
Question 4: Refer to the exhibit. (Exhibit) Which route type does the ro...
Question 5: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 6: When the active router in an HSRP group fails, what router a...
Question 7: Which type of address is the public IP address of a NAT devi...
Question 8: Refer to the exhibit. (Exhibit) An engineer is tasked with v...
Question 9: R1 has learned route 10.10.10.0/24 via numerous routing prot...
Question 10: A corporate office uses four floors in a building * Floor 1 ...
Question 11: When a WPA2-PSK WLAN is configured in the wireless LAN Contr...
1 commentQuestion 12: What mechanism carries multicast traffic between remote site...
Question 13: What are two benefits of network automation? (Choose two)...
Question 14: What benefit does controller-based networking provide versus...
Question 15: Refer to the exhibit. (Exhibit) An extended ACL has been con...
Question 16: What event has occurred if a router sends a notice level mes...
Question 17: (Exhibit) Refer to the exhibit. An engineer must add a subne...
Question 18: When a floating static route is configured, which action ens...
Question 19: Which two tasks must be performed to configure NTP to a trus...
Question 20: An engineer is asked to protect unused ports that are config...
Question 21: What criteria is used first during me root port selection pr...
Question 22: Which configuration ensures that the switch is always the ro...
Question 23: Refer to the exhibit. (Exhibit) An engineer is bringing up a...
Question 24: Using direct sequence spread spectrum, which three 2.4-GHz c...
Question 25: Which 802.11 frame type is association response?...
Question 26: Router R1 must send all traffic without a matching routing-t...
Question 27: Which API is used in controller-based architectures to inter...
Question 28: Which command must be entered when a device is configured as...
Question 29: How does CAPWAP communicate between an access point in local...
Question 30: A user configured OSPF in a single area between two routers ...
Question 31: Which statement about Link Aggregation when implemented on a...
Question 32: Which MAC address is recognized as a VRRP virtual address?...
Question 33: How do AAA operations compare regarding user identification,...
Question 34: Two switches are connected and using Cisco Dynamic Trunking ...
Question 35: Which attribute does a router use to select the best path wh...
Question 36: Refer to the exhibit. (Exhibit) What commands are needed to ...
Question 37: Which two command sequences must you configure on switch to ...
Question 38: What is the difference regarding reliability and communicati...
Question 39: What are two differences between optical-fiber cabling and c...
Question 40: Refer to exhibit. (Exhibit) Which statement explains the con...
Question 41: Refer to the exhibit. (Exhibit) An administrator configures ...
Question 42: Which device performs stateful inspection of traffic?...
Question 43: Which action is taken by a switch port enabled for PoE power...
Question 44: How do TCP and UDP differ in the way that they establish a c...
Question 45: Which type of information resides on a DHCP server?...
Question 46: Which two actions are performed by the Weighted Random Early...
Question 47: A wireless administrator has configured a WLAN; however, the...
Question 48: Refer to the exhibit. (Exhibit) What two conclusions should ...
Question 49: Which function does the range of private IPv4 addresses perf...
Question 50: (Exhibit) Refer to the exhibit. After the configuration is a...
Question 51: What is the primary purpose of a First Hop Redundancy Protoc...
Question 52: How does HSRP provide first hop redundancy?...
Question 53: Drag and drop the attack-mitigation techniques from the left...
Question 54: What software defined architecture plane assists network dev...
Question 55: What is a difference between local AP mode and FiexConnet AP...
Question 56: Refer to the exhibit. (Exhibit) A network engineer must bloc...
Question 57: A device detects two stations transmitting frames at the sam...
1 commentQuestion 58: While examining excessive traffic on the network, it is note...
Question 59: which type of IPv6 address is publicly routable in the same ...
Question 60: How do TCP and UDP differ in the way they guarantee packet d...
Question 61: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 62: What are two fundamentals of virtualization? (choose two)...
Question 63: Refer to the exhibit. (Exhibit) To which device does Router1...
Question 64: Refer to the exhibit. (Exhibit) Based on the LACP neighbor s...
Question 65: Refer to the Exhibit. (Exhibit) After the switch configurati...
Question 66: Which two must be met before SSH can operate normally on a C...
Question 67: Which WPA3 enhancement protects against hackers viewing traf...
Question 68: (Exhibit) Refer to the exhibit. How does router R1 handle tr...
Question 69: Which two outcomes are predictable behaviors for HSRP? (Choo...
Question 70: Refer to the exhibit. (Exhibit) Which password must an engin...
Question 71: Drag and drop the AAA functions from the left onto the corre...
Question 72: What criteria is used first during the root port selection p...
Question 73: Refer to the exhibit. (Exhibit) which path is used by the ro...
Question 74: Refer to the exhibit. (Exhibit) Which configuration on RTR-1...
Question 75: Which two capacities of Cisco DNA Center make it more extens...