Valid 200-301 Dumps shared by ExamDiscuss.com for Helping Passing 200-301 Exam! ExamDiscuss.com now offer the newest 200-301 exam dumps, the ExamDiscuss.com 200-301 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 200-301 dumps with Test Engine here:
Access 200-301 Dumps Premium Version
(1195 Q&As Dumps, 35%OFF Special Discount Code: freecram)
<< Prev Question Next Question >>
Question 56/75
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented?
(Choose two)
(Choose two)
Correct Answer: D,E
Explanation
Whenever the physical transmission has problems, the receiving device might receive a frame whose bits have changed values. These frames do not pass the error detection logic as implemented in the FCS field in the Ethernet trailer. The receiving device discards the frame and counts it as some kind of input error.
Cisco switches list this error as a CRC error. Cyclic redundancy check (CRC) is a term related to how the FCS math detects an error.
The "input errors" includes runts, giants, no buffer, CRC, frame, overrun, and ignored counts.
The output below show the interface counters with the "show interface s0/0/0" command:
Whenever the physical transmission has problems, the receiving device might receive a frame whose bits have changed values. These frames do not pass the error detection logic as implemented in the FCS field in the Ethernet trailer. The receiving device discards the frame and counts it as some kind of input error.
Cisco switches list this error as a CRC error. Cyclic redundancy check (CRC) is a term related to how the FCS math detects an error.
The "input errors" includes runts, giants, no buffer, CRC, frame, overrun, and ignored counts.
The output below show the interface counters with the "show interface s0/0/0" command:
- Question List (75q)
- 1 commentQuestion 1: What are two reasons that cause late collisions to increment...
- Question 2: Refer to the exhibit. (Exhibit) An engineer deploys a topolo...
- Question 3: A user configured OSPF in a single area between two routers ...
- Question 4: What is the default behavior of a Layer 2 switch when a fram...
- Question 5: Which function docs an SNMP agent perform?...
- Question 6: What software defined architecture plane assists network dev...
- Question 7: Refer to the exhibit. (Exhibit) A network engineer must bloc...
- Question 8: A router running EIGRP has learned the same route from two d...
- Question 9: Refer to the exhibit. (Exhibit) Which switch becomes the roo...
- Question 10: Which statement about Link Aggregation when implemented on a...
- Question 11: How do traditional campus device management and Cisco DNA Ce...
- Question 12: Which WAN access technology is preferred for a small office ...
- Question 13: A user configured OSPF and advertised the Gigabit Ethernet i...
- Question 14: Using direct sequence spread spectrum, which three 2.4-GHz c...
- Question 15: (Exhibit) Refer to the exhibit. How does router R1 handle tr...
- Question 16: What is a function of Wireless LAN Controller?...
- Question 17: Refer to the exhibit. (Exhibit) Drag and drop the networking...
- Question 18: Which technology is used to improve web traffic performance ...
- Question 19: When a site-to-site VPN is used, which protocol is responsib...
- Question 20: Refer to the exhibit. (Exhibit) What is the effect of this c...
- Question 21: Refer to the exhibit. (Exhibit) An administrator configures ...
- Question 22: Which output displays a JSON data representation? (Exhibit)...
- Question 23: Which MAC address is recognized as a VRRP virtual address?...
- Question 24: A packet is destined for 10.10.1.22. Which static route does...
- Question 25: Which network allows devices to communicate without the need...
- Question 26: What criteria is used first during me root port selection pr...
- Question 27: Which configuration is needed to generate an RSA key for SSH...
- Question 28: The SW1 interface g0/1 is in the down/down state. Which two ...
- Question 29: The service password-encryption command is entered on a rout...
- Question 30: What is an advantage of Cisco DNA Center versus traditional ...
- Question 31: which type of IPv6 address is publicly routable in the same ...
- Question 32: Which API is used in controller-based architectures to inter...
- Question 33: What is a characteristic of spine-and-leaf architecture?...
- Question 34: How will Link Aggregation be Implemented on a Cisco Wireless...
- Question 35: Which command enables a router to become a DHCP client?...
- Question 36: Refer to the exhibit. (Exhibit) Based on the LACP neighbor s...
- Question 37: How do TCP and UDP differ in the way they guarantee packet d...
- Question 38: An email user has been lured into clicking a link in an emai...
- Question 39: Refer to the exhibit. (Exhibit) What does router R1 use as i...
- Question 40: What is a difference between local AP mode and FiexConnet AP...
- Question 41: Which two encoding methods are supported by REST APIs? (Choo...
- Question 42: Refer to the exhibit. (Exhibit) Which type of route does R1 ...
- Question 43: What is the primary purpose of a First Hop Redundancy Protoc...
- Question 44: What is a difference between RADIUS and TACACS+?...
- Question 45: which IPv6 address block forwards packets to a multicast add...
- Question 46: Two switches are connected and using Cisco Dynamic Trunking ...
- Question 47: Refer to exhibit. (Exhibit) Which statement explains the con...
- Question 48: What is the expected outcome when an EUI-64 address is gener...
- Question 49: Which action must be taken to assign a global unicast IPv6 a...
- Question 50: What are two southbound APIs? (Choose two )...
- Question 51: Drag and drop the Cisco Wireless LAN Controller security set...
- Question 52: Which two values or settings must be entered when configurin...
- Question 53: How does Cisco DNA Center gather data from the network?...
- Question 54: Which two must be met before SSH can operate normally on a C...
- Question 55: What are two roles of Domain Name Services (DNS)? (Choose Tw...
- Question 56: A frame that enters a switch fails the Frame Check Sequence....
- Question 57: Which statement identifies the functionality of virtual mach...
- Question 58: Refer to the exhibit. (Exhibit) which path is used by the ro...
- Question 59: Drag and drop the attack-mitigation techniques from the left...
- Question 60: Refer to the exhibit. (Exhibit) Which configuration issue is...
- Question 61: Refer to the exhibit. (Exhibit) Which route does R1 select f...
- Question 62: A network engineer must back up 20 network router configurat...
- Question 63: What are two characteristics of a controller-based network? ...
- Question 64: An office has 8 floors with approximately 30-40 users per fl...
- Question 65: What are two roles of the Dynamic Host Configuration Protoco...
- Question 66: Refer to the exhibit. (Exhibit) With which metric was the ro...
- Question 67: An engineer is configuring NAT to translate the source subne...
- Question 68: Which two tasks must be performed to configure NTP to a trus...
- Question 69: Refer to the exhibit. (Exhibit) What commands are needed to ...
- Question 70: Router R1 must send all traffic without a matching routing-t...
- Question 71: Refer to the exhibit. (Exhibit) If the network environment i...
- Question 72: Which QoS Profile is selected in the GUI when configuring a ...
- Question 73: Which configuration ensures that the switch is always the ro...
- Question 74: When a WPA2-PSK WLAN is configured in the wireless LAN Contr...
- Question 75: Which action is taken by a switch port enabled for PoE power...
