<< Prev Question Next Question >>

Question 45/77

What event has occurred if a router sends a notice level message to a syslog server?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (77q)
Question 1: Which two capacities of Cisco DNA Center make it more extens...
Question 2: Refer to the exhibit. (Exhibit) The default-information orig...
Question 3: A router running EIGRP has learned the same route from two d...
Question 4: Which type of attack can be mitigated by dynamic ARP inspect...
Question 5: Drag and drop the IPv4 network subnets from the left onto th...
Question 6: What is the default behavior of a Layer 2 switch when a fram...
Question 7: By default, how Does EIGRP determine the metric of a route f...
Question 8: Refer to the exhibit. (Exhibit) An engineer deploys a topolo...
Question 9: Refer to the exhibit. (Exhibit) What action establishes the ...
Question 10: What are two differences between optical-fiber cabling and c...
Question 11: Refer to the exhibit. (Exhibit) A packet is being sent acros...
Question 12: Which output displays a JSON data representation? (Exhibit)...
Question 13: Which action is taken by a switch port enabled for PoE power...
Question 14: Which mode must be used to configure EtherChannel between tw...
Question 15: Refer to the Exhibit. (Exhibit) After the switch configurati...
Question 16: Drag and drop the WLAN components from the left onto the cor...
Question 17: Which two values or settings must be entered when configurin...
Question 18: An engineer must configure a WLAN using the strongest encryp...
Question 19: A user configured OSPF in a single area between two routers ...
Question 20: which type of IPv6 address is publicly routable in the same ...
Question 21: Which technology must be implemented to configure network de...
Question 22: Which configuration ensures that the switch is always the ro...
Question 23: What is the primary different between AAA authentication and...
Question 24: Refer to the exhibit. (Exhibit) Which switch in this configu...
Question 25: Which mode allows access points to be managed by Cisco Wirel...
Question 26: What protocol allows an engineer to back up 20 network route...
Question 27: When a floating static route is configured, which action ens...
Question 28: Refer to the exhibit. (Exhibit) Router R2 is configured with...
Question 29: Refer to the exhibit. (Exhibit) What is the effect of this c...
Question 30: A network engineer is configuring an OSPFv2 neighbor adjacen...
Question 31: Which type of information resides on a DHCP server?...
Question 32: What are two descriptions of three-tier network topologies? ...
Question 33: Refer to the exhibit. (Exhibit) What does router R1 use as i...
Question 34: A packet is destined for 10.10.1.22. Which static route does...
Question 35: What software defined architecture plane assists network dev...
Question 36: What role does a hypervisor provide for each virtual machine...
Question 37: Refer to the exhibit. (Exhibit) What is the next hop address...
Question 38: An engineer needs to configure LLDP to send the port descrip...
Question 39: Drag the descriptions of device management from the left ont...
Question 40: Which two actions influence the EIGRP route selection proces...
Question 41: Refer to the exhibit. (Exhibit) Drag and drop the networking...
Question 42: Refer to the exhibit. (Exhibit) An extended ACL has been con...
Question 43: Which MAC address is recognized as a VRRP virtual address?...
Question 44: Refer to the exhibit. (Exhibit) What commands are needed to ...
Question 45: What event has occurred if a router sends a notice level mes...
Question 46: What benefit does controller-based networking provide versus...
Question 47: Drag and drop the attack-mitigation techniques from the left...
Question 48: How do traditional campus device management and Cisco DNA Ce...
Question 49: Refer to the exhibit. (Exhibit) Which switch becomes the roo...
Question 50: Refer to the exhibit. (Exhibit) Router R1 is running three d...
Question 51: Which type of address is the public IP address of a NAT devi...
Question 52: When configuring a WLAN with WPA2 PSK in the Cisco Wireless ...
Question 53: How do TCP and UDP differ in the way they guarantee packet d...
Question 54: Which API is used in controller-based architectures to inter...
Question 55: R1 has learned route 192.168.12.0/24 via IS-IS. OSPF, RIP. a...
Question 56: Which two encoding methods are supported by REST APIs? (Choo...
Question 57: How does Cisco DNA Center gather data from the network?...
Question 58: Which IPv6 address type provides communication between subne...
Question 59: Refer to the exhibit. (Exhibit) A network engineer must bloc...
Question 60: An engineer is configuring NAT to translate the source subne...
Question 61: What is a difference between local AP mode and FiexConnet AP...
Question 62: A network administrator enabled port security on a switch in...
Question 63: Refer to the exhibit. (Exhibit) The show ip ospf interface c...
Question 64: An engineer must configure an OSPF neighbor relationship bet...
Question 65: What is the difference regarding reliability and communicati...
Question 66: How does CAPWAP communicate between an access point in local...
Question 67: Which two WAN architecture options help a business scalabili...
Question 68: What are two characteristics of a controller-based network? ...
Question 69: Drag and drop the functions from the left onto the correct n...
Question 70: Which network allows devices to communicate without the need...
Question 71: What is a function of Wireless LAN Controller?...
Question 72: A Cisco IP phone receive untagged data traffic from an attac...
Question 73: What are two reasons for an engineer to configure a floating...
Question 74: Refer to the exhibit. (Exhibit) Which prefix does Router 1 u...
Question 75: What are two benefits of controller-based networking compare...
Question 76: The SW1 interface g0/1 is in the down/down state. Which two ...
Question 77: When the active router in an HSRP group fails, what router a...