<< Prev Question Next Question >>

Question 43/89

Drag and Drop Question
Drag each route source from the left to the numbers on the right. Beginning with the lowest and ending with the highest administrative distance.
Select and Place:

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (89q)
Question 1: After you deploy a new WLAN controller on your network, whic...
2 commentQuestion 2: Refer to the exhibit. A router received these five routes fr...
Question 3: Which type of ipv6 address is publicly routable in the same ...
Question 4: An email user has been lured into clicking a link in an emai...
Question 5: What makes Cisco DNA Center different from traditional netwo...
Question 6: Which three describe the reasons large OSPF networks use a h...
Question 7: What is the expected outcome when an EUI-64 address is gener...
Question 8: Which two actions are performed by the Weighted Random Early...
Question 9: Drag and Drop Question Drag and drop the benefits of a cisco...
Question 10: Which two capacities of Cisco DNA Center make it more extens...
Question 11: Which action must be taken to assign a global unicast IPv6 a...
Question 12: Refer to the exhibit. Which two statements about the interfa...
Question 13: Refer to the exhibit. If OSPF is running on this network,how...
Question 14: Refer to the exhibit. How does router R1 handle traffic to 1...
Question 15: Refer to the exhibit. C-router is to be used as a "router-on...
Question 16: in Which way does a spine and-leaf architecture allow for sc...
Question 17: Drag and Drop Question Drag drop the descriptions from the l...
Question 18: Refer to the exhibit. What commands are needed to add a subi...
Question 19: Which of the following dynamic routing protocols are Distanc...
Question 20: Refer to the exhibit. What is the effect of this configurati...
Question 21: Refer to the exhibit. Which two statements about the network...
Question 22: What is the primary effect of the spanning-tree port fast co...
Question 23: Which unified access point mode continues to serve wireless ...
Question 24: Which type of address is the public IP address of a NAT devi...
Question 25: Which component of an Ethernet frame is used to notify a hos...
Question 26: What is an advantage of Cisco DNA Center versus traditional ...
Question 27: Refer to the exhibit. Which prefix does Router 1 use for tra...
1 commentQuestion 28: Which option about JSON is true?...
Question 29: Refer to the exhibit. When PC 1 sends a packet to PC2,the pa...
Question 30: Refer to the exhibit. A network technician is asked to desig...
Question 31: Which effete does the aaa new-model configuration command ha...
Question 32: Refer to the exhibit. Which statement about the interface th...
Question 33: A user configured OSPF and advertised the Gigabit Ethernet i...
Question 34: An engineer is asked to protect unused ports that are config...
Question 35: Which command is used to enable LLDP globally on a Cisco IOS...
Question 36: Drag and Drop Question A network engineer is configuring an ...
Question 37: What is the primary different between AAA authentication and...
Question 38: Which QoS Profile is selected in the GUI when configuring a ...
Question 39: Refer to exhibit. What Administrative distance has route to ...
Question 40: Which value can you modify to configure a specific interface...
Question 41: A network administrator is troubleshooting the OSPF configur...
Question 42: Which two statements about NTP operations are true? (Choose ...
Question 43: Drag and Drop Question Drag each route source from the left ...
Question 44: How do TCP and UDP differ in the way they provide reliabilit...
Question 45: You are configuring your edge routers interface with a publi...
Question 46: Which mode must be used to configure EtherChannel between tw...
Question 47: An engineer must configure a WLAN using the strongest encryp...
Question 48: Which command can you enter to determine the addresses that ...
Question 49: When configuring IPv6 on an interface, which two IPv6 multic...
Question 50: Which three statements about MAC addresses are correct? (Cho...
Question 51: Refer to exhibit. Which statement explains the configuration...
Question 52: Drag and Drop Question Drag and drop the characteristics of ...
Question 53: Which value is used to determine the active router in an HSR...
Question 54: A Cisco IP phone receive untagged data traffic from an attac...
Question 55: Refer to the exhibit. An engineer must add a subnet for a ne...
Question 56: Which IPv6 address type provides communication between subne...
Question 57: An engineer must configure a /30 subnet between two routers....
Question 58: What is the binary pattern of unique ipv6 unique local addre...
Question 59: Which command should you enter to configure a device as an N...
Question 60: Which two must be met before SSH can operate normally on a C...
Question 61: Refer to the exhibit. The New York router is configured with...
Question 62: Which WPA3 enhancement protects against hackers viewing traf...
Question 63: Which action is taken by a switch port enabled for PoE power...
Question 64: A corporate office uses four floors in a building. - Floor 1...
Question 65: How does HSRP provide first hop redundancy?...
Question 66: Which function dose the range of private IPv4 addresses perf...
Question 67: A frame that enters a switch fails the Frame Check Sequence....
Question 68: Which command is used to display the collection of OSPF link...
Question 69: What benefit does controller-based networking provide versus...
Question 70: By default, how does EIGRP determine the metric of a route f...
Question 71: Which Cisco IOS command will indicate that interface Gigabit...
Question 72: Refer to the exhibit. Which type of route does R1 use to rea...
Question 73: Which two statements about eBGP neighbor relationships are t...
Question 74: Which three statements are typical characteristics of VLAN a...
Question 75: Which two outcomes are predictable behaviors for HSRP? (Choo...
Question 76: Refer to the exhibit. Which two commands were used to create...
Question 77: Which command can you enter to allow Telnet to be supported ...
Question 78: Refer to Exhibit. An engineer is configuring the NEW York ro...
Question 79: Which two statements about VTP are true? (Choose two.)...
Question 80: Which two actions influence the EIGRP route selection proces...
Question 81: What are two reasons a network administrator would use CDP? ...
1 commentQuestion 82: A network engineer must create a diagram of a multivendor ne...
Question 83: Which technique can you use to route IPv6 traffic over an IP...
Question 84: Which feature or protocol is required for an IP SLA to measu...
Question 85: How do traditional campus device management and Cisco DNA Ce...
Question 86: A user configured OSPF in a single area between two routers ...
Question 87: Refer to the exhibit. Which Command do you enter so that R1 ...
Question 88: You have two paths for the 10.10.10.0 network - one that has...
Question 89: When configuring a WLAN with WPA2 PSK in the Cisco Wireless ...