<< Prev Question Next Question >>

Question 32/123

What is the correct format of an access control list on a Cisco Nexus switch to deny unencrypted Web traffic from any source to destination host 10.10.1.110?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (123q)
Question 1: An administrator wants a host with IP address 192.168.40.3 t...
Question 2: What is the maximum distance that is supported by Cisco acti...
Question 3: HOTSPOT (Exhibit)
Question 4: In Cisco NX-OS Software, which command redistributes a route...
Question 5: Which two layers of the OSI model are combined in the Intern...
Question 6: HOTSPOT (Exhibit)
Question 7: Which two networking devices operate at Layer 1 of the OSI m...
Question 8: Where does Cisco Nexus Operating System store the startup co...
Question 9: Which network topology is most closely associated with FDDI?...
Question 10: Which two statements describe the purpose of RFC 1918? (Choo...
Question 11: When connecting a switch port to a virtualization host requi...
Question 12: Which layer of the OSI model is associated with Token Ring M...
Question 13: On a Cisco router, which configuration register setting bypa...
Question 14: Which VTP mode disallows the creation of local VLANs?...
Question 15: Which device forwards data based on the destination IP addre...
Question 16: Which command should you use to configure a Cisco Nexus swit...
Question 17: How many IP addresses are usable for a subnet that has the a...
Question 18: How many IP address ranges are specified in RFC 1918?...
Question 19: What are two attributes of a VLAN? (Choose two.)...
Question 20: What is the addressing format of IPv6?...
Question 21: What is the function of the Tab key on the Cisco Nexus Opera...
Question 22: Which two data center technologies are part of the IEEE 802....
Question 23: What is required to allow devices that are using RFC 1918 ad...
Question 24: Which Cisco data center switch can support a 4-RU physical s...
Question 25: Which option is an example of a link-state routing protocol?...
Question 26: Which three statements are true concerning RFC 1918 IP addre...
Question 27: Which statement is correct regarding a routed port on a mult...
Question 28: What is the maximum allowable hop count for RIPv1?...
Question 29: What is the default periodic interval at which RIPv1 sends r...
Question 30: Given a subnet address of 10.6.128.0/22, how many IP address...
Question 31: What is the correct format of an access control list on a Ci...
Question 32: What is the correct format of an access control list on a Ci...
Question 33: Which two features must be licensed on a Cisco Nexus 5548UP ...
Question 34: What is the maximum distance that is supported between two d...
Question 35: What is the minimum number of fabric modules that should be ...
Question 36: What are three characteristics of the Ethernet access method...
Question 37: Ethernet 1/1 is assigned IP address 10.1.1.1 with subnet mas...
Question 38: Which field in an Ethernet II frame performs the same functi...
Question 39: Which option would you use to exit the Cisco Nexus Operating...
Question 40: If a Nexus switch receives a frame and no MAC table entry is...
Question 41: Which statement correctly describes an SVI?...
Question 42: How many bits are in an IPv4 address?...
Question 43: If a Nexus switch receives a frame and does not have an entr...
Question 44: What is the binary value of the decimal number 1263?...
Question 45: Which option is an example of a distance vector routing prot...
Question 46: What are four security features that are included in Cisco N...
Question 47: What is the minimum required command to enter global configu...
Question 48: HOTSPOT (Exhibit)
Question 49: Which layer of the OSI model is associated with the reliable...
Question 50: Which statement describes the function of the OSI transport ...
Question 51: HOTSPOT (Exhibit)
Question 52: Which two options are groups of network protocols that are c...
Question 53: Which two options describe services that are provided by TCP...
Question 54: What is the maximum distance that is supported by Cisco pass...
Question 55: Which option is an example of an advanced distance vector ro...
Question 56: A customer wants to connect to their SAN via Fibre Channel. ...
Question 57: What are two advantages of employing an external router for ...
Question 58: What is the correct format of an access control list on a Ci...
Question 59: Which transport protocol requires a three-way handshake to e...
Question 60: HOTSPOT (Exhibit)
Question 61: Which statement describes the purpose of the MAC address for...
Question 62: HOTSPOT (Exhibit)
Question 63: Which four statements indicate unique properties of VLAN 1 o...
Question 64: Which command displays the Trunking Native Mode VLAN on port...
Question 65: What is the subnet mask for the network 172.16.0.0/21?...
Question 66: What are three reasons that switches supersede bridges? (Cho...
Question 67: Which two options represent a subnet mask that allows for a ...
Question 68: Which two options describe what can happen when devices are ...
Question 69: HOTSPOT (Exhibit)
Question 70: HOTSPOT (Exhibit)
Question 71: Which network device is used to identify and protect against...
Question 72: What are two features of a bridge? (Choose two.)...
Question 73: How many supervisor engines must a Cisco Nexus chassis conta...
Question 74: In an IPv6 address, how many bits are used for the interface...
Question 75: What is the correct format of an access control list on a Ci...
Question 76: In Cisco NX-OS, which three options are possible spanning tr...
Question 77: What is the decimal value of the hexadecimal number 0x718?...
Question 78: On a new Cisco Nexus switch, you receive an error message wh...
Question 79: What are three important factors when configuring VTP on the...
Question 80: What is the order of the OSI stack starting at Layer 1 and e...
Question 81: Which two MAC addresses are valid? (Choose two.)...
Question 82: The kickstart image is corrupted on a Cisco Nexus 7000 switc...
Question 83: What are three modular Layer 2 processes in Cisco Nexus Oper...
Question 84: What is the Cisco Nexus Operating System command to define a...
Question 85: When deploying 10BASE-2 Ethernet, what is the maximum cable ...
Question 86: Which two options describe services that are provided by UDP...
Question 87: Which two networking devices forward data based on destinati...
Question 88: Which two features must be licensed on a Cisco Nexus 7000 Sw...
Question 89: Which situation results in a flashing blue status LED on a C...
Question 90: What are three reasons to migrate from IPv4 to IPv6? (Choose...
Question 91: Which three addresses are valid forms of an IPv6 Address: 20...
Question 92: What is the binary value of the hexadecimal number 0x511?...
Question 93: Which three terms are used to describe data at Layers 1, 2, ...
Question 94: Which two addresses represent multicast addresses? (Choose t...
Question 95: Which two layers of the OSI model are combined in the Intern...
Question 96: What is the default bridge ID priority for Rapid PVST+?...
Question 97: What are three modular Layer 3 processes in Cisco Nexus Oper...
Question 98: What is the command sequence to force a Cisco Nexus 6000 swi...
Question 99: Which action will a router take if it does not know the dest...
Question 100: Where does Cisco Nexus Operating System store the running co...
Question 101: Which device is a multiport bridge?...
Question 102: What is the dotted hexadecimal representation of the IP addr...
Question 103: You are designing a network that provides FCoE, FabricPath, ...
Question 104: In an IEEE 802.3 Ethernet frame, what is the significance of...
Question 105: Which version of Cisco Nexus Operating System became a commo...
Question 106: HOTSPOT (Exhibit)
Question 107: What are two core features of Cisco Nexus Operating System? ...
Question 108: VLAN 10 is assigned IP address 10.1.1.1 with subnet mask 255...
Question 109: Which three IP addresses are examples of an RFC 1918 address...
Question 110: On most keyboards, the Up arrow and Down arrow keys move thr...
Question 111: What are two default user roles in Cisco Nexus Operating Sys...
Question 112: Which two statements about configuring VLANs on the Cisco Ne...
Question 113: At which layer of the OSI model does TCP operate?...
Question 114: Which layer of the OSI model ensures that information sent f...
Question 115: What is the acronym expansion of the UDLD feature of Cisco N...
Question 116: At which layer in the OSI stack does the Hypertext Transfer ...
Question 117: Which two commands would you use to erase the Cisco Nexus Op...
Question 118: What is the maximum number of fabric modules that can be ins...
Question 119: Which two Cisco data center switches provide support for Vir...
Question 120: What will cause a device to wait a random amount of time bef...
Question 121: What does RIPv1 send to its neighbors?...
Question 122: Which option includes the two devices that can be connected ...
Question 123: Which two layers of the OSI model relate to the transmission...