Please see explanation
Explanation/Reference:
Explanation:
The above named organization has 14 hosts that need to access the internet simultaneously but were provided with just 6 public IP addresses from198.18.184.105 to 198.18.184.110/29.
In this case, you have to consider using NAT Overload (or PAT)
DoubleClick on the Weaver router to access the CLI
Router> enable
Router# configure terminal
First you should change the router's name to Weaver:
Router(config)#hostname Weaver
Create a NAT pool of global addresses to be allocated with their netmask:
Weaver(config)# ip nat pool mypool 198.18.184.105 198.18.184.110 netmask 255.255.255.248 Create a standard access control list that permits the addresses that are to be translated:
Weaver(config)#access-list 1 permit 192.168.100.16 0.0.0.15
Establish dynamic source translation, specifying the access list that was defined in the prior step:
Weaver(config)#ip nat inside source list 1 pool mypool overload
Finally, we should save all your work with the following command:
Weaver#copy running-config startup-config (Don't forget this)
Check your configuration by going to "Host for testing" and type:
C : \>ping 192.0.2.114
The ping should work well and you will be replied from 192.0.2.114
This command translates all source addresses that pass access list 1, which means a source address from 192.168.100.17 to 192.168.100.30, into an address from the pool named mypool (the pool contains addresses from 198.18.184.105 to 198.18.184.110) Overload keyword allows to map multiple IP addresses to a single registered IP address (many-to-one) by using different ports.
The question said that appropriate interfaces have been configured for NAT inside and NAT outside statements.
This is how to configure the NAT inside and NAT outside, just for your understanding:
Weaver(config)#interface fa0/0
Weaver(config-if)#ip nat inside
Weaver(config-if)#exit
Weaver(config)#interface s0/0
Weaver(config-if)#ip nat outside
Weaver(config-if)#end