100-105 Exam Dumps | Which destination IP address can a host use to send one message to multiple devices across different

Home
Cisco
Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0)
Cisco.100-105.v2018-06-06.q113
Question 111

Valid 100-105 Dumps shared by ExamDiscuss.com for Helping Passing 100-105 Exam! ExamDiscuss.com now offer the newest 100-105 exam dumps, the ExamDiscuss.com 100-105 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 100-105 dumps with Test Engine here:

Access 100-105 Dumps Premium Version
(832 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 111/113

Which destination IP address can a host use to send one message to multiple devices across different subnets?

A. 172.20.1.0

B. 192.168.0.119

C. 239.255.0.1

D. 127.0.0.1

Correct Answer: C

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (113q): Question 1: Which NAT term is defined as a group of addresses available ...; Question 2: A workstation has just resolved a browser URL to the IP addr...; Question 3: Which NTP command configures the local device as an NTP refe...; Question 4: Which statement about NTP is true?...; Question 5: On a Cisco switch, which protocol determines if an attached ...; Question 6: An administrator is working with the 192.168.4.0 netwrok, wh...; Question 7: Which feature allows a device to use a switch port that is c...; Question 8: Which function enables an administrator to route multiple VL...; Question 9: Which statement about routing protocols is true?...; Question 10: Which method does a connected trunk port use to tag VLAN tra...; Question 11: Refer to the exhibit. (Exhibit) If CDP is enabled on all dev...; Question 12: What is the subnet address of 192.168.1.42 255.255.255.248?...; Question 13: Refer to the exhibit. (Exhibit) An administrator cannot conn...; Question 14: On a live network, which two commands will verify the operat...; Question 15: (Exhibit) Refer to the exhibit. Which command would you use ...; Question 16: Which technique can you use to route IPv6 traffic over an IP...; Question 17: Which Ethernet interface command is present when you boot a ...; Question 18: Refer to the exhibit. (Exhibit) The MAC address table is sho...; Question 19: Which statement describes the effect of the copy run start c...; Question 20: Which two statements describe the operation of the CSMA/CD a...; Question 21: Which option must occur before a workstation can exchange HT...; Question 22: Which two of these functions do routers perform on packets? ...; Question 23: Instructions For both the Router and the Switch the simulate...; Question 24: By default, how many MAC addresses are permitted to be learn...; Question 25: Which MTU size can cause a baby giant error?...; Question 26: Refer to the exhibit. (Exhibit) Which command is simplest to...; Question 27: Which sequence begins a unique local IPv6 address in binary ...; Question 28: Which statement about DHCP address pools is true?...; Question 29: Which NTP concept indicates the distance between a device an...; Question 30: (Exhibit) Examine the DHCP configuration between R2 and R3; ...; Question 31: Instructions For both the Router and the Switch the simulate...; Question 32: Which address type does a switch use to make selective forwa...; Question 33: (Exhibit) Refer to the exhibit. The network administrator is...; Question 34: Which two options will help to solve the problem of a networ...; Question 35: Which statement about routing protocols is true?...; Question 36: Which routing protocol has the smallest default administrati...; Question 37: Refer to the exhibit. (Exhibit) A network has been planned a...; Question 38: When a router makes a routing decision for a packet that is ...; Question 39: Which adverse situation can occur if an Ethernet cable is to...; Question 40: After you configure a default route to the Internet on a rou...; Question 41: When enabled, which feature prevents routing protocols from ...; Question 42: Which option is a valid hostname for a switch?...; Question 43: Which statement about the default switch configuration for r...; Question 44: Which route source code represents the routing protocol with...; Question 45: Which three statements are true about the operation of a ful...; Question 46: Refer to the exhibit. (Exhibit) If the resume command is ent...; Question 47: Which command displays the number of times that an individua...; Question 48: Which statement describes the effect of the overload keyword...; Question 49: Which port-security feature allows a switch to learn MAC add...; Question 50: Which set of conditions comprises a successful ping attempt ...; Question 51: Refer to the exhibit. (Exhibit) A TFTP server has recently b...; Question 52: (Exhibit) Refer to the topology and switching table shown in...; Question 53: Refer to the exhibit. (Exhibit) The two routers have had the...; Question 54: You have configured the host computers on a campus LAN to re...; Question 55: (Exhibit) Users complain that they are unable to reach Inter...; Question 56: Which feature automatically disables Cisco Express Forwardin...; Question 57: (Exhibit) R1 router clock is synchronized with ISP router. R...; Question 58: Two hosts are attached to a switch with the default configur...; Question 59: An administrator has connected devices to a switch and, for ...; Question 60: (Exhibit) Why application that are installed on PC's in R2 L...; Question 61: Which entity assigns IPv6 addresses to end users?...; Question 62: Which table displays the MAC addresses that are learned on a...; Question 63: In which two ways does TCP differ from UDP? (Choose two.)...; Question 64: Which NAT command can be applied to an interface?...; Question 65: Which statement about unique local IPv6 addresses is true?...; Question 66: (Exhibit) Refer to the exhibit. Which feature is enabled by ...; Question 67: Which subnet address is for the IP address 172.19.20.23/28?...; Question 68: Instructions For both the Router and the Switch the simulate...; Question 69: Which device allows users to connect to the network using a ...; Question 70: Refer to the exhibit. (Exhibit) All devices attached to the ...; Question 71: Why would a network administrator configure port security on...; Question 72: Which statement about 6to4 tunneling is true?...; Question 73: Which statement about a router on a stick is true?...; Question 74: Which statement is a Cisco best practice for switch port sec...; Question 75: Which option is the default switch port port-security violat...; Question 76: Which keyword in a NAT configuration enables the use of one ...; Question 77: On which OSI layer does a VLAN operate?...; Question 78: Which three statements accurately describe CDP? (Choose thre...; Question 79: At which layer of the OSI model does the protocol that provi...; Question 80: How many primary IPv4 addresses can be assigned to an interf...; Question 81: A switch has 48 ports and 4 VLANs. How many collision and br...; Question 82: If a host experiences intermittent issues that relate to con...; Question 83: What is the default lease time for a DHCP binding?...; Question 84: Which component of a routing table entry represents the subn...; Question 85: Instructions For both the Router and the Switch the simulate...; Question 86: Which two VLANs are reserved for system use only? (Choose tw...; Question 87: Which technology supports the stateless assignment of IPv6 a...; Question 88: Which statement describes the effect of the exec-timeout 30 ...; Question 89: Which protocol verifies connectivity between two switches th...; Question 90: The command ip route 192.168.100.160 255.255.255.224 192.168...; Question 91: Which statement about native VLAN traffic is true?...; Question 92: Refer to the exhibit. (Exhibit) Which statement describes th...; Question 93: Refer to the exhibit. (Exhibit) Which option describes how S...; Question 94: (Exhibit) Refer to the exhibit. The enterprise has decided t...; Question 95: Which network configuration can you use to segregate broadca...; Question 96: Which statement about unicast frame forwarding on a switch i...; Question 97: Which NAT type is used to translate a single inside address ...; Question 98: Which two statements are true regarding ICMP packets? (Choos...; Question 99: Which value is indicated by the next hop in a routing table?...; Question 100: Which information is used to install the best route to a des...; Question 101: Which RFC was created to alleviate the depletion of IPv4 pub...; Question 102: Which statement about the inside interface configuration in ...; Question 103: On which type of device is every port in the same collision ...; Question 104: (Exhibit) Refer to the exhibit. Which option describes how S...; Question 105: Configuration of which option is required on a Cisco switch ...; Question 106: Which network topology allows all traffic to flow through a ...; Question 107: Which dynamic routing protocol uses only the hop count to de...; Question 108: Which component of the routing table ranks routing protocols...; Question 109: In which circumstance is static routing most useful?...; Question 110: Refer to the exhibit. (Exhibit) The exhibit is showing the t...; Question 111: Which destination IP address can a host use to send one mess...; Question 112: What is one requirement for interfaces to run IPv6?...; Question 113: How does a Layer 2 switch differ from a hub?...

[×]

Download PDF File

Enter your email address to download Cisco.100-105.v2018-06-06.q113.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 111/113

LEAVE A REPLY

Download PDF File