<< Prev Question Next Question >>

Question 42/90

What advantages does using predictive site survey modeling software offer over performing a manual site survey? (Choose 2)

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (90q)
Question 1: A non-802.11 device is suspected of causing interference on ...
Question 2: When compared with legacy Power Save mode, how does VHT TXOP...
Question 3: What statement about 802.3. Clause 33 Power over Ethernet is...
Question 4: What statement is true concerning the use of Orthogonal Freq...
Question 5: When a client moves to a new BSS within an ESS, what step is...
Question 6: During a post-implementation survey, you have detected a non...
Question 7: An IEEE 802.11 amendment is in the draft state. What impact ...
Question 8: What feature was introduced in the 802.11h amendment in orde...
Question 9: Users and Network support personnel at a mid-sized equipment...
Question 10: You have received a report of poor wireless connections on t...
Question 11: You are managing a wireless access point in autonomous mode ...
Question 12: A dual-band 802-1 lac AP must be powered by PoE. As a class ...
Question 13: You are the network administrator for ABC Company. Your mana...
Question 14: As you prepare for a site survey in a multi-floor corporate ...
Question 15: What security solution is deprecated in the 802.11 standard ...
Question 16: Your manager asked you to locate a solution that allows for ...
Question 17: In an 802.11 2.4 GHz system, what 22 MHz channels are consid...
Question 18: Which one of the following frequency ranges is not specified...
Question 19: You are deploying a WLAN with the access points configured f...
Question 20: What wireless networking term describe the increase of RF en...
Question 21: An RF signal sometimes bends as it passes through some mater...
Question 22: Option 43 must be configured to allow access points to locat...
Question 23: Which IEEE 802.11 physical layer (PHY) specifications includ...
Question 24: What can an impedance mismatch In the RF cables and connecto...
Question 25: What statement about the IEEE 802.11e QoS facility is true?...
Question 26: The IEEE 802.11-2012 standard requires VHT capable devices t...
Question 27: A client complains of low data rates on his computer. When y...
Question 28: You are using a tool that allows you to see signal strength ...
Question 29: The network administrator at XYZ Company recently attended a...
Question 30: What is primary metric of scanning can stations use to selec...
Question 31: What factor is likely to cause the least impact on the appli...
Question 32: In WLAN security, which authentication method always create ...
Question 33: You are reconfiguring an AP to use the short guard Interval....
Question 34: What factors does not influence the distance at which an RF ...
Question 35: Which one of the following is not a factor considered when c...
Question 36: When implementing PoE, what role is played by a switch?...
Question 37: What terms accurately complete the following sentence? The I...
Question 38: What item is essential for performing a manual RF site surve...
Question 39: You are being interviewed by ABC Company for employment as a...
Question 40: What is the final step in an effective troubleshooting proce...
Question 41: Which one of the following channels can be used for VHT tran...
Question 42: What advantages does using predictive site survey modeling s...
Question 43: What 802.11 network configuration would result in multiple s...
Question 44: You were previously onsite at XYZ's facility to conduct a pr...
Question 45: What is the most effective method for testing roaming in rel...
Question 46: A company has hired you to perform a pre-deployment site sur...
Question 47: ABC Company has thousands of Wi-Fi users accessing their net...
Question 48: You are troubleshooting a client problem with a 2.4 GHz WLAN...
Question 49: You are using a site survey tool for post-implementation val...
Question 50: To ease user complexity, your company has implemented a sing...
Question 51: You are troubleshooting a problem with interference from a n...
Question 52: You are onsite with a client to perform a post-deployment si...
2 commentQuestion 53: What is appended to the end of each 802.11 data frame after ...
Question 54: Your consulting firm has recently been hired to complete a s...
Question 55: What best describes WPA2 in relation to 802.11 wireless netw...
Question 56: You are performing a post implementation validation survey. ...
Question 57: Two co-located 802.11b/g/n APs can interfere with one anothe...
Question 58: What cause of hidden nodes within a BSS would be more likely...
Question 59: To ease user complexity, your company has implemented a sing...
Question 60: In addition to coverage analysis results, what should be inc...
Question 61: You are implementing a multi-AP WLAN and fast secure roaming...
Question 62: You are implementing a VHT-capable AP. Which one of the foll...
Question 63: You are troubleshooting a client issue on a Windows laptop. ...
Question 64: What is a channel mode specified by the 802.11n (High Throug...
Question 65: Which directional antenna types are commonly used by indoor ...
Question 66: What parameter of the client driver should be configured on ...
Question 67: ABC Company is planning a point-to-multipoint outdoor bridge...
Question 68: What statements about the beamwidth of an RF antenna are tru...
Question 69: What cipher suite is specified by the 802.11-2016 standard a...
Question 70: What statement about the SSID is true?...
Question 71: When an ACK frame is not received by the transmitting STA, w...
Question 72: An 802.11 based network uses an AP and has several connectin...
Question 73: What factors will have the most significant impact on the am...
Question 74: The requirement for a WLAN you are installing state that It ...
Question 75: You manage a WLAN with 100 802.1lac access points. All acces...
Question 76: You are selecting antennas for a WLAN operating in the 5 GHz...
Question 77: You have been tasked with creating a wireless link between t...
Question 78: What statement accurately describes the RF cables and connec...
Question 79: A WLAN is implemented using wireless controllers. The Aps mu...
Question 80: In a long-distance RF link, what statement about Fade Margin...
Question 81: What answer correctly completes the following sentence? ____...
Question 82: You are tasked with performing a throughput test on the WLAN...
Question 83: A WLAN transmitter that emits a 50 mW signal is connected to...
Question 84: What ID is typically mapped to an AP's MAC address if a sing...
Question 85: What statement describes the authorization component of a AA...
Question 86: Lynne runs a small hotel, and as a value added service for h...
Question 87: When a client station sends a broadcast probe request frame ...
Question 88: In an 802.11n 2.4 GHz BSS, what prevents each station from u...
Question 89: What standard is referenced into the 802.11-2012 specificati...
Question 90: The center frequency of channel 1 in the 2.4 GHz band is 2.4...