<< Prev Question Next Question >>

Question 55/60

You are deploying a WLAN with the access points configured for 10 mW of output power on the 2.4 GHz radios and 20mW of output power on the 5GHz radios. Some semi-directional antennas are also in use.
What kind of deployment is described?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (60q)
Question 1: When an ACK frame is not received by the transmitting STA, w...
Question 2: During a post-implementation survey, you have detected a non...
Question 3: To ease user complexity, your company has implemented a sing...
Question 4: You are tasked with performing a throughput test on the WLAN...
Question 5: What 802.11 network configuration would result in multiple s...
Question 6: When a client station sends a broadcast probe request frame ...
Question 7: What statement about the IEEE 802.11-2016 QoS facility is tr...
Question 8: You are managing a wireless access point in autonomous mode ...
Question 9: What is the most effective method of testing roaming in rela...
Question 10: What statement about 802.3, Clause 33 Power over Ethernet is...
Question 11: You have received a report of poor wireless connections on t...
Question 12: The center frequency of channel 1 in the 2.4 GHz band is 2.4...
Question 13: What is the final step in an effective troubleshooting proce...
Question 14: An RF sigma sometimes bends as it passes through some materi...
Question 15: In addition to coverage analysis result, what should be incl...
Question 16: The requirements for a WLAN you are installing state that it...
Question 17: A WLAN is implemented using wireless controllers. The APs mu...
Question 18: What statement about the beamwidth of an RF antenna is true?...
Question 19: You were previously onsite at XYZ's facility to conduct a pr...
Question 20: What can an impedance mismatch in the RF cables and connecto...
Question 21: What security solution is deprecated in the 802.11 standard ...
Question 22: Lynne runs a small hotel, and as a value added for his custo...
Question 23: When implementing PoE, what role is played by a switch?...
Question 24: A client complains of low data rates on his computer. When y...
Question 25: Which directional antenna types are commonly used by indoor ...
Question 26: What wireless networking term describes the increase of RF e...
Question 27: In an 802.11 2.4 GHz system, what 22 MHz channels are consid...
Question 28: You manage a WLAN with 100 802.11ac access points. All acces...
Question 29: You are using a site survey tool for post-implementation val...
Question 30: A non-802.11 device is suspected of causing interference on ...
Question 31: A dual-band 802.11ac AP must be powered by PoE. As a class 4...
Question 32: What factor does not influence the distance at which an RF s...
Question 33: What factor is likely to cause the least impact on the appli...
Question 34: You are implementing a VHT-capable AP. Which one of the foll...
Question 35: What best describes WPA2 in relation to 802.11 wireless netw...
Question 36: You are performing a post-implementation validation survey. ...
1 commentQuestion 37: A WLAN transmitter that emits a 50 mW signal is connected to...
Question 38: Which one of the following is not a factor considered when c...
Question 39: What ID is typically mapped to an AP's MAC address if a sing...
Question 40: You are troubleshooting a client issue on a Windows laptop. ...
Question 41: An IEEE 802.11 amendment is in the daft state. What impact d...
Question 42: You have been tasked with creating a wireless link between t...
Question 43: Your manager asked you to locate a solution that allows for ...
Question 44: What statement describes the authorization component of a AA...
Question 45: You are troubleshooting a client problem with a 2.4 GHz WLAN...
Question 46: You are implementing a multi-AP WLAN and fast secure roaming...
Question 47: You are troubleshooting a problem with interference from a n...
Question 48: Which IEEE 802.11 physical layer (PHY) specification include...
Question 49: What cipher suite is specified by the 802.11-2016 standard a...
Question 50: In a long-distance RF link, which statement about Fade Margi...
Question 51: When compared with legacy Power Save mode, how does VHT TXOP...
Question 52: ABC Company is planning a point-to-multipoint bridge deploym...
Question 53: You are reconfiguring an AP to use the short guard interval....
Question 54: An 802.11-based network uses an AP and has several connectin...
Question 55: You are deploying a WLAN with the access points configured f...
Question 56: You are the network administrator for ABC Company. Your mana...
Question 57: Option 43 must be configured to allow access points to locat...
Question 58: What statement is true concerning the use of Orthogonal Freq...
Question 59: What is appended to the end of each 802.11 data frame after ...
Question 60: What primary metric of scanning can stations use to select t...