<< Prev Question Next Question >>

Question 71/120

Return Loss is the decrease of forward energy in a system when some of the power is being reflected back toward the transmitter.
What will cause high return loss in an RF transmission system, including the radio, cables, connectors and antenna?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (120q)
Question 1: You have been sent as a consultant to a customer site that i...
Question 2: What factors influence the distance that an RF signal can be...
Question 3: XYZ Corporation is experiencing connectivity problems with t...
Question 4: The 802.11 protocol specifies a fundamental channel access m...
Question 5: A WLAN transmitter that emits a 200 mW signal is connected t...
Question 6: What item is essential for performing a manual RF site surve...
Question 7: What is the intended use for the WLAN hardware known as a po...
Question 8: In WLAN security, which authentication method always create ...
Question 9: What is a channel mode specified by the 802.11n (High Throug...
Question 10: You are selecting antennas for a WLAN operating in the 5 GHz...
Question 11: Users and Network support personnel at a mid-sized equipment...
Question 12: In a Wi-Fi client configuration utility, what feature is mos...
Question 13: What features are most often configurable within 802.11 WLAN...
Question 14: In a long-distance RF link, what statement about Fade Margin...
Question 15: What terms accurately complete the following sentence? The I...
Question 16: If an 802.11 RF transmission reaches a receiving antenna sim...
Question 17: As XYZ Company's wireless specialist, you have been asked to...
Question 18: Which antenna types are commonly used by indoor Wi-Fi device...
Question 19: What statements about the beamwidth of an RF antenna are tru...
Question 20: When replacing the antenna of a WLAN device with a similar a...
Question 21: In an enterprise WLAN, what condition will prevent a dual-ba...
Question 22: You are an independent contractor, hired to perform an indoo...
Question 23: What problems may exist for a multiple channel architecture ...
Question 24: You are being interviewed by ABC Company for employment as a...
Question 25: Your consulting firm has recently been hired to complete a s...
Question 26: When compared with legacy Power Save mode, how does VHT TXOP...
Question 27: What feature was introduced in the 802.11h amendment in orde...
Question 28: An 802.11 WLAN transmitter that emits a 50 mW signal is conn...
Question 29: During the discovery and connectivity process, client and AP...
Question 30: XYZ Company has decided to install an 802.11 WLAN system tha...
Question 31: To ease user complexity, your company has implemented a sing...
Question 32: What phrase correctly completes the following sentence? When...
Question 33: What advantages does using predictive site survey modeling s...
Question 34: ABC Company has just purchased a 6 dBi patch antenna. After ...
Question 35: As a consultant, you've been hired by XYZ Company to provide...
Question 36: As a consultant, you have been hired by ABC Company to imple...
Question 37: Two co-located 802.11b/g/n APs can interfere with one anothe...
Question 38: The IEEE 802.11-2012 standard requires VHT capable devices t...
Question 39: What component of the 802.11 standard allows stations to res...
Question 40: What facts are true regarding controllers and APs in a Split...
Question 41: What answers correctly complete the following sentence? ____...
Question 42: What type of device often causes interference across 50% or ...
Question 43: What mechanisms are specified by the IEEE 802.11 standard to...
Question 44: What standard is referenced into the 802.11-2012 specificati...
Question 45: What features were introduced in the IEEE 802.11h amendment ...
Question 46: When a client station sends a broadcast probe request frame ...
Question 47: Which one of the following frequency ranges is not specified...
Question 48: When a client moves to a new BSS within an ESS, what step is...
Question 49: What feature(s) are most likely to be supported by 802.11 en...
Question 50: You are onsite with a client to perform a post-deployment si...
Question 51: In an 802.11n 2.4 GHz BSS, what prevents each station from u...
Question 52: What problem may exist for a multiple channel architecture (...
Question 53: What is always required to establish a high quality 2.4 GHz ...
Question 54: What statements accurately describe the RF cables and connec...
Question 55: What cause of hidden nodes within a BSS would be more likely...
Question 56: Which features are incorporated in the 802.11-2012 specifica...
Question 57: What answer correctly completes the following sentence? ____...
Question 58: What phrase defines Equivalent Isotropically Radiated Power ...
Question 59: What factors are likely to cause the greatest impact on the ...
Question 60: ABC Company has a 2.4 and 5 GHz WLAN deployment. DFS functio...
Question 61: How is throughput capacity scaled in a single channel archit...
Question 62: As a station moves away from the access point to which it is...
Question 63: ABC Company is planning a point-to-multipoint outdoor bridge...
Question 64: Two co-located 802.11b/g/n APs can interfere with one anothe...
Question 65: You were previously onsite at XYZ's facility to conduct a pr...
Question 66: What statement accurately describes the RF cables and connec...
Question 67: What problems may occur when there are hidden nodes in the B...
Question 68: Which unit of measurement is an absolute unit that is used t...
Question 69: The client devices that connect to your network include a mi...
Question 70: What factors are taken into account when calculating the Lin...
Question 71: Return Loss is the decrease of forward energy in a system wh...
Question 72: ABC Hospital is planning a Wi-Fi infrastructure upgrade wher...
Question 73: AP-1 is a 3x3:2 AP. STA-3 is a 3x3:3 client. What is the max...
Question 74: What three cipher suites are specified by the IEEE 802.11-20...
Question 75: What statements describe industry practices for communicatio...
Question 76: Why is it recommended for a wireless network administrator t...
Question 77: XYZ Company has hired you to perform an indoor site survey o...
Question 78: The IEEE 802.11-2012 standard requires VHT capable devices t...
Question 79: A company has hired you to perform a pre-deployment site sur...
Question 80: What HT technology requires MIMO support on both the transmi...
Question 81: In a single channel architecture (SCA) WLAN system, 802.11n ...
Question 82: When using an RF splitter to connect one transceiver to sect...
Question 83: What parameter of the client driver should be configured on ...
Question 84: What factors will have the most significant impact on the am...
Question 85: When designing a WLAN infrastructure implementation for high...
Question 86: What factors will have the most significant impact on the am...
Question 87: Prior to association, what parameter can 802.11 client devic...
Question 88: As an RF wave propagates through space, the wave front exper...
Question 89: In an infrastructure Basic Service Set (BSS), how does the p...
Question 90: You are using a tool that allows you to see signal strength ...
Question 91: In addition to coverage analysis results, what should be inc...
Question 92: ABC Company has thousands of Wi-Fi users accessing their net...
Question 93: As defined in the 802.11 specification, legacy Power Save re...
Question 94: What are two channel modes specified by the 802.11n (High Th...
Question 95: Which IEEE 802.11 physical layer (PHY) specifications includ...
Question 96: What statement about the IEEE 802.11e QoS facility is true?...
Question 97: Which data rate is supported by 802.11g radios that is not s...
Question 98: What word describes the bending of an RF signal as it passes...
Question 99: A Wi-Fi Alliance interoperability certificate indicates that...
Question 100: What WLAN system feature is required to produce a scenario w...
Question 101: The IEEE 802.11a/n/ac physical layer technologies utilize th...
Question 102: What term describes the effect of increasing the intensity o...
Question 103: Lynne runs a small hotel, and as a value added service for h...
Question 104: For what likely reasons might an organization choose to purc...
Question 105: In an 802.11n 2.4 GHz BSS, what prevents each station from u...
Question 106: What statement about 802.3-2012, Clause 33 Power over Ethern...
Question 107: The network administrator at XYZ Company recently attended a...
Question 108: What causes of hidden nodes within a BSS would be more likel...
Question 109: When a client moves to a new BSS within an ESS, what steps a...
Question 110: When performing a site survey for a Multiple Channel Archite...
Question 111: What is a common feature of an 802.11 WLAN client utility? (...
Question 112: The OSI model is a 7-layer model for understanding the funct...
Question 113: In addition to throughput enhancements, what other improveme...
Question 114: In an 802.11 2.4 GHz system, what 22 MHz channels are consid...
Question 115: What information is transmitted in the Beacon management fra...
Question 116: Which of the following frequency ranges are specified for us...
Question 117: What term correctly completes the following sentence? In an ...
Question 118: You are the network administrator for ABC Company. Your mana...
Question 119: Which answer correctly completes the following sentence? The...
Question 120: What statements about the SSID are true? (Choose 2)...