<< Prev Question Next Question >>

Question 20/131

You told your customer that multipath fading may be mitigated simply by moving one or both of the receivers antennas a small amount, usually by one to four wavelengths away from its original position. Your customer is prepared to make the change, but does not know the wavelength for
802.11ac.
What is the approximate wavelength of an 802.11ac radio wave?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (131q)
Question 1: What are the two most common industry-standard protocols use...
Question 2: Which of the following items could be considered constraints...
Question 3: A business traveler from North America is in Europe. The hot...
Question 4: Given: The 802.11ac APs you have selected for your public ac...
Question 5: What might limit the ability to locate 802.11 clients using ...
Question 6: The thermal noise is at #174 dBm/Hz. A spectrum analyzer has...
Question 7: An engineering firm just upgraded their WLAN form nine 802.1...
Question 8: While configuring your site survey software for an upcoming ...
Question 9: What statements are true regarding jitter and latency?(Choos...
Question 10: SSID hiding is not generally recommended because some frames...
Question 11: What is the purpose of DHCP Option 43, and how is it used wi...
Question 12: In high-density environments, such as stadiums and conventio...
Question 13: What is a typical characteristic of barcode scanners?...
Question 14: A wireless engineer from your company performed a site surve...
Question 15: The installation crew for your WLAN project wants to install...
Question 16: You are selecting external antennas for use in a bridge link...
Question 17: As a device starts to shift to lower PHY rates, what factors...
Question 18: What inexpensive tool is capable of locating neighbor WLANs ...
Question 19: A cable with 2.5 dB of loss is used to measure the return lo...
Question 20: You told your customer that multipath fading may be mitigate...
Question 21: In most WLAN design tools, after defining project parameters...
Question 22: In addition to a copy of your design, which tools should you...
Question 23: In this question, you will compare the mobility processes of...
Question 24: What type of standards-based encryption is used by office ex...
Question 25: When performing a spectrum analysis walkthrough of a facilit...
Question 26: What type of protection should be provided to outdoor antenn...
Question 27: Using a SCA means that all APs will be using the same channe...
Question 28: After importing a floor plan to a predictive design tool, wh...
Question 29: What functions may be performed by a WIPS?(Choose all that a...
Question 30: Your customer requires a security solution in which client c...
Question 31: A customer wants to deploy a WLAN that employs centralized f...
Question 32: What are methods of providing RF high availability? Response...
Question 33: What is the purpose of a Physical Installation Guide documen...
Question 34: What VoWiFi implementations frequently require multicast pac...
Question 35: When designing a static channel plan for an office using voi...
Question 36: During a customer walkthrough you notice an area of the CAD ...
Question 37: You are working on a VoWLAN design with your customer's wire...
Question 38: You desire to achieve a 450 Mbps MCS. What 802.11n features ...
Question 39: A controller-based WLAN infrastructure has its controller on...
Question 40: What kind of site survey helps you identify if roaming is wo...
Question 41: During an RFP analysis, one of the vendors mentioned that yo...
Question 42: A museum wants to offer Wi-Fi to its visitors. One of their ...
Question 43: If radar has reportedly been detected on your WLAN deploymen...
Question 44: What might limit the ability to locate 802.11 clients using ...
Question 45: In an RSN requiring low-latency reassociations and no fast s...
Question 46: For what purposes are VPNs typically used in modern WLANs?(C...
Question 47: You are testing a VoWLAN deployment, and your communication ...
Question 48: What limitation exists when WMM is not enabled on an 802.11n...
Question 49: You are designing a WLAN and nave been asked to recommend a ...
Question 50: When creating a long-distance bridge link, it is important t...
Question 51: In what circumstance would you not enable DFS channels on a ...
Question 52: Which DHCP option, when required, should be configured and e...
Question 53: During a validation site survey, you realize that the instal...
Question 54: A business traveler from North America is in Europe. The hot...
Question 55: What advantage provided by 802.11n and 802.11ac is not usabl...
Question 56: You are planning for client devices in a WLAN that is be upg...
Question 57: Who should be in the final meeting from the customer-side af...
Question 58: When viewing channel utilization information from a protocol...
Question 59: Given: A WLAN controller is connected to ABC Company's core ...
Question 60: What commonly used item can help lo prevent back pain during...
Question 61: In your company's WLAN, you expect to have a mixed client PH...
Question 62: Given: In a site survey deliverable report, you are expected...
Question 63: When designing for a PTP outdoor link, what important consid...
Question 64: What are the three biggest WLAN enterprise verticals?(Choose...
Question 65: When you see the SKINNY protocol in a post-install validatio...
Question 66: What is an advantage of centralized data forwarding?...
Question 67: During a validation site survey, you realize that the instal...
Question 68: During lunch time in the break room of a company, Wi-Fi conn...
Question 69: When live video streaming solutions that transmit simultaneo...
Question 70: Before performing a pre-deployment passive RF survey of a ne...
Question 71: What document can be useful when determining client capabili...
Question 72: What is the chip rate of 1 Mbps 802.11b? Response:...
Question 73: What differences exist between VLANs in wireless and wired d...
Question 74: In the enterprise, when is WPA/WPA2-Personal generally a rec...
Question 75: What statement is true of a WLAN design that supports Real-T...
Question 76: What is the most suitable antenna option to be used when des...
Question 77: What is the meaning of a Real Time FFT graph?...
Question 78: Which one of the following might be detected as a source of ...
Question 79: What are the deliverables to your customer after successfull...
Question 80: When doing some frame capturing over the air during a voice ...
Question 81: What is the DSCP Per Hop Behavior equivalent classification ...
Question 82: A museum wants to offer Wi-Fi to its visitors. One of their ...
Question 83: Given: You are evaluating the theoretical and real-world RF ...
Question 84: Location technology (RTLS) can use which of the following me...
Question 85: What is a radome?
Question 86: What are some common problems with short (12 or fewer charac...
Question 87: A WLAN that you designed has been deployed in one area, user...
Question 88: In a convention center, you have received complaints about t...
Question 89: When troubleshooting coverage issues for a wireless network ...
Question 90: You must perform a site survey that defines signal strength,...
Question 91: While performing a validation site survey, you realize that ...
Question 92: What action should be taken after implementing a WLAN based ...
Question 93: What best describes ensuring coverage requirements in a depl...
Question 94: Which definition correctly describes the "local MAC" variati...
Question 95: When installing APs on high ceilings, what should be the mos...
Question 96: Excessive uplink RTP frame retransmissions can result in ___...
Question 97: You have enabled IEEE 80211 FT in your WLAN infrastructure. ...
Question 98: Your customer is using PSK as their only authentication. The...
Question 99: What factors are key features when designing a guest network...
Question 100: Of the following antenna connector types, which one is the s...
Question 101: For what purpose is SSID hiding generally useful?(Choose all...
Question 102: You're about to deploy an Enterprise-class VoWLAN infrastruc...
Question 103: Left to its simplest form, what method does a location algor...
Question 104: What document is typically created to launch a project?...
Question 105: An enterprise customer is subject to the highest standards f...
Question 106: When a WLAN controller sends an 802.11 frame to a lightweigh...
Question 107: NicoCo is building a new facility and would like to install ...
Question 108: A table of VLANs in a _________ document should include what...
Question 109: What method improves throughput in a low SNR environment? Re...
Question 110: Which operational plane would be responsible for performing ...
Question 111: What part of the 802.11n preamble is used by the receiver to...
Question 112: Aesthetics are very important in some environments. What com...
Question 113: One of your customers plans on providing wireless coverage t...
Question 114: As an implementation engineer, you have just received initia...
Question 115: During a post-deployment verification, you are requested to ...
Question 116: For an antenna 35 dBi of gain is needed. What antenna type s...
Question 117: What is the purpose of defining wall materials in WLAN desig...
Question 118: You are validating association capabilities from clients to ...
Question 119: During lunch time in the break room of a company, Wi-Fi conn...
Question 120: A designer has created a WLAN design that has been implement...
Question 121: To ensure that your design meets the requirements of the WLA...
Question 122: What frequency and power did 802.11y provide? Response:...
Question 123: When using a predictive design tool, you have selected APs w...
Question 124: Which one of the following is an essential metric to measure...
Question 125: In a multiple channel architecture (MCA) network supporting ...
Question 126: In a PC-based spectrum analyzer, what data chart identifies ...
Question 127: You have determined the best mounting locations for APs in a...
Question 128: As you plan a WLAN upgrade, you have assessed the network re...
Question 129: What are some significant drawbacks that are present with WP...
Question 130: As a device starts to shift to lower PHY rates, what factors...
Question 131: When selecting a centralized WLAN architecture, what new pro...