FreeCram
  1. Home
  2. BICSI
  3. BICSI Installer 2 - Copper Exam
  4. BICSI.INSTC_V7.v2023-05-29.q37
  5. Question 28
<< Prev Question Next Question >>

Question 28/37

Which of the following are typically used to support cables between a cable tray and work area outlets?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (37q)
Question 1: Which of the following is used to express system gain and lo...
Question 2: What is the primary purpose of firestopping?...
Question 3: Which of the following steps should be performed first when ...
Question 4: Which of the following describes a nonmechanical firestop sy...
Question 5: If the situation requires, a conduit should be terminated __...
Question 6: What is the maximum number of work areas that a CP should se...
Question 7: What is the maximum permissible amount of untwisting for cat...
Question 8: Which of the following markings is used for non-conductive o...
Question 9: Which of the following is designed to provide protection fro...
Question 10: Which is a keyed, contact, moderate loss connector in presen...
Question 11: Which of the following should be used to prevent the cable f...
Question 12: Which of the following connector styles is presently used wi...
Question 13: Which of the following terms describes the ration of the pow...
Question 14: Which of the following should be used to install plywood in ...
Question 15: Which of the following refers to a set of rules issued by a ...
Question 16: How far should the top of a ladder extend above the roofline...
Question 17: Unqualified workers must stay AT LEAST ____ from exposed ene...
Question 18: Which of the Two organizations jointly oversee the worldwide...
Question 19: What is the minimum inside bend radius for balanced twisted ...
Question 20: How much cable slack should be left in the work area after t...
Question 21: What is the required physical topology for a SCS?...
Question 22: Which of the following PPE items MUST be worn at all times w...
Question 23: Which of the following is used to connect cabinets to the ne...
Question 24: A purple backboard should be used to identify ________?...
Question 25: What is the maximum allowable horizontal cable length?...
Question 26: Two truck drivers are communicating over a Citizens Band (CB...
Question 27: A third 90-degree bend may be permitted in a conduit run if ...
Question 28: Which of the following are typically used to support cables ...
Question 29: Which of the following is used to measure the length of a 4-...
Question 30: What is the bend radius requirement for optical fiber cable ...
Question 31: What is the primary purpose of the telecommunications bondin...
Question 32: Which of the following fire ratings refers to the time perio...
Question 33: What is the specified performance level for Category 8 cable...
Question 34: What is the maximum pull force for four-strand optical fiber...
Question 35: What is the minimum number of consolidation points that shou...
Question 36: What type of coaxial cable is used for video backbone distri...
Question 37: What grade of plywood is recommended for use with ICT system...