FreeCram
  1. Home
  2. BICSI
  3. BICSI Installer 2 - Copper Exam
  4. BICSI.INSTC_V7.v2022-12-23.q40
  5. Question 35
<< Prev Question Next Question >>

Question 35/40

During the troubleshooting phase, what is the first step?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (40q)
Question 1: Which of the following topologies is the recommended topolog...
Question 2: Which of the following is used to equalize potential differe...
Question 3: Which of the following tend to cause sheath damage during ca...
Question 4: Which of the following combinations is used to identify the ...
Question 5: Which of the following is used to connect cabinets to the ne...
Question 6: Which of the following markings indicates that the cable is ...
Question 7: Which of the following connector styles is presently used wi...
Question 8: Which of the following PPE items MUST be worn at all times w...
Question 9: What is the specified performance level for Category 8 cable...
Question 10: Which of the following is the primary benefit of using wall-...
Question 11: Which of the following is a property of an electromagnetic f...
Question 12: Volts are measurement of _______?...
Question 13: What type of connector is used with ribbon cable?...
Question 14: Which of the following items may be used as a substitute dev...
Question 15: During a retrofit, an installation crew discovers old insula...
Question 16: Which of the following markings is used for non-conductive o...
Question 17: Fall protection is required whenever a person is exposed to ...
Question 18: Which of the following is permissible if the available fires...
Question 19: What is the required physical topology for a SCS?...
Question 20: Which of the following are typically used to support cables ...
Question 21: How far should the top of a ladder extend above the roofline...
Question 22: Which of the following is the bonding connection point for t...
Question 23: Which of the following types of construction protects the op...
Question 24: Which of the following must be measured before the length of...
Question 25: Which of the following interconnects the PBB to the SBB?...
Question 26: How long does it take someone to form a first impression?...
Question 27: What is the minimum inside bend radius for balanced twisted ...
Question 28: A radio station transmits an omnidirectional signal that is ...
Question 29: Which pair of a 100-ohm balanced twisted pair patch cable ha...
Question 30: What is the primary purpose of an electrical grounding syste...
Question 31: Light pulses in optical fiber cables are subjected to a loss...
Question 32: What is the primary purpose of the telecommunications bondin...
Question 33: Which of the following is a floor serving space that serves ...
Question 34: Which of the following is designed to provide protection fro...
Question 35: During the troubleshooting phase, what is the first step?...
Question 36: A third 90-degree bend may be permitted in a conduit run if ...
Question 37: If you are working on a catwalk, you are required to wear __...
Question 38: What is the minimum recommended height that should be used w...
Question 39: Which of the following make the biggest impression on a cust...
Question 40: Which of the following terms describes the ration of the pow...