<< Prev Question Next Question >>

Question 100/153

(group8) #show ap active
Active AP Table
---------------
Name Group IP Address 11g Clients 11g Ch/EIRP/MaxEIRP 11a Clients 11a Ch/EIRP/MaxEIRP
---- ----- ---------- --------- ------------------- ----------- ------------------- AP1 building1 10.1.80.150 0 AM 0 AM AP2 building1 10.1.80.151 0 AM 0 AM
A user called technical support because they cannot see any of their APs in building one. You perform the
"show" command as illustrated above.
What can you conclude about these two APs from this output?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (153q)
Question 1: Which dual radio access point models support concurrent oper...
Question 2: An access port has been placed in trusted mode. The Vlan on ...
Question 3: Which profiles are required in an AP Group to enable an SSID...
Question 4: Which netdestination aliases are built into the controller? ...
Question 5: How does an Aruba infrastructure calculate a wireless device...
Question 6: Exhibit: (Exhibit) Based on the above screen capture for Int...
Question 7: By default, which CLI based remote access method is enabled ...
Question 8: A Remote AP provisioned in "Split-Tunnel" Forwarding mode ha...
Question 9: What are the Airtime Allocation Policy options for Airtime F...
Question 10: What information do you need to generate a feature license k...
Question 11: Which command, when executed on a master controller, will sh...
Question 12: When the controller is configured for Captive Portal and the...
Question 13: As an admin/root user, what other type of role-based managem...
Question 14: A Remote AP provisioned with an SSID in "Bridged" forwarding...
Question 15: Aruba pair of 3200XM controllers are licensed to their maxim...
Question 16: Which of the following could be used to set a user's post-au...
Question 17: Which is a Device Specific Attribute that can be evaluated i...
Question 18: Which of the statements below are TRUE regarding ARM's Spect...
Question 19: An administrator wants to assign a VLAN to a user based upon...
Question 20: Which method can APs use to discover a controller?...
Question 21: Which describe "roles" as used on Aruba Mobility Controllers...
Question 22: In the diagram provided for this question, the wireless user...
Question 23: Which of the following describes a Remote AP provisioned in ...
Question 24: A network administrator wants to terminate VPN sessions on a...
Question 25: Aruba Client Match does NOT use which of the following param...
Question 26: How does the ARM Band Steering feature encourage 5GHz capabl...
Question 27: What settings need to be changed on a factory default AP in ...
Question 28: An 7240 controller is Licensed for 560 APs. The controller h...
Question 29: An Aruba 650 controller is functioning as a standby Master. ...
Question 30: Which of the following will accept named VLANs as a paramete...
Question 31: A 3600 controller has 64 PEF-NG license, 128 AP licenses and...
Question 32: Which of the following licenses can be included in the licen...
Question 33: An Aruba controller is configured with the correct IP addres...
Question 34: Which parameter(s) does a Master controller use to determine...
Question 35: What are the types of user derivation rules that can be appl...
Question 36: What are aliases used for?
Question 37: Referring to the diagram provided for this question, represe...
Question 38: When configuring Captive Portal, which protocols are support...
Question 39: Which of the following metrics does the ARM feature use to c...
Question 40: A wired device is connected to an untrusted port on a contro...
Question 41: When an 802.11 client roams what device decides when to move...
Question 42: When direct consoled to an AP, what is the command sequence ...
Question 43: How many Aruba controllers can be added to a single mobility...
Question 44: (group8) #show ap arm history ap-name AP1 Interface :wifi0 A...
Question 45: A controller is provisioned in L3 Mode for Wireless Users. W...
Question 46: Which of the following parameters can be specified in a rule...
Question 47: When an Aruba 6000 controller has two M3 modules installed, ...
Question 48: Which of the following Aruba controllers is able to provide ...
Question 49: With Fast-Failover disabled, to which IP address should the ...
Question 50: View the Server group and User Roles screen shots above. (Ex...
Question 51: Referring to the diagram provided for this question, an empl...
Question 52: Where should mobility domains be enabled in a network with 1...
Question 53: In the above diagram, the system shows two Aruba access poin...
Question 54: IEEE 802.11r provides support for which of the following:...
Question 55: When configuring a server group containing 3 servers, a cust...
Question 56: A Remote AP was properly functioning before losing it's inte...
Question 57: Which of the following are NOT valid RAP forwarding modes? (...
Question 58: View the Server group screen shot above. (Exhibit) A company...
Question 59: The screen captures above show the 802.1X authentication pro...
Question 60: A company purchased an indoor mesh deployment using the 620 ...
Question 61: A university has 2 departments. Department 1 has its own mob...
Question 62: An administrator creates a WLAN with an unmodified default A...
Question 63: The Aruba Policy Enforcement Firewall (PEF) module supports ...
Question 64: With CPSec disabled, which encryption protocol does a tunnel...
Question 65: In an Aruba controller based system, the L3 mobility tunnel ...
Question 66: Referring to the diagram provided for this question, an empl...
Question 67: What is the best practice regarding licensing for a backup m...
Question 68: As illustrated in the above diagram and screen capture, a wi...
Question 69: A campus AP has been provisioned with a VAP in bridge forwar...
Question 70: Refer to the following configuration segment for this item. ...
Question 71: Referring to the diagram provided for this question, an empl...
Question 72: When configuring ports in the Controller wizard, which of th...
Question 73: Which log type should be enabled to troubleshoot IPSec authe...
Question 74: With CPSec disabled, which tunnel protocol is used between A...
Question 75: What does Aruba Layer 3 redundancy require to operate?...
Question 76: Refer to the above screen capture. (Exhibit) By default, whi...
Question 77: Exhibit: (Exhibit) The above diagram has one master and thre...
Question 78: The reusable Aruba Controller wizards are accessible in what...
Question 79: Masters communicate configuration information with locals us...
Question 80: Which of the following licenses are consumed by Mesh APs adv...
Question 81: Which of the following configurations can accept a VLAN pool...
Question 82: An AP 105 was converted into a RAP. The RAP can authenticate...
Question 83: Which of the following APs do NOT support dual radio operati...
Question 84: The Aruba Policy Enforcement Firewall (PEF-NG) module suppor...
Question 85: A client device associates with an SSID provisioned with 802...
Question 86: The network administrator wishes to terminate the VPN encryp...
Question 87: Review the following truncated output from an Aruba controll...
Question 88: With CPSec enabled, which tunnel protocol is used between AP...
Question 89: Centralized licensing is not in use on an Aruba based networ...
Question 90: In the diagram provided for this question, the Aruba control...
Question 91: Which of the following statements is true?...
Question 92: With CPSec disabled, Aruba access points are Layer 3 connect...
Question 93: Which of the following are valid RAP operating modes?...
Question 94: A port firewall policy is applied to a trunk port that denie...
Question 95: A user connected to a Captive Portal VAP successfully. When ...
Question 96: The screen captures above show the 802.1X authentication pro...
Question 97: One hundred (100) additional APs were deployed in an existin...
Question 98: An administrator is setting up a factory default controller....
Question 99: Which of the following statements is true of Spectrum Mode?...
Question 100: (group8) #show ap active Active AP Table --------------- Nam...
Question 101: A customer forgot all passwords for a controller. What metho...
Question 102: In the above diagram, the system shows two Aruba access poin...
Question 103: Which protocol does the Aruba controller utilize for control...
Question 104: If a Remote AP (RAP) is attempting to contact a controller t...
Question 105: When APs boot up, in which order do they discover a controll...
Question 106: The screen captures below show the 802.1X authentication pro...
Question 107: The Contrtoller wizard enables which of the following contro...
Question 108: What are two different methods of configuring AP redundancy ...
Question 109: An AP is not communicating with the controller. Upon investi...
Question 110: What is the purpose of Mesh Clusters?...
Question 111: A customer has a remote AP deployment, where each remote AP ...
Question 112: Refer to the following configuration segment for this item. ...
Question 113: How is an AP redirected to a Local controller after DNS reso...
Question 114: What is the maximum number of remote APs supported by a 3600...
Question 115: As illustrated in the above diagram, a company has two campu...
Question 116: Which of the following firewall rules allows a user to initi...
Question 117: Which actions does ARM (Adaptive Radio Management) perform? ...
Question 118: The permanent licenses on the controller will be deleted wit...
Question 119: A client device associates with an SSID provisioned with 802...
Question 120: Which method is NOT supported to provision an Aruba campus A...
Question 121: Which of the following commands is most useful in showing th...
Question 122: Which of these are NOT a client attribute that can be config...
Question 123: Screenshots of the Captive Portal authentication profile and...
Question 124: What can an AM do that an AP cannot do?...
Question 125: An Aruba controller can be accessed with which CLI based rem...
Question 126: What is the first role a user is given when a user associate...
Question 127: Exhibit: (Exhibit) Referring to the diagram provided for thi...
Question 128: A 3200 controller has 16 AP licenses,16 PEF-NG licenses, 16 ...
Question 129: A client attaches to a secure jack interface set to untruste...
Question 130: Exhibit: (Exhibit) In the diagram provided for this question...
Question 131: An Aruba Controller is configured with VLAN 1,5, 200, and 40...
Question 132: When deploying Remote Mesh Portals, what is one of the purpo...
Question 133: In the above screen capture: (Exhibit) The administrator not...
Question 134: ip access-list session anewone user network 10.1.1.0 255.255...
Question 135: An AP was configured and assigned to an AP group then powere...
Question 136: Exhibit: (Exhibit) Referring to the above screen capture, on...
Question 137: A port on a controller has been configured as untrusted. No ...
Question 138: Exhibit: (Exhibit) Referring to the above screen capture, on...
Question 139: What are the PEF-NG license limits based on?...
Question 140: Centralized licensing is not enabled in a network of 1 Maste...
Question 141: In the diagram provided for this question, four buildings ar...
Question 142: By default, how long will an AP scan a single channel when A...
Question 143: Which match condition can be used by a server derivation rul...
Question 144: A Remote AP provisioned in "Split-Tunnel" Forwarding mode ha...
Question 145: When configuring split tunnel mode on a Remote AP (RAP) wher...
Question 146: Exhibit: (Exhibit) Referring to the above screen capture, if...
Question 147: Which command will show all client association history?...
Question 148: Which settings cannot be modified directly from a local cont...
Question 149: Which of the following will occur if a master license server...
Question 150: Exhibit: (Exhibit) Referring to the above screen capture, on...
Question 151: An Aruba based network has a Master and four local controlle...
Question 152: Which of the following functions can be configured in the Co...
Question 153: View the Server group and User Roles screen shots above. (Ex...