4A0-M01 Exam Dumps | Click on the exhibit (Exhibit) Given the configurations shown and the following information: * Multilayer

Home
Alcatel-Lucent
Alcatel-Lucent IP/MPLS Mobile Backhaul Transport
Alcatel-Lucent.4A0-M01.v2019-05-05.q91
Question 73

Valid 4A0-M01 Dumps shared by ExamDiscuss.com for Helping Passing 4A0-M01 Exam! ExamDiscuss.com now offer the newest 4A0-M01 exam dumps, the ExamDiscuss.com 4A0-M01 exam questions have been updated and answers have been corrected get the newest ExamDiscuss.com 4A0-M01 dumps with Test Engine here:

Access 4A0-M01 Dumps Premium Version
(150 Q&As Dumps, 35%OFF Special Discount Code: freecram)

<< Prev Question Next Question >>

Question 73/91

Click on the exhibit

Given the configurations shown and the following information:
* Multilayer Switch (MLS) 1 and 2 host duplicate Virtual Private Routed Network (VPRN) services.
* Configured on the interfaces L3_VLAN402 is Virtual Router ID (VRID) 1 Your customer states that if the master interface fails and recovers, they want traffic to remain on the VRID backup interface.
What must you change in the configuration shown to keep the VRID from moving traffic back to the master?

A. set MLS1 interface L3_VLAN402 to priority 255

B. set a revert time value of infinity

C. set both interface priorities to the default

D. configure no preempt in the VRID

Correct Answer: D

Your email address will not be published. Required fields are marked *

Comment: *

Name: *

Email: *

Rating: *

Verification: *

Question List (91q): Question 1: Click on the exhibit. (Exhibit) Consider the topology and ML...; Question 2: Which statement correctly describes Alcatel-Lucent SROS Mult...; Question 3: Click on the exhibit. (Exhibit) Considering the configuratio...; Question 4: Click on the exhibit (Exhibit) Given the diagram shown and t...; Question 5: Click on the exhibit. Given the diagram. (Exhibit) On the ML...; Question 6: Click on the exhibit. (Exhibit) Given the show result shown,...; Question 7: What function does a Backhaul Transport Provider (BTP) Aggre...; Question 8: Click on the exhibit (Exhibit) Given the diagram shown, and ...; Question 9: In IEEE 1588v2 two-way synchronization operating mode, which...; Question 10: A Synchronization Ethernet (SyncE)/Synchronization Status Me...; Question 11: Click on the exhibit (Exhibit) Given the configuration examp...; Question 12: A Synchronization Ethernet (SyncE)/Synchronization Status Me...; Question 13: Click on the exhibit. (Exhibit) Given the configuration show...; Question 14: Which statement is true concerning aPipe ATM cell mode versu...; Question 15: Click on the exhibit (Exhibit) Which statement correctly des...; Question 16: Which statement correctly describes Virtual Routing and Redu...; Question 17: Click on the exhibit (Exhibit) Given the diagram shown, and ...; Question 18: Click on the exhibit. (Exhibit) Given the configurations sho...; Question 19: In a mobile backhaul network, which component belongs to the...; Question 20: Which statement correctly describes a Versatile Service Modu...; Question 21: Which IEEE 1588v2/Precision Time Protocol (PTP) v2 message c...; Question 22: Click on the exhibit. Given the show command results and the...; Question 23: Click on the exhibit. (Exhibit) Based on the default SROS Bo...; Question 24: Which statement best describes phase synchronization as it i...; Question 25: Click on the exhibit. (Exhibit) Given the show command resul...; Question 26: Click on the exhibit. (Exhibit) Given the show command resul...; Question 27: Click on the exhibit (Exhibit) Given the diagram and the fol...; Question 28: Click on the exhibit. (Exhibit) Given the show command resul...; Question 29: Which statement correctly describes bi-directional Automatic...; Question 30: As cells enter an aPipe service configured for vc-type atm-v...; Question 31: Click on the exhibit (Exhibit) Given the show command result...; Question 32: Which statement correctly describes redundant ePipe service ...; Question 33: Which statement correctly describes the IEEE 1588v2 two-way ...; Question 34: Given the following: * A 3G base station connects to an aPip...; Question 35: Which statement correctly describes a Point-to-Point (PPP) M...; Question 36: A Versatile Services Module (VSM) Cross Connect ID (CCID) ca...; Question 37: Click on the exhibit (Exhibit) Given the diagram shown, and ...; Question 38: Click on the exhibit. Given the show result shown: (Exhibit)...; Question 39: Which IEEE 1588v2 two-step clock message allows the slave to...; Question 40: With which message type does an IEEE l583v2/Precision Time P...; Question 41: Click on the exhibit. (Exhibit) Consider the topology and ML...; Question 42: Choose the two SAP identifiers that a Cross Connect ID (CCID...; Question 43: Once an IEEE 1588v2/Precision Time Protocol (PTP) v2 clock i...; Question 44: Which command example correctly configures a 7750 Service Ro...; Question 45: Which statement correctly describes TDM port configuration f...; Question 46: Which statement is correct concerning spoke SDP use in point...; Question 47: Which is an important design consideration when deploying pa...; Question 48: Click on the exhibit. Given the topology shown: (Exhibit) Th...; Question 49: If an IEEE 1588v2/Precision Time Protocol (PTP) v2 slave tim...; Question 50: Click on the exhibit Given the configuration shown: (Exhibit...; Question 51: Click on the exhibit. (Exhibit) Each numbered item, 1, 2, 3,...; Question 52: Click on the exhibit. Given the local Provider Edge (PE) rou...; Question 53: Click on the exhibit. Given the show command and the result ...; Question 54: Click on the exhibit. (Exhibit) Given the configuration show...; Question 55: An SROS router obtains its timing exclusively from its BITS ...; Question 56: Click on the exhibit (Exhibit) Given the cell site router co...; Question 57: Click on the exhibit (Exhibit) Which statement correctly des...; Question 58: Click on the exhibit (Exhibit) Given the configuration shown...; Question 59: Which statement correctly describes how the Versatile Servic...; Question 60: Which statement correctly describes SROS Virtual Private Wir...; Question 61: Click on the exhibit. Given the show command results and the...; Question 62: As which clock type must an IEEE 1588v2 node operate in orde...; Question 63: Which statement correctly describes Virtual Routing and Redu...; Question 64: You are configuring an ePipe 250 service on the Switching Pr...; Question 65: Click on the exhibit. (Exhibit) Given the configuration show...; Question 66: A 7750 Service Router (SR) receives BITS clocking over a Sup...; Question 67: Click on the exhibit. (Exhibit) Which field in the show comm...; Question 68: Click on the exhibit (Exhibit) Given the diagram and the fol...; Question 69: A network element (NE) forwards external traffic through a V...; Question 70: Which payload type set in a SONET-framed OC-3 port creates i...; Question 71: Which is a characteristic of the IEEE 802.3 Slow Protocol?...; Question 72: Click on the exhibit. (Exhibit) With the information given, ...; Question 73: Click on the exhibit (Exhibit) Given the configurations show...; Question 74: Click on the exhibit. Given the topology and the Multiprotoc...; Question 75: Which field included in the IEEE 802.3 Organization Specific...; Question 76: Click on the exhibit (Exhibit) Given the configuration shown...; Question 77: Click on the exhibit (Exhibit) Given the diagram shown, and ...; Question 78: Which component must you configure on an IEEE 1588v2/Precisi...; Question 79: Click on the exhibit. (Exhibit) You wish to configure a seco...; Question 80: Which statement correctly describes an MSP Aggregation Gatew...; Question 81: Which SAP port and identifier format is correct for use in a...; Question 82: Click on the exhibit. (Exhibit) Given the configuration show...; Question 83: Click on the exhibit. (Exhibit) Given the topology shown: Wi...; Question 84: Click on the exhibit. Given the configuration shown: (Exhibi...; Question 85: Which synchronization technique supports time of day and pha...; Question 86: Click on the exhibit. (Exhibit) Consider the topology and ML...; Question 87: Click on the exhibit. (Exhibit) Given the configuration show...; Question 88: Click on the exhibit. Given the diagram shown: (Exhibit) Whi...; Question 89: Click on the exhibit. (Exhibit) Given the local Provider Edg...; Question 90: Which IEEE 1588v2/Precision Time Prolocol (PTP) v2 message c...; Question 91: Click on the exhibit (Exhibit) Given the show results shown,...

[×]

Download PDF File

Enter your email address to download Alcatel-Lucent.4A0-M01.v2019-05-05.q91.pdf

Email:

Disclaimer:
Freecram doesn't offer Real GIAC Exam Questions. Freecram doesn't offer Real SAP Exam Questions. Freecram doesn't offer Real (ISC)² Exam Questions. Freecram doesn't offer Real CompTIA Exam Questions. Freecram doesn't offer Real Microsoft Exam Questions.
Oracle and Java are registered trademarks of Oracle and/or its affiliates.
Freecram material do not contain actual actual Oracle Exam Questions or material.
Microsoft®, Azure®, Windows®, Windows Vista®, and the Windows logo are registered trademarks of Microsoft Corporation.
Freecram Materials do not contain actual questions and answers from Cisco's Certification Exams. The brand Cisco is a registered trademark of CISCO, Inc.
CFA Institute does not endorse, promote or warrant the accuracy or quality of these questions. CFA® and Chartered Financial Analyst® are registered trademarks owned by CFA Institute.
Freecram does not offer exam dumps or questions from actual exams. We offer learning material and practice tests created by subject matter experts to assist and help learners prepare for those exams. All certification brands used on the website are owned by the respective brand owners. Freecram does not own or claim any ownership on any of the brands.

Question 73/91

LEAVE A REPLY

Download PDF File