FreeCram
  1. Home
  2. Alcatel-Lucent
  3. Alcatel-Lucent Advanced Troubleshooting
  4. Alcatel-Lucent.4A0-110.v2019-05-12.q15
  5. Question 12
<< Prev Question Next Question >>

Question 12/15

What are the typical RIP related issues found during troubleshooting?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (15q)
Question 1: Refer to the diagram below, what encapsulation type and VLAN...
Question 2: L1 ISIS adjacency is up between two routers (Node-1 and Node...
Question 3: Which one of the following routes should be the best BGP rou...
Question 4: Node 1 and Node 2 are directly connected running LDP. The sy...
Question 5: VPRN 300 is configured on Node 3 and Node 4 with LDP and MP-...
Question 6: If a router needs to support services offering of 1514 byte ...
Question 7: VPRN 300 is configured on Node 3 and Node 4 with LDP as the ...
Question 8: Which command should be used to enable automatic synchroniza...
Question 9: What are the possible logging destinations supported on the ...
Question 10: A LSP is configured with one primary path and one secondary ...
Question 11: Two routers are physically connected running ISIS. ISIS L2 a...
Question 12: What are the typical RIP related issues found during trouble...
Question 13: Node A has an active BGP route 10.1.1.1 in its routing table...
Question 14: Which one of the following CLI can be used to view all manag...
Question 15: Node 1 receives some VPRN routes from Node 2, but Node 2 is ...