<< Prev Question Next Question >>

Question 18/23

LSP toNode3 is configured on Node1, all hops configured in the lsp path and lsp destination address are reachable via IGP. Both primary and secondary LSP paths are down with failure code equal toRoute ToDestination. What is the potential cause of this problem?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (23q)
Question 1: Which command should be used to enable automatic synchroniza...
Question 2: Which command is used to view alarms of all severity levels ...
Question 3: Which files have to exist on Compact Flash 3 during system i...
Question 4: Two routers are physically connected to each other with ISIS...
Question 5: A LSP is configured with one primary path and one secondary ...
Question 6: A SDP is created on Node-2 with the far end address set to N...
Question 7: Based on the show display below, what should be done to furt...
Question 8: Which command can be used to view all interfaces configured ...
Question 9: An operator has entered the following CLI commands to config...
Question 10: Based on the following CLI Output, why is the path toPod3-lo...
Question 11: What MPLS tunnel label(s) will be used in the data packet tr...
Question 12: The mesh-sdp binding for a VPLS configured on Node 1 is down...
Question 13: A spoke-sdp terminated IES configured on Node 3 is down due ...
Question 14: What are the possible logging destinations supported on the ...
Question 15: If a router needs to support services offering of 1514 byte ...
Question 16: The LDP session is not down between Node-1 and Node-2. Based...
Question 17: Two direct connected routers are running RIPv2, neighbors ar...
Question 18: LSP toNode3 is configured on Node1, all hops configured in t...
Question 19: Node A has an active BGP route 10.1.1.1 in its routing table...
Question 20: Node 1 receives some VPRN routes from Node 2, but Node 2 is ...
Question 21: A policy is configured to redistribute four active static ro...
Question 22: What are the typical RIP related issues found during trouble...
Question 23: VPRN 300 is configured on Node 3 and Node 4 with LDP as the ...