<< Prev Question Next Question >>

Question 47/91

The FDB has learned 2 MAC addresses. The first is from a device accessible via a locality defined SAP, the second is from a device accessible via an SDP. Both MAC addresses were learned at the exact same time. If all traffic from these hosts stops at the same time, which address will age out first from the FDB based on default settings?

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Question List (91q)
Question 1: What is the maximum number of VLANs supported on a tradition...
Question 2: Which protocol is used to signal the status of the active li...
Question 3: What are the benefits of a hierarchical VPLS architecture? (...
Question 4: Click on the exhibit below. (Exhibit) The SAP on PE-A has be...
Question 5: Click on the exhibit below. (Exhibit) Assume PE-1 has a mesh...
Question 6: What needs to be configured in a VPLS in order to forward cu...
Question 7: What action will be taken when an MPLS router receives a fra...
Question 8: What action will be taken when an Ethernet switch receives a...
Question 9: Click on the exhibit below. (Exhibit) Based on the output be...
Question 10: A LAG is configured with LACP passive mode enabled. When wil...
Question 11: Click on the exhibit below. (Exhibit) A new site is added to...
Question 12: The service-mtu of a VPLS using MPLS encapsulation is set to...
Question 13: The service mtu of a VPLS is set to 9100. What is the recomm...
Question 14: Which element of IEEE 802.1ag is responsible for initiating ...
Question 15: How do user VPLSs become associated with a management VPLS f...
Question 16: After the "disable-learning" command has been executed at th...
Question 17: Click on the exhibit below. (Exhibit) How many LSPs are requ...
Question 18: IEEE 802.3ah frames must be untagged....
Question 19: When deploying Active/Standby pseudowires, the CE does not r...
Question 20: Which of the following statements about a management VPLS ar...
Question 21: What function in IEEE 802.1 ah helps to limit the amount of ...
Question 22: Click on the exhibit below. (Exhibit) CE-A sends frames with...
Question 23: In RSTP, an alternate port is on the same switch as a design...
Question 24: What are the advantages of running a physical ring topology ...
Question 25: In the IEEE 802.1 ag, how are merged services detected?...
Question 26: Click on the exhibit below. (Exhibit) Which SDP on R3 will M...
Question 27: MC-LAG is only supported on network ports....
Question 28: In IEEE 802.1ag, how are loops detected?...
Question 29: (Exhibit) Which of the following features can be enabled to ...
Question 30: Click on the exhibit below. (Exhibit) Study the network diag...
Question 31: Which PDU type is sent periodically over a link in the IEEE ...
Question 32: MAC explosion is best described as a large amount of MAC add...
Question 33: A router has just learned the 10th MAC address while the FDB...
Question 34: Which of the following best describes the difference between...
Question 35: What of the following is a key benefit of Active/Standby pse...
Question 36: Why are provisioning requirements a factor that influence VP...
Question 37: Which failure scenario is NOT supported by IEEE 802.lag?...
Question 38: Click on the exhibit below. (Exhibit) Assume PE-B expects av...
Question 39: Click on the exhibit below. (Exhibit) Based on the following...
Question 40: Which of the following are required for an operational mesh-...
Question 41: Two management VPLSs have been created. mVPLS 1 and mVPLS 2....
Question 42: When a PE node receives a PBB encapsulated frame on a B-VPLS...
Question 43: How does PBB forward broadcast, unknown-unicast and multicas...
Question 44: Which of the following must be true in order to add a port t...
Question 45: How is MAC learning achieved in traditional Ethernet switche...
Question 46: Consider a large metro-to-metro VPLS network interconnected ...
Question 47: The FDB has learned 2 MAC addresses. The first is from a dev...
Question 48: H-VPLS solves the data-plane and control-plane problems with...
Question 49: What is the MTU impact on the SDP path-mtu if fast reroute, ...
Question 50: An l-VPLS can be associated with many B-VPLS services....
Question 51: What is the result of initiating an oam mac-ping to an unkno...
Question 52: Which of the following are true when ports are configured wi...
Question 53: The "discard-unknown" command has been enabled at the VPLS l...
Question 54: Which of the following SAP encapsulations supports only one ...
Question 55: The operation of a VPLS can be best described by which of th...
Question 56: MC-LAG provides link and node protection from an MDU to 3 or...
Question 57: Which of the following needs to be considered when designing...
Question 58: Click on the exhibit below. (Exhibit) A new router named PE-...
Question 59: Click on the exhibit below. (Exhibit) The MDU attached to th...
Question 60: What is the default Spanning Tree protocol used in a VPLS on...
Question 61: Click on the exhibit below. (Exhibit) Assuming there is a fu...
Question 62: Which of the following describes the scope of the IEEE 802.3...
Question 63: Why is MAC explosion a factor to be considered when designin...
Question 64: If a management VPLS is administratively disabled what will ...
Question 65: IEEE 802.3ah is similar to SONET/SDH in that it can count an...
Question 66: What must be enabled in order to prevent a loop within a LAG...
Question 67: What is the MTU impact on the SDP path-mtu if fast reroute f...
Question 68: Click on the exhibit below. (Exhibit) CE-A is on VLAN 200 an...
Question 69: In RSTP, how is the root bridge selected?...
Question 70: If the max remote-age timer of a B-VPLS is reached, what hap...
Question 71: Click on the exhibit below. (Exhibit) Assume there are two V...
Question 72: Click on the exhibit below. (Exhibit) In the diagram below, ...
Question 73: An l-VPLS is configured with a service id of 511. What will ...
Question 74: Click on the exhibit below. (Exhibit) Which port will become...
Question 75: What scaling factors should a network engineer be aware of w...
Question 76: RSTP blocks a spoke-sdp using a management VPLS. Is traffic ...
Question 77: A customer has requested a VPLS service. The customer is usi...
Question 78: An MC-LAG is configured with default parameters. When a fail...
Question 79: Click on the exhibit below. (Exhibit) Which port will become...
Question 80: Which of the following is a true statement?...
Question 81: The following question relates to this command syntax: "conf...
Question 82: What is the default remote-age timer of a B-VPLS?...
Question 83: In Active/Standby pseudowires a failed pseudowire has recove...
Question 84: How does the IEEE 802.1ag loopback function differently from...
Question 85: Click on the exhibit below. (Exhibit) Assume a CE router is ...
Question 86: Click on the exhibit below. (Exhibit) Based on the service-m...
Question 87: Redundant spoke-SDPs are used between 2 Metro networks for r...
Question 88: In IEEE 802.1ag, which two key functions are configured on b...
Question 89: Click on the exhibit below. (Exhibit) Study the diagram show...
Question 90: What is PBB also known as?
Question 91: What is the name of the feature supported on the Alcatel-Luc...