Valid 300-180 Dumps shared by EduDump.com for Helping Passing 300-180 Exam! EduDump.com now offer the newest 300-180 exam dumps, the EduDump.com 300-180 exam questions have been updated and answers have been corrected get the newest EduDump.com 300-180 dumps with Test Engine here:

Access 300-180 Dumps Premium Version
(210 Q&As Dumps, 35%OFF Special Discount Code: freecram)

Online Access Free 300-180 Exam Questions

Exam Code:300-180
Exam Name:Troubleshooting Cisco Data Center Infrastructure
Certification Provider:Cisco
Free Question Number:77
Version:v2018-08-18
Rating:
# of views:1196
# of Questions views:44258
Go To 300-180 Questions

Recent Comments (The most recent comments are at the top.)

AVI - Jan 02, 2019

No.# A and C.
In a single CPU config you can install DIMMs only in slots of a populated socket.

AVI - Jan 02, 2019

No.# I think A is the correct answer since it result in 0 downtime.

AVI - Jan 02, 2019

No.# Correct answer is B.
You cannot form any types of port-channel between 2 fabric interconnects since they are standalone.

mung - Dec 09, 2018

No.# Correct Anser: B (Atomic Counters)
Atomic counters can be configured to monitor endpoint/EPG to endpoint/EPG traffic within a tenant for identifying and isolating traffic loss. Once configured, the packet counters on a configured policy are updated every 30 seconds. Atomic counters are valid when endpoints reside on different leaf nodes.

Harry - Nov 23, 2018

No.# Correct Answers should be: B C

- Check the peer (CNA) to see if it supports DCBX.
- Ensure that the VSAN trunk protocol has been enabled.

From: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/troubleshooting/guide/N5K_Troubleshooting_Guide/n5K_ts_fcoe.html

Harry - Nov 23, 2018

No.# Answer must be A
A passive twinax cable carries a 10 Gig Ethernet signal over short lengths (5m or under, like SFP passive cable) of copper with no additional components to boost signal.

Harry - Nov 23, 2018

No.# I think the 8e-policy is incompatible, since FCoE needs no drop, and 8e is the only one with Drop QOS.

Harry - Nov 23, 2018

No.# This is showing only one endpoint.
The LV behind IP and MAC means Locally vpc attached.
I think C is the right answer

Niko - Oct 10, 2018

No.# Only users belonging to the network-admin role can create roles.
answer is D
https://www.cisco.com/en/US/products/ps5989/products_configuration_guide_chapter09186a00808c0483.html

Niko - Oct 10, 2018

No.# actually seems like all answers are correct because any cost less that 250 should be enough for routing start to work correctly but how to chouse? choose smalles one and be sure that it will defenetely work or choose biggest one for planning that in case of future upgrades maybe??? mostly looks like 60 more reliable

Niko - Oct 09, 2018

This questions are not accurate 4-5 questions was on real exam all questions are new.

LEAVE A REPLY

Your email address will not be published. Required fields are marked *

Other Version
1075 viewsCisco.300-180.v2019-08-20.q97
1019 viewsCisco.300-180.v2019-05-11.q91
879 viewsCisco.300-180.v2019-01-30.q81
1081 viewsCisco.300-180.v2018-06-22.q76
1350 viewsCisco.300-180.v2018-05-15.q70
894 viewsCisco.300-180.v2018-03-26.q73
2541 viewsCisco.300-180.v2018-03-19.q168
2021 viewsCisco.300-180.v2018-02-12.q300
Exam Question List
Question 1: Refer to the exhibit. DC-SWITCH14 is a Cisco Nexus switch. P...
Question 2: Which option is a best practice that should be followed when...
Question 3: View the Exhibit. (Exhibit) Refer to the exhibit. You config...
Question 4: Which two options describes the correct requirements for non...
Question 5: Which occurrence happens during an ISSU in a single supervis...
Question 6: Refer to the exhibit. You discover that eth1/1 stopped forwa...
Question 7: Refer to the exhibit. (Exhibit) SAN-SW-1 has failed and must...
Question 8: Which option is exchanged between neighbors during OTV adjac...
1 commentQuestion 9: Refer to the exhibit. (Exhibit) Your customer reports that a...
Question 10: DRAG DROP Two fabric interconnects fail during a Cisco UCS f...
Question 11: View the Exhibit. (Exhibit) Refer to the exhibit. Which stat...
Question 12: Which two statements are true regarding vPC? (Choose two.)...
1 commentQuestion 13: Refer to the exhibit. A user named user1 cannot create roles...
Question 14: Refer to the exhibit. The VXLAN configuration fails. Which a...
Question 15: When troubleshooting VXLAN, which interface is the source of...
Question 16: What is the default MTU size of a VMware host?...
Question 17: A customer is trying to boot an operating system that is ins...
1 commentQuestion 18: Refer to the exhibit. (Exhibit) You customer reports that th...
Question 19: Which statement is true regarding the admin VDC?...
Question 20: Refer to the exhibit. (Exhibit) Which statement describes th...
1 commentQuestion 21: Refer to the exhibit. Which statement accurately describes t...
Question 22: Which configuration command is critical in order for OTV edg...
Question 23: A customer reports that they are missing vPC peer link redun...
Question 24: After disassociating a service profile from a server, you at...
Question 25: After moving Cisco UCS to a new data center that has a diffe...
Question 26: A customer has two data centers, each containing two Cisco N...
Question 27: You are troubleshooting a Cisco Nexus 1000V Series Switch. W...
1 commentQuestion 28: DRAG DROP Refer to the exhibit. You are configuring a FCoE V...
Question 29: Refer to the exhibit. You connect Cisco Nexus 5600 Series sw...
1 commentQuestion 30: Refer to the exhibit. Which action removes the system design...
Question 31: You use a Cisco UCS VIC 1340 adapter. You discover that the ...
Question 32: Which statement is true regarding LACP configuration?...
1 commentQuestion 33: An engineer enters the show svs neighbors command as shown b...
Question 34: Refer to the exhibit. Which description of the result is tru...
Question 35: Which two protocols are important for DCBX to enable the "no...
1 commentQuestion 36: You install a new DIMM in a Cisco UCS C-Series standalone ra...
1 commentQuestion 37: You discover that OSPF neighbors are stuck in Exstart and Ex...
Question 38: Which command would you use to check the status of your conf...
Question 39: Refer to the exhibit. You fail to configure a boot from iSCS...
Question 40: Which command must you use to identify an active VIF for a p...
Question 41: Which CLI command identifies the service profile that is ass...
1 commentQuestion 42: Refer to the exhibit. (Exhibit) Your customer is migrating t...
Question 43: What task is required before adding traffic sources to a mon...
Question 44: After removing a VMM domain from an EPG, you discover that t...
Question 45: Which command is used to check for potential vPC configurati...
Question 46: You have a Cisco APIC that has a VIC 1225 adapter installed....
Question 47: Which solution can be applied if there is communication betw...
Question 48: Which tool can be used to browse the Cisco APIC Management I...
Question 49: Which two commands will help an administrator identify any i...
Question 50: Refer to the exhibit. After a boot policy is added, the prof...
Question 51: View the Exhibit. (Exhibit) Refer to the exhibit. You are co...
Question 52: A customer is troubleshooting degraded DIMM errors on a Cisc...
Question 53: Refer to the exhibit. Interfaces Ethernet 7/1-8 are members ...
Question 54: What is the default number of dynamic vNICs that is specifie...
Question 55: Which statement about the Nexus atomic rollback feature is t...
Question 56: A customer has a Cisco UCS Central cluster. The customer con...
Question 57: How can you identify the blade location when tracing server ...
Question 58: Refer to the exhibit. (Exhibit) All the interfaces on the sw...
Question 59: Which configuration is needed to suppress duplicate IP addre...
Question 60: You plan to use OSPFv2 on several Cisco Nexus 9000 Series Sw...
Question 61: In an IP storage environment, what occurs if you apply a ser...
Question 62: A customer is configuring an upstream disjoint Layer 2 netwo...
Question 63: Refer to the exhibit. Which two connectivity options for int...
1 commentQuestion 64: Which two conditions can prevent vFC from coming up? (Choose...
Question 65: Refer to the exhibit. (Exhibit) You install a new Cisco Nexu...
Question 66: View the Exhibit. (Exhibit) Refer to exhibit A Cisco UCS adm...
Question 67: At any given time, each server can be associated with how ma...
1 commentQuestion 68: You must identify and isolate traffic loss. Which option do ...
Question 69: A switch is configured with the following command: switch(co...
Question 70: Which two conditions can prevent FCoE from functioning prope...
Question 71: Refer to the exhibit. The two switches are stuck in the EXCH...
Question 72: Refer to the exhibit. Anycast RP fails. Which two actions do...
Question 73: Refer to the exhibit. (Exhibit) You have two fabric intercon...
Question 74: Which identification for EPGs can you use to check zone rule...
Question 75: Which two features are required to configure a blade to boot...
Question 76: Which feature must be enabled before the Data Center Bridgin...
Question 77: Refer to the exhibit. The Cisco Nexus 5000 Series Switches f...